表聲測驗 的英文怎麼說

中文拼音 [biǎoshēngcèyàn]
表聲測驗 英文
watch test
  • 表 : Ⅰ名詞1 （外面;外表） outside; surface; external 2 （中表親戚） the relationship between the child...
  • 測 : 動詞1. （測量） survey; fathom; measure 2. （測度; 推測） conjecture; infer
  • 驗 : 動詞1. （察看; 查考） examine; check; test 2. （產生預期的效果） prove effective; produce the expected result
  • 測驗 : test; trial run; examination; testing
  1. To sum up, tested and validated by data sets of shenzhou iv unmanned spacecraft and precise orbit ephemeris, the algorithms presented in the thesis can improve orbit accuracy and reduce random noise considerablely. derived conclusions have important value for reference, and lay the firm technological foundation for future applications

    總之，經過神舟四號飛船實測數據計算和精密星歷檢驗，表明本文提出的各種定軌方法可以較好的提高定軌精度，減少隨機噪聲，所得出的結論對于實際應用具有重要的參考價值，並為將來的應用奠定了堅實的技術基礎。
  2. Surface transverse wave has the 1. 6 high frequency than rayleigh type surface acoustic wave ( using the same technology the frequency of devices of stw has about 1. 6 high frequency than rayleigh type surface acoustic wave ). the paper introduces the theory, design parament, technology and result expeiment of surface acoustic wave ( includes rayleigh surface acoustic wave and surface transverse wave, simple stw ) with low insertion loss, high q and researches the high frequency, low phase noise oscillator with 1ghz stw resonator as frequency element. and describes measurement method and finally experimantal result of the low phase noise surface acoustic wave oscillator

    本文研究了以低損耗、高q值聲表面波（其中包括聲表面瑞利波- - rayleighsurfaceacousticwave ，和聲表面橫波等）諧振器的工作原理、設計參數、製作工藝及其實驗結果，並且研究了以1ghzstw諧振器為頻控元件的高頻率、低相位噪聲聲表面波振蕩器，以及低相位噪聲聲表面波振蕩器的測試方法和最終的測試結果。
  3. The point blast induced spherical wave is the especial instance of the ellipsoid shock wave. at last, the experimental data in alcohol are in good agreement with the calculated results of the model by analysis of the data of the laser pulse induced the laser plasma shock front by acoustics means

    最後，設計應用聲學方法對酒精中產生的激光等離子體沖擊波波前傳播過程進行測試，對兩個不同方向上激光等離子體沖擊波波前測試數據的分析表明，旋轉橢球面的沖擊波模型與實驗測量結果相吻合。
  4. The experimental data are in good agreement with the calculated results of the model by analysis of the data of the laser pulse of different energy induced the laser plasma shock front by acoustics means. in addition, the calculated results of the model are in good agreement with the experimental data by optics means

    同時設計應用聲學方法對水中不同能量的脈沖激光作用下產生的激光等離子體沖擊波波前傳播過程進行測試及數據分析，對光學陰影方法探測的激光等離子體沖擊波近場波前傳播數據進行詳細分析，結果表明新模型計算結果與實驗測量值一致。
  5. Experimental results in different noises and snr indicated that this vad algorithm can divide speech segments from non - speech segments accurately and reduce voiced - unvoiced error obviously. ( 2 ) an improved dct - hn speech decomposition algorithm based on the harmonic - noise model is presented

    不同噪聲、信噪比下的實驗結果表明，該演算法可以準確區分語音段與非語音段，明顯降低了基音檢測中清濁誤判現象的發生; （ 2 ）基於「諧波-噪聲」模型提出了一種改進的dct - hn語音分解演算法。
  6. A minitype wireless noise measure system is designed to act as an automonitor, which has been proved to be a practical device

    試驗結果表明，該系統可以有效獲得飛機的噪聲數據，測試結果與模擬結果比較吻合。
  7. By the result of these experiments, acoustic emission ( ae ) was chosen to use in the research. at the same time, we analyse the phenomenon of acoustic emission at the base of theory, the characteristic signal of acoustic emission which comes from the faulty bearing at the angle of application, and the expression of the characteristic signal. contrast was also made on the data achieved separately from vibrational signal and ae signal, and it is proved that ae is feasible and available to the diagnosis to the fault of the rolling bearing

    主要工作有如下幾方面：對本段前期實驗室階段採用的振動法幅值域無量綱處理進行了分析，並研製了現場所使用的滾動軸承故障檢測裝置，將無量綱參數診斷法應用於段修現場，且做了大量試驗；對于現場試驗中所出現的問題進行了分析，提出將聲發射的方法用於軸承的在線故障診斷；從理論上分析了聲發射現象，從應用的角度分析故障軸承的聲發射信號的特徵以及聲發射信號特徵的表示方法，並在實驗室中，採用振動法和聲發射法實時檢測的實驗數據進行了對比和分析，證明了使用聲發射法對軸承故障檢測的可行性和有效性。
  8. The developing ratio of its long - term fc is up to 25 %. and the ultrasonic velocity was inspected out by way of ultrasonic - concrete technique : the maximum value was 5376m / s ; the minimum was 4386m / s. this explained that hpc in the experiments was very close - grained

    採用超聲波混凝土檢測技術測得試件28d的最大波速值為5376m s ；試件最小波速也達到了4386m s ，這表明本試驗所獲得的混凝土試件的密實程度是相當高的。
  9. It implies that gene expression in plant cells might have changed under the stimulation of sound wave. thirdly, the cell cycle of protoplast of control group and stimulated group ( stimulating for 9 days ) was estimated by flow cytometer. the results showed that the number of cells of stimulated group decreased in g0 / g1 phase and increased in s phase

    圍繞中心法則分別測定了dna 、 rna和可溶蛋白質的含量，發現聲波刺激組的dna含量變化不明顯，而rna和可溶蛋白質的含量都有所升高，且以刺激9天的實驗組最為突出，表明在強聲波的作用下，有關應力響應的轉錄因子被啟動，轉錄水平提高，從而翻譯合成較多的蛋白質，促進植物的生長發育。
  10. At the same time, the intrapartical diffusion and liquid internal mass transfer can been enhanced by ultrasound field, owing to additional stirring, the increasing rate of intraparticle diffusion coefficient is enhanced, while that of the liquid film mass transfer coefficient is reduced under ultrasound field

    模型研究表明： freundlich ?兩相阻力模型計算得到濃度與實驗測定值非常吻合，超聲場能有效地強化浸取粒內擴散與液膜傳質，攪拌作用下超聲強化液膜擴散的的能力降低，強化粒內擴散的能力增強。
  11. On the basis of the theory of fractal geometry, the fractal dimension characters of ae signal at different tool wear states were analyzed, an algorithm was provided to decide the scale range which is necessary to calculate the dimension of non - fully - fractal form. the experiments showed that the fractal dimension of ae signal is slightly effected by the changes of cutting parameters ; the variance of the fractal dimensions, which reflects the geometric characters of ae signals, has the same tendency as that of the flank wear, the monitoring system, which takes the fractal dimension of the ae signal as the feature, can identify the different tool wear states more correctly under different cutting conditions

    以分形幾何理論為基礎，對刀具不同磨損階段聲發射信號的分形特徵進行分析.提出了計算非完全分形體信號波形的關聯維數時尺度范圍的確定方法，分析了聲發射信號在刀具磨損過程中分形維數的變化特性.刀具磨損切削實驗數據表明，聲發射信號的分形維數受切削參數變化影響較小；分形維數反映了聲發射信號的幾何特徵，其大小能較好地反映刀具的不同磨損狀態.實驗結果表明，該方法能正確地實時在線監測刀具的不同磨損狀態
  12. 6. the laboratory immersion testing has been shown that the sensor carrier for single sensor rataing reflactor is available for in - line inspection of small - diameter pipelines at the proper sampling frequcy and system amplititude

    小管道液浸超聲檢測室內試驗表明，在適當的采樣率和系統增益的情況下，單探頭反射鏡式檢測頭完全可用於小管道的超聲智能檢測。
  13. The input impedance of the interdigital saw transducer is measured by the equivalent circuit method. the experimental results show that the synchronized frequency of 9. 586 mhz, the acoustic radiation resistance of 44. 6 and the static electrode capacity of 194pf all agree with those design values

    用自行設計的等效電路測量方案，測量了表面彈性波馬達換能器的輸入阻抗，實驗結果顯示表面彈性波換能器的共振頻率為9 . 586mhz ，輻射聲電阻為44 . 6 ，叉指電極靜電容為194pf 。
  14. The experimental results and attack analysis show that the watermark algorithm is transparent and robust against some image processing operations, such as jpeg lossy compression, median filtering, additive noise, scaling, and incorporating attacks

    實驗結論和攻擊測試表明，本文所提議的演算法具有較好的透明性，對如jpeg有損壓縮、中值濾波、附加噪聲、伸縮、裁剪等各種圖像處理的攻擊有較強的頑健性。
  15. As one of the most potential experimental stress measurement, ultrasonic technique was widely developed and applied in recent years. limited by their own characters, bulk wave and surface wave in ultrasonic frequency are difficult to be used to measure the internal tangent stress condition from the surface of medium. in many occasions, they will not be able to evaluate the working condition of mechanical components effectively

    超聲波技術作為最有潛力的實驗應力測量技術之一，近年來得到了廣泛的發展和應用，然而超聲體波與表面波由於其自身的限制性，均無法從表面測量內部的切向應力狀況，在許多場合下無法有效進行機械構件工作狀態的評估。
  16. After briefly describing the damage mechanism of electromigration, noises theories and signal processing methods, many kinds of experimental assessing methods of electromigration, such as the traditional mtf test, the test of changes of resistance and noise measurement, etc., are reviewed in this paper, and its research on the technology of noises detection has been studied emphatically

    本論文在簡要介紹電遷移失效機理、噪聲理論和1 / f信號表徵方法的基礎上，對各種電遷移可靠性實驗評估方法（傳統的壽命測試法、電阻變化測量法、噪聲測量法）的特點作了分析對比。重點研究了vlsi金屬互連電遷移噪聲檢測技術。
  17. Based on the basic principle of tyre pattern noise controlling, measurement approach of tyre noise, frequently used charts and simulation model are introduced, some computation formulas are derived and testified. emphasis is placed on the studying of tyre pattern noise controlling from the following aspects : noise reduction optimization theory, intelligent optimization approaches and comprehensive noise intelligent diagnosis, etc. two main approaches to measure tyre noise is introduced, indoor drum - rolling measurement and outdoor yard measurement

    本課題從輪胎花紋噪聲控制的基本理論出發，對輪胎噪聲測試方法、常用圖表和模擬模型進行了闡述；用實測數據對部分分析計算公式進行了推導和驗證；還著重從輪胎花紋噪聲降噪優化理論、智能優化方法、噪聲綜合智能診斷等方面，對輪胎花紋噪聲控制進行了系統的研究。
  18. ( 3 ) the effects of the random noise on the measured results, which are based on brightness temperature approach method and continuous measurement method, are evaluated. the experiment results demonstrate that the effect on brightness temperature approach method is uncertain and continuous measurement method can bear certain random noise

    在某一溫度點下的各通道理論測量值加入一定的隨機噪聲，試驗結果表明:亮溫逼近法受隨機噪聲的影響是不確定的，而連續測量法可以承受一定的隨機噪聲影響。
  19. White male students ' performance was similarly depressed when they took a math test in which asian - americans were said to do better

    在一項聲稱亞裔美籍學生表現會比較好的數學測驗中，白人男學生的表現亦不佳。
  20. Non - destructivetesting - ultrasonic inspection - characterization of search unit and sound field

    無損檢測超聲檢驗探頭及其聲場的表徵
分享友人
分享到 Line

分享到臉書