表面測試 的英文怎麼說

中文拼音 [biǎomiàncèshì]
表面測試 英文
suface test
  • 表 : Ⅰ名詞1 （外面;外表） outside; surface; external 2 （中表親戚） the relationship between the child...
  • 面 : Ⅰ名詞1 （頭的前部; 臉） face 2 （物體的表面） surface; top 3 （外露的一層或正面） outside; the ri...
  • 測 : 動詞1. （測量） survey; fathom; measure 2. （測度; 推測） conjecture; infer
  • 試 : 名詞（古代占卜用的器具） astrolabe
  • 表面 : surface; superficies; boundary; face; rind; sheet; skin; outside; appearance
  • 測試 : test; testing; checkout; measurement
  1. Test method for ga as ratio of surface of gallium arsenide

    砷化鎵表面鎵砷比的測試方法
  2. But the products are developed in our country have not used in clinic successfully. many elements restrict the exploitation of vascular prostheses in our country. one of the astriction maybe is the lack of a research on the biomechanical performance for vascular prostheses and the reasonable test methods

    我國研究的各種產品尚不能達到滿意的臨床效果，限制我國人造血管開發的因素是多方面的，其中嚴重缺乏對人造血管的生物力學基本性能的研究可能是主要原因之一，因為關于紡織基人造血管的性能和性能表徵的深入研究，以及關于各表徵指標的測試方法和測試手段的研究，在我國幾乎是空白。
  3. This paper discusses the designing and making of the dynamic testing systems of engine electronic control system. base on the construction and operation principle of santana 2000gsi m3. 8. 2 engine electronic control systems, design and manufacture led circuit of dynamic testing and fault imitating electronic control unit. on the inspect board, design and equip with motronic 3. 8. 2 ecu i / o measuring joints, design and set up obd - ii diagnostic communication link, design and install fuel pressure inspecting meter. depend on the obd - ii diagnostic communication link and ecu i / o measuring joints, this dynamic testing system can inspect engine electronic fuel injection system, distributorless ignition system, idle speed control system and evaporative emission control system, and can inspect m3. 8. 2 sensors, ecu and actuators, and can interrogate fault memory and erase fault memory ; and can analyse data stream ; and can carry out fault imitating. besides, this paper analyses sensors and actuators typical fault w aves

    2電控單元電路連接器設計製成輸入輸出電子控制檢測端子，並在檢測面板上布置了obd -診斷插座和燃油壓力表。使該動態測試系統能實現對電噴發動機的燃油系統、直接點火系統、怠速控制系統和燃油蒸氣排放控制系統的動態檢測；並通過obd -診斷座、 ecu輸入輸出檢測端子和故障模擬處理單元實現對電噴發動機電控系統各傳感器、電控單元、執行器進行故障碼讀取與清除；動態數據讀取和波形測試和故障模擬等。此外，本論文還分析了傳感器和執行器典型故障波形。
  4. It focuses on the theory of the mineral functional materials " improving the anti - chloride permeability and the chloride binding. the main achievements of this article include : 1 ) use the technology of xrd, sem, bet, laser particle size distributor etc to test the component, the construction, particle size distributor, specific surface etc of micro - silica, ultra - fined slag, high quality fly ash, meta - kaolin clay, four types of the mineral functional material, theoretically analysis the functions which the four mineral functional minerals act on cement concrete, namely pozzolanicity effect, filling effect, micro - aggregate effect, surface adsorption effect and so bring into play the affect of plastification, lowing of temperature, reinforcement, improvement of durability. base on this analysis we can conclude that the proper diameter of the mineral functional material is 5 m - 15 m, that is blain fineness 4500cm2 / g - 7500cm2 / g

    本論文的主要成果包括以下幾個方面： （ 1 ）採用xrd 、 sem 、 bet 、激光粒度分析儀等多種測試手段，探明了以硅灰，超細磨粒化高爐礦渣，優質粉煤灰及偏高嶺土超細粉等4種超細礦物功能材料的組成、結構、粒度分佈、比表面積等基本性質；從理論上分析了礦物功能材料在混凝土中的4種效應，即火山灰效應、填充密實效應、微集料效應、表面吸附效應，並由此發揮出增塑、溫峰削減（降熱） ，增強及耐久性改善等作用；通過相關理論分析，推導出礦物功能材料的合理粒徑范圍在5 m 15 m ，即勃氏比表面積為4500cm ~ 2 g 7500cm ~ 2 g 。
  5. This text studied the mutually interference influences to the aerodynamic force of irregular shape base on analysis using wind force and wind pressure data of super high buildings model obtained by wind tunnel tests, and provided reference to designer and expurgator on building code

    本文以超高層建築剛性模型的高頻天平測力風洞試驗數據和表面測壓風洞試驗數據為依據，研究了復雜外形建築的風力和高層建築相互干擾對風力影響，供設計者及規范修訂時參考。
  6. Half - hourly measurements of co 2, water vapor, and energy exchange using the eddy covariance technique from walker branch watershed, tennessee, 1995 - 1998, http : cdiac. esd. ornl. gov ftp ameriflux data us - sites walker - branch

    對合成數據集和真實數據集的全面測試表明，本文提出的卸載策略的性能均好於現有其它方法。
  7. Standard test method for quantitative sporicidal three - step method to determine sporicidal efficacy of liquids, liquid sprays, and vapor or gases on contaminated carrier surfaces

    在受污染的載體表面測定液體噴液蒸氣或氣體的殺孢子效率的定量殺孢子三步法的標準試驗方法
  8. As to how to exert learning assessment successfully, this article has some probes, and attempts to form a learning assessment system. this system advocates collaboration between teachers and students, attaches importance to testing, daily assessment, science explorations ’ portfolio assessment and science experiments ’ authentic assessment, and guides students to assess themselves. to sum up, this system requires its ideal, objective, measures and results be “ appreciated ” and be received by all students

    基於以上研究，本文制定了相應的具有可操作性的學業評定標準，並對學業評定如何實施進行了有益的探索，認為當前亟需構建一個強調師生合作，重視考試（書面測試） 、日常評定、科學探究的檔案袋評定以及科學實驗的表現性評定相結合，引導學生開展自我評定和同伴評定的學業評定體系，這一體系強調學業評定的理念、目標、方法和結果必須被學生所真正「欣賞」和接受。
  9. Test method for determining interlaminar resistance of insulating coatings using two adjacent test surfaces

    利用兩個相鄰試驗表面測定絕緣塗層層間電阻的方法
  10. Must have working knowledge of cmm, micro - height, hardness tester, surface gage, calipers, and additional equipment

    必須有關于cmm ，高度測量，硬度測試，表面測量，齒輪等設備知識。
  11. Standard practice for selection of coating specimens for appearance measurements

    表面測量用塗層試樣的選擇的標準規程
  12. Carrying out an inspection which is based on visual inspection and non - intrusive tests

    進行檢驗憑肉眼視察和表面測試
  13. Furthermore, we compared the mechanical properties between the modified nano - cac03 / pp and unmodified nano - cac03 / pp. we have investigated the composites by means of mechanical testing, dsc, xrd, ft - ir, tem, sem, etc. the relation between the structure and property of the composites has been discussed in this thesis. we studied the nano - particles by means of ls particles size analysis, we also studied the modified nano - cac03 by means of ft - ir

    論文中對caco _ 3粒子進行了粒度與比表面測試分析，對經鈦酸酯偶聯劑表面改性的納米caco _ 3粒子進行了紅外吸收光譜分析，對改性后的復合材料進行了力學性能測試、差熱掃描量熱分析、 x射線衍射譜、紅外吸收光譜、透射電鏡、掃描電鏡等分析，討論了樣品中結構和性能之間的關系。
  14. Surface wave test

    原位測試表面波試驗
  15. Tn order to eliminatc the error caused hylight power drift of incident light, we adopt the method of the ration of scattering light to measure the concentration of protein in milk. that is to measure 90 " scattering light intensity and 0 " transmitting light intensity in the light incident plane. the ratio of them is to be used to express measured optical parameter

    由於牛乳蛋白質的測量精度要求很高，為了消除因入射光的光功率漂移而引起的誤差，我們採用散透比法來測量牛乳蛋白質的含量，即在光的入射平面內同時90處的散射光光強is和測量0處的透射光光強it ，用它們的比值來表徵測試牛乳蛋白質含量的光學參量。
  16. Standard test method for single wheel driving traction in a straight line on snow - and ice - covered surfaces

    在覆雪或覆冰表面測定單輪直線驅動摩擦力的標準試驗方法
  17. Test the colours used in web pages against a black and white printer or a monochrome screen. ensure that a sharp contrast is displayed

    以黑白兩種顏色的印表機或只有這兩種顏色的屏幕畫面測試網頁所採用的顏色，以確保所展示內容的顏色對比分明。
  18. The object - oriented power system transient stability simulation software provides a vivid and friendly man - machine interface ( mmi ). according to the test of a given system, the whole software is proved to have the characteristics of precise calculation and convenient operation, which further proves the immense potentiality of the application of oot in the development of power system software

    本文所開發的面向對象的電力系統暫態穩定模擬軟體提供了友好、形象直觀的人機界面，測試結果表明，該軟體具有計算準確、操作直觀和易學易用的特點，從而進一步證明了面向對象技術在電力系統軟體開發應用中的巨大潛力。
  19. The mode number and the frequencies range, which were considered during calculating the wind - induced responses of large cantilevered roof by using the method of frequency domain, were analysed and discussed, according to the results of wind tunnel tests of bahamas and guinea stadium grandstand cantilevered roofs, and the rules that rms displacement and rms internal force responses under strong wind force changing with participant modes number and frequencies range were obtained, and which could be explained from the point of wind pressure power spectrum densities of the measured points on surface of the roof

    摘要根據援巴哈馬體育場和援幾內亞體育場主看臺懸挑屋蓋風洞試驗數據結果，分析和探討了採用頻域分析法計算大跨度懸挑屋蓋風振響應時應考慮的結構模態數和頻率范圍，得到強風作用下懸挑屋蓋結構均方根位移與內力響應隨參與計算的模態數和頻率范圍的變化規律，並從屋蓋表面測點風壓譜密度的角度解釋了這種變化規律。
  20. Standard test method for determining interlaminar resistance of insulating coatings using two adjacent test surfaces

    利用相鄰的兩個測試表面測定絕緣覆層層間電阻的標準試驗方法
分享友人
分享到 Line

分享到臉書