衡算計量程序 的英文怎麼說

中文拼音 [héngsuànjìliángchéngxù]
衡算計量程序 英文
accounting procedure
  • 衡 : Ⅰ名詞1 （秤桿） the graduated arm of a steelyard2 （稱重量的器具） weighing apparatus3 （姓氏） a...
  • 算 : Ⅰ動詞1 （計算數目） calculate; reckon; compute; figure 2 （計算進去） include; count 3 （謀劃;計...
  • 計 : Ⅰ動詞1 （計算） count; compute; calculate; number 2 （設想; 打算） plan; plot Ⅱ名詞1 （測量或計算...
  • 量 : 量動1. （度量） measure 2. （估量） estimate; size up
  • 程 : 名詞1 （規章; 法式） rule; regulation 2 （進度; 程序） order; procedure 3 （路途; 一段路） journe...
  • 計量 : calculate; estimate; meterage; metering; batching; measure
  • 程序 : 1 （進行次序） order; procedure; course; sequence; schedule; ground rule; routing process 2 [自動...
  1. And the deficiencies are pointed out in present researches, such as highway capacity, level - of - service, influence factor of road alignments, etc. from these, it has confirmed that the thesis should be studied from rational analysis, quantitative analysis of level - of - service, impact on capacity of road alignments, setting - up simulation model, etc. the high - accuracy gps dynamic data acquisition appearance is proposed to be used for the first time to carry on the experiment of overtaking on two - lane highways, and experiment scheme is designed according to the driver ' s perceive to judge each overtaking course. based on the experiment data, it can get two important parameters of acceptant gap ? the critical gap of overtakable time headway and returnable time headway through data processing, which can offer the strong support to the research of two - lane highway capacity with qualitative and quantitative analysis. besides, the experiment methods is provided to observe overtaking ratio and to measure the

    研究中首次提出了運用高精度gps動態數據採集儀對雙車道公路上的超車行為進行觀測，設計了根據駕駛員感受度來衡量超車過程的實驗方案，並通過後期數據處理得到了超車過程中兩個重要的可接受間隙參數-可超車車頭時距和可回車車頭時距的臨界間隙值，為定性和定量分析雙車道公路通行能力提供有力的數據支持;同時，還提出了觀測超車率的實驗方法以及測量加速度干擾的實驗方案，統一了計算加速度干擾的時間統計間隔，為雙車道公路的服務水平量化研究奠定基礎;最後還簡單介紹了駕駛員問卷調查法和模擬程序中模型參數標定和驗證的數據採集方法。
  2. Monitor apparatus can measure valid value of three phase voltage and current, power factor, three phase disequilibrium, instant flecker of short time and harmonic without twenty, degree and harmonic distortion total. the paper are laid on the following. ( 1 ) master plan and function of circuit, ( 2 ) hardware design including circuit and principle of a / d conversion, phase lock, liquid crystal display and keystroke and so on, ( 3 ) design of system software including digital filtering, fft, a / d conversion and monitor interface of pc, ( 4 ) system test

    監測儀能夠完成包括三相電壓、三相電流的有效值、功率因數、三相不平衡、電壓短期閃變、以及20次內的諧波、諧波相位、諧波失真總量等的測量。論文重點介紹了以下幾部分： （ 1 ）電路的總體設計和功能； （ 2 ）硬體設計，包括a d轉換、鎖相環、液晶顯示和按鍵輸入等原理和電路。 （ 3 ）系統軟體設計，包括a d轉換、 fft 、數字濾波等程序的原理和演算法以及上位機監控界面的設計； （ 4 ）系統測試。
  3. I have taken impotance to analyze the rallying point of famous product, concrete cost and capability of providing and guarantee in this artical, meanwhile, i have caculated the quantity of concrete needed for the year and got the regression equation with the historic data for drilling footage of eight years and the consuming quantity of oilwell cement by the method of linear regression, and it has very significance for the making of stock contract and the plan of concrete production, i have analyzed the physical distribution of oilwell cement by the transpotation flex and the advantage or disadvantage between direct distribution and distribution to store in this artical, and i have tried to find the balance point of the two distribution ways by the ecnomic analysis and pointd out the conception of economic semidiameter, and come to the conclusion of direct distribution, distribution to store, and subarea of distribution to store at last

    本文對油井水泥供應商在品牌號召力、水泥成本、供應保障能力等方面進行了詳盡分析，並對供應商進行了能力排序;用線性回歸方法從八年鉆井進尺與油井水泥消耗量的歷史數據推算了當年度油井水泥需求量，得出了回歸方程，這對于油井水泥采購合同的制訂、水泥供應商生產計劃的制訂具有相當重要的意義;從運輸彈性分析出發對油井水泥物流配送進行了研究，對直達配送、入庫配送的優缺點進行了詳細的分析，在經濟分析的基礎上力求找到兩種配送方式的均衡點，並提出了經濟半徑的概念，得出了直達配送、入庫配送、入庫分區距離等幾項結論。
  4. A parallel computing software is established independently. this software is a cell - centered finite - volume, structured grid, multi - block code which solves the equations governing inviscid and viscous flow of a calorically perfect gas or of an arbitrary mixture of thermally perfect gas undergoing non - equilibrium chemical reactions

    通過簡單的參數控制，該程序既可計算二維、軸又巾彌和三維量熱完全氣體，也可計算化判卜平衡流;既可計算無粘流，也可計算粘性流。
  5. Fist ly, use mass equivalent method to predigest the original rotor system. secondly, use transfer matrix arithmetic to have finished the relative program to calculate the critical speed of flexible multi - tray rotor bearing system by matlab language. thirdly. finish program the unbalance response using riccati - transfer matrix arithmetic and finity buck arithmetic. fourthly, answer to the high vibration of uncontroled system when cross the critical speed, come out to adopt changing clearance damper bearing to control the viberation

    本文對多柔盤轉子-支承系統的振動現象做了以下初步探索：用質量離散化方法把原轉子系統簡化；採用matlab語言編制了對傳遞矩陣法計算多柔盤轉子-支承系統的臨界轉速；用matlab語言對riccati傳遞矩陣法和有限元法編制了程序計算系統的不平衡響應；並針對其過臨界轉速時振動較大的現象，提出採用變間隙控制油膜剛度和阻尼，從而使原系統的在特定轉速（臨界轉速）的一段范圍內不平衡響應減小；並從被動控制與主動控制兩方面進行數值模擬，取的了較好的控制效果。
  6. According to the geological data which was gained by exploration investigation, establishing a geological model which can reflect rock mass characteristics ; with analyzing the internal and exterior factors synthetically, the deformation and possible failure mechanism and mode of the cut slopes was confirmed which combines with stereoic projection and other techniques ; the stabilities of the 14 high slopes are estimated synthetically by applicable design codes and guidelines. with the estimate result and some other analysis methods, the rock mass mechanical parameters of slope are identified ; as a results, 14 high slopes fall into 4 categories based on rockmass characteristics and discontinuities. the stability and deformation of some typical slopes was analyzed with distinct element method by udec ; the safety factor of some dangerous slopes are calculated by rigid limiting equilibrium method for comparison

    首先著重研究影響邊坡穩定性的內在因素，主要是通過地質勘探、測量、現場觀測等手段取得研究區地質體的基礎地質資料，建立起能夠反映地質體結構特徵的地質模型;隨后綜合分析潛在的內外部影響因素，並結合赤平投影對邊坡可能的失穩模式或破壞機製作出判斷;運用已有巖體質量分類方法對沿線14個高陡邊坡穩定性進行初步的評價，並結合試驗研究、經驗判斷、工程類比等手段確定了坡體的巖體力學參數;根據穩定性初步評價結果將研究區14個高陡邊坡按開挖方式分為4大類，並利用離散元程序udec對各類典型高陡邊坡進行了穩定性計算分析;對潛在危險邊坡利用剛體極限平衡法求出了不同工況下的安全系數。
  7. This paper was detailed to introduce the measurement of main exhaust composition from marine diesel engine. at the same time, this paper discusses the computational method to get exhaust mass flow rate by carbon balance method and carbon / oxygen balance method

    本文詳細介紹了船用柴油機排氣中各主要成分的測量方法，同時討論了用碳平衡和碳氧平衡法計算排氣質量流量的過程並編寫了相關的計算程序。
  8. The calculations introduced in this paper can also be used to estimate the values of energy consumption in each working procedure, and to provide the corresponding parameters for production line design and the thermal load parameters for making the right selection of equipment types

    通過衡算可估算在生產過程中各工序的熱量消耗指標，也可為生產線的設備設計提供設計參數，以及為化工設備的選型提供熱負荷參數。
  9. Standard guide for establishing security seal control and accountability procedures

    制定安全密封控制和衡算計量程序的標準指南
  10. Ameliorate the algorithms. in order that our program can work as a software for design of gain equalizer, adaptability and less amount of computing are necessary. algorithm of solve nonlinear equation was ameliorate to decrease the amount of computing

    鑒于本文計算程序的最終目標是生成增益均衡器輔助設計軟體（給出所需耦合器的增益譜的譜形及其參數） ，因此，在計算耦合器的參數時，程序的自適應性和計算量方面具有更高的要求。
  11. Several transient simulation programs have been developed based on the models above, and were put into practice of the transient simulations of following : ( 1 ) autoregulation on water height of the fore bay in single pump station, and the influence of governor parameters ; ( 2 ) autoregulation on output of adjustable - blade pump in single pump station, and the influence of governor parameters ; ( 3 ) on - line autoregulation on flow equation of multilevel pump stations system

    本文應用上述方法編制了過渡過程模擬程序， （ 1 ）進行了單級泵站中轉槳泵在線自動調節泵站前池水位的動態模擬計算，並對調節參數的影響做了比較研究； （ 2 ）進行了單級泵站中轉槳泵在線自動調節泵輸出流量的動態模擬計算，並對調節參數的影響做了比較研究； （ 3 ）進行了多級泵站中轉槳泵在線自動調節輸水系統流量平衡的動態模擬計算。
  12. As an example of 3d program with high quality mesh, proper boundary & initial conditions and ingenious simulation strategy, numerical analysis of flow - fields in hylte nozzle and cavity of dfcl running on fuel system of ( nf3 + h2 + he ) / d2 and experimental stagnation parameters, has been performed using vibration - state - unbalance & rotation - state - balance model, and a detailed kinetic model including 111 one - way primary reactions expressing by finite rate equations between thirteen species. the coefficients of transportation used in the analysis are calculated by employing the formulas of molecular kinetics

    新建立的三維程序在高質量網格、合理的初邊值以及模擬方案基礎上，採用振動非平衡?轉動平衡模型和有限速率方程表達的111個單向基元反應的化學動力學模型，利用分子運動理論計算的輸運系數和工程實驗採用的滯止參數，對運轉（ nf _ 3 + h _ 2 + he ） d _ 2燃料體系的df激光器的hylte噴管和光腔進行了數值模擬分析。
  13. Microsoft windows system monitor allows you to use graphs, charts, and reports to gauge the efficiency of your computer, and identify and troubleshoot possible problems such as unbalanced resource use, insufficient hardware, or poor program design, and plan for additional hardware needs

    Microsoft windows系統監視器允許您使用圖形、圖表和報告來測量計算機的效率，確定並解決可能的問題（如資源使用不平衡、硬體不足或程序設計有問題等） ，並針對其他硬體需求制定計劃。
分享友人
分享到 Line

分享到臉書