行驅動器 的英文怎麼說

中文拼音 [hángdòng]
行驅動器 英文
line driver
  • : 行Ⅰ名詞1 (行列) line; row 2 (排行) seniority among brothers and sisters:你行幾? 我行三。where...
  • : 動詞1. (趕) drive (a horse, car, etc. ) 2. (快跑) run quickly 3. (趕走) expel; disperse
  • : 名詞1. (器具) implement; utensil; ware 2. (器官) organ 3. (度量; 才能) capacity; talent 4. (姓氏) a surname
  • 驅動器 : actuator
  • 驅動 : [機械工程] drive; prime mover
  1. Defragment your hard drive after installing the product

    安裝本產品后,對硬盤碎片整理。
  2. After reviewing the history and recent developments of the research on thermoacoustics, and introducing the classical thermoacoustic theory, we carry out the following investigations : 1 ) thermoacoustically driven pulse tube refrigerator ( tadptr ) experiments have been done on the self - built pulse tube refrigerator driven by standing wave thermoacoustic prime mover system

    本文首先回顧了熱聲機械的歷史及現狀,詳細介紹了熱聲學理論基礎,重點研究了以下若干問題: 1駐波型熱聲脈管製冷機在自搭建的駐波型熱聲脈管製冷機實驗裝置上進了實驗研究。
  3. Some simulations with deltae has also been made to predict the performance of the system. at the end of this section, proposals and schemes are also given for the further experiments. 4 ) thermoacoustically driven puke tube refrigerator ( tadptr ) with the successful operation of the standing wave thermoacoustic prime mover, we transferred part of our efforts to the thermoacoustically driven pulse tube refrigeration, which is actually the original aim for our study on the thermoacoustic prime mover

    熱聲脈管製冷機在成功研製熱聲的基礎上,對其與脈管製冷機(一種在低溫端沒有運部件的新型的低浙江大學博士學位論文金滔:熱聲及其的脈管製冷研究2001年5月溫製冷機)的聯接進了匹配分析,並搭建了熱聲脈管製冷機的實驗臺,進了系統的實驗研究。
  4. In mss, the unit of space that is allocated on a staging drive

    海量存儲系統( mss )中,在分級上進分配的存儲空間單位。
  5. Because no drive software is needed in using chip 21154, this paper don ’ t refer to the drive design. after configuring the register in initialization rightly, the work about design of add - in card are all done

    因為橋晶元不需要軟體,因此不需要進程序的設計,只需要在初始化的時候對配置寄存正確的配置即可,這些工作在最後一部分完成。
  6. Disable the autorun feature on all pcs with cd - rom drives

    禁用所有pc的cd - rom功能
  7. An experimental setup has been designed and built up through a collaboration program between cryogenics laboratory in zhejiang university and limsi - cnrs ( france ). the system employs the inherently reversible stirling cycle, and then its thermodynamic efficiency can easily surpass that of standing - wave system and is even comparable to that of the traditional internal combustion engines

    在充分理解工作機理的基礎上,與法國國家科研中心limsi實驗室合作,設計並建成一臺波型熱聲實驗裝置,進了初步實驗,以氨氣和氮氣為工質,成功地獲得了頻率分別為66hz和23hz的熱聲振蕩。
  8. Worse, it only ran on a machine with an actual floppy on a traditional isa floppy controller my windows desktop machine had an ls - 120 drive. emulation to the rescue

    更糟糕的是,運它的機必須在傳統的isa軟盤控制上安裝實際的軟盤(我的windows桌面機有一個ls - 120) 。
  9. As novel concept actuators, ultrasonic motors have been attracting intensive attention at home and abroad with their outstanding features such as low speed and high torque, large holding torque, rapid response, light weight and compact sizes, simple structure, and no magnetic disturbance, etc. traveling wave ultrasonic motors are especially attracting researchers ’ interest for their good controllability and flexible constructions

    超聲波馬達作為一種全新的,以低速大轉矩、靜態保持力矩大、響應速度快、體積重量小、結構簡單以及無磁場干擾等優點受到國內外的廣泛關注,其中波超聲波馬達以其控制性能良好和結構靈活等優點尤為引人矚目。
  10. Developerworks, july 2004, martyn honeyford suggests that your own linux distribution on a portable drive offers the same portability - but greater flexibility - than a livecd. find more resources for linux developers in the

    ( developerworks , 2004年7月)中, martyn honeyford指出,您自己的可移上的linux發版本可以提供與livecd相同的輕便性而且更為靈活。
  11. Routine to search inappropriate words in files and drives

    搜查不合適的話,在文件和
  12. Taking the vr step motor as example in the paper, systemic research is conducted about the principle of the subdividing drive, the non - linearity relationship between microstep and phase current, the method of velocity adjusting and the interrelated factors. the system is designed to realize the subdividing drive, velocity adjusting and position. especially, there are two innovations in this paper. one is the first introduction of pld device and isp technology to the design of phase sequencer, the other is the new measure and amend method of microstep

    本文以三相反應式步進電機為實例,對細分原理、細分的非線性、變細分調速以及相關影響因素進系統的研究;實現細分、調速控制、定位控制和軟硬介面的設計。在此基礎上,本文對細分環形分配的設計和微步距測量修正進了創新;提出將pld件和isp技術引入到細分環形分配的設計思想和錯位測量和逼近修正法。
  13. In order to exert the speed performance of gaas mid frequency switch and improve the agility to be compatible with ttl control electric level of most present system, we studied the gaas mid frequency switch with ttl driver

    為了充分發揮gaas開關的速度性能,提高gaas微波開關的使用靈活性,以及與目前多數系統中的開關ttl控制電平相兼容,我們對ttl電平的gaas中頻開關進研究。
  14. A mathematic model of the motor is builded and emulated through matlab. the low - speed and constant - torque, high - speed and constant - power state is analyzed and researched, also the software approach of simulation to the driver has been done, a digital signal processor tms320lf2407 is developed successfully to control the perm square - wave bldcm driving airscrew of solar powered unmanned engine. it is useful to the further study

    在matlab下建立了電機的數學模型,通過計算機模擬,驗證了數學模型的正確性,同時在理論上對低速恆轉矩高速恆功率運了分析與研究,提出了一種用模糊控制的方法實現恆功率控制,並對了系統模擬,成功的研製了以數字信號處理控制tms320lf2407為控制核心的,控制無刷直流電太陽能無人飛機的螺旋槳,為後面繼續研究工作提供了參考。
  15. In large computer systems, staff involved in loading disks on disk drives, removing printouts from line printers etc

    在大型計算機系統中,負責把磁盤裝入磁盤,從式印表機中取走列印結果等日常操作的人員。
  16. Running all ferrule fans, signal conrertor fans, hardpand ? driving fans, top cabinet, door ? fans, and checking whether they are normal or not

    將各嵌套扇、信號變換風扇、硬盤風扇、櫃頂、門風扇等電源接通,檢查各風扇,應運正常。
  17. There is difference frequency measurement requirement for every part of pid regulating, difference between dynamic quality and static quality in response time and accuracy. according to these, it use the interrupt functions and high - speed counter of the simens s7 - 200 plc cpu226 basic unit and some peripheral circuit to measure frequency ; in software designed, the procedure frame of hydraulic - turbine governor and disperse process of parallel pid are analyzed, an improved pid algorithm is adopted to realize a pid regulation mode with variable structure and parameters ; the mechanical liquid - pressure system of the hydraulic - turbine governor is with electric - hydraulic converter unit of step motor. according to the drive character of five phase of response step motor, a variable frequency regulated voltage driver unit is designed in order to realize interface between plc and driver of step motor

    本文利用s7 - 200plc自身的特點設計了頻率測量單元,根據pid調節各個環節的特點,以及調速態特性、靜態特性對頻率測量的實時性和精度要求的不同,利用s7 - 200plc基本單元中內置的高速計數以及相應的外圍放大整形、分頻電路,實現了水輪發電機組頻率的測量;在軟體上,對微機調速的整個程序框架、並聯pid的離散化過程進了分析,選用改進的pid演算法實現了變參數、變結構的pid調節模式;調速的機械液壓隨系統具有步進電機電液轉換元件,採用五相反應式步進電機,根據其特性設計了變頻調壓,實現plc與步進電機之間數字介面。
  18. After a detailed review on the historical developments of the research on thermoacoustics, as well as the latest advances in this field, prospective applications, and a survey of theoretical fundamentals, the present work focuses on the following sections : 1 ) standing wave thermoacoustic prime mover an experimental setup of standing wave thermoacoustic prime mover has been built up with brass matrix as the thermoacoustic stack

    本文首先回顧了熱聲熱機的發展歷史及最新成就,在詳細介紹熱聲學理論基礎以及熱聲機械設計原則之後,重點研究了以下若干問題: 1駐波型熱聲建立了我國第一臺實用駐波型熱聲試驗臺,並進了實驗研究。
  19. Are not plagued by buffer underruns as older drives are

    )不會有老式那樣的緩沖區欠載運煩惱。
  20. This article presents a sort of economical and opening line - cutting cnc system based on pc , realizing method and key technology, develops step motor axis card and blending step motor driver based on l297 / l298 chip

    本文提出了一種適用於線切割機床的經濟型開放式數控系統結構及實現方法,進了相關關鍵技術研究,並開發出了基於isa總線的步進電機軸卡以及基於l297 / 298晶元的混合式步進電機
分享友人