蠕變斷裂 的英文怎麼說
中文拼音 [rúbiànduànliè]
蠕變斷裂
英文
creep fracture-
The experimental study on creep fracture of rock
巖石蠕變斷裂特性的試驗研究First, the basic mechanical capability and creep were proceeded on the material test system with the modified three point bending creep fracture test. the modulus and fracture toughness and tensile strength was attained and creep curve in 200 temperature was also presented. applying basic damage mechanical theory, thermal damage analyses were performed induced in fracture toughness and modulus, the practical formula of damage factors varying with temperature and time was given
首先利用改進的三點彎曲試驗在mts實驗機上進行了巖石力學性能和蠕變測試,得到了花崗巖在溫度影響下的彈性模量和斷裂韌度以及抗拉強度變化規律,並得到了200下北山花崗巖蠕變全過程曲線。Testing methods for creep rupture of adhesive bonds
粘接劑粘合點蠕變斷裂試驗方法The knowledge on the properties of used materials is urgently needed for reasonable life - prediction and life - distribution. as cylinder bolts are concerned, they often rapture at the first tooth - root resulting from lower high temperature strength of their material and higher stress. since bolts operate at high temperature environment, creep skew and damage causing their failure are important factors that can not been neglected
就汽缸螺栓而言,由於螺栓材料的高溫強度偏低,預緊力過大,常常在螺栓的第一齒根部位發生蠕變脆性斷裂,因其長期在高溫環境下工作,蠕變變形和蠕變損傷是其失效的一個不可忽略的重要因素。Method of creep and creep rupture test for metallic materials
金屬材料蠕變和蠕變斷裂試驗方法Geotextiles and geotextile - related products - determination of the tensile creep and creep rupture behaviour
拉伸蠕變和拉伸蠕變斷裂性能的測定08. 02 test methods for tensile, compressive, and flexural creep and creep - rupture of plastics
塑料的張力壓力和柔性蠕變以及蠕變斷裂試驗方法Standard test methods for tensile, compressive, and flexural creep and creep - rupture of plastics
塑料的拉伸壓縮彎曲蠕變及蠕變斷裂的標準試驗方法Geotextiles and geotextiles - related products - determination of tensile creep and creep rupture behaviour
土工布及相關產品.拉伸蠕變和蠕變斷裂性能的測定Standard test methods for conducting creep, creep - rupture, and stress - rupture tests of metallic materials
金屬材料傳導蠕變蠕變斷裂和應力斷裂的標準試驗方法Standard test method for conducting time - to - failure creep - rupture tests of joints fabricated from nonbituminous organic roof membrane material
非瀝青質有機屋面薄膜材料接縫的蠕變斷裂時間標準試驗方法The influence factors of fracture life are composites boards lay structure, wood - lacuna, and bamboo structure
影響疲勞蠕變斷裂壽命分散性的因素主要有層合板的鋪設結構、木材缺陷和竹材結構等的影響。( 7 ) basing on defining damage variable with flaws in rock, this paper uses linear viscoelasticity fracture mechanics to set up a damage reep model and analyses the model
( 7 )在用巖石中大小、方位和位置均為隨機分佈的裂紋定義損傷變量基礎上,利用線粘彈性斷裂力學原理對考慮裂紋內水壓的巖石的損傷蠕變問題進行了建模和分析。The presence of small amount of liquid at grain boundaries tends to form thin viscous layer which surrounds the finer grains. intergranular fracture may occur at the grain boundaries between two fine grains not covered by viscous phases. the high ductility achieved at low strain rates is generally attributed to dislocation glide - creep accommodation mechanisms
原始晶界上產生少量液相,形成薄的固液共存粘性層並包圍細化的晶粒,沿晶斷裂主要發生在無粘性層的細晶粒間;而在較低應變速率下,三叉晶界位錯攀援?蠕變協調機制鬆弛晶界滑移產生的應力集中,晶界上產生較多液相,有利於晶界滑移進行。Facture damage behavior of wood - bamboo composites board under the mutual action of fatigue and creep was studied
摘要研究了在疲勞蠕變交互作用下竹木復合層合板的斷裂損傷行為。Results showed that the curves of fatigue / creep have three stages at the 75 % stress and the curves of fatigue / creep have two stages at the 55 % stress
結果表明,在交變載荷最大值為75 %的應力水平下,其疲勞蠕變斷裂曲線為3段式曲線;在55 %的應力水平下, 15小時內其疲勞蠕變曲線為兩段式曲線。Standard test method for elevated temperature tensile creep strain, creep strain rate, and creep time - to - failure for advanced monolithic ceramics
高級單片陶瓷的高溫抗拉蠕變應變,蠕變應變率及蠕變斷裂時間的標準試驗方法Geotextiles and geotextile - related products - determination of tensile creep and creep rupture behaviour iso 13431 : 1999 ; german version en iso 13431 : 1999
土工織物與土工織物相關產品.拉伸蠕變與蠕變斷裂性能Specification for test pieces and test methods for metallic materials - tensile tests - uninterrupted creep and rupture tests - metric units
金屬材料試樣和試驗方法規范.第1部分:拉伸試驗.第3節:不間斷蠕變試驗和蠕變斷裂試驗.米制單位Standard test method for accelerated tensile creep and creep - rupture of geosynthetic materials based on time - temperature superposition using the stepped isothermal method
使用階段等溫法對基於時間-溫度疊加的土工合成材料的加速拉伸蠕變和蠕變斷裂的標準試驗方法分享友人