表面蒸發器 的英文怎麼說

中文拼音 [biǎomiànzhēngfāqì]
表面蒸發器 英文
baudelot evaporator
  • 表 : Ⅰ名詞1 （外面;外表） outside; surface; external 2 （中表親戚） the relationship between the child...
  • 面 : Ⅰ名詞1 （頭的前部; 臉） face 2 （物體的表面） surface; top 3 （外露的一層或正面） outside; the ri...
  • 蒸 : Ⅰ動詞1. （蒸發） evaporate2. （利用水蒸氣的熱力使食物熟或熱） steam Ⅱ名詞[中醫] （將藥物隔水蒸熟） steaming
  • 發 : 名詞（頭發） hair
  • 器 : 名詞1. （器具） implement; utensil; ware 2. （器官） organ 3. （度量; 才能） capacity; talent 4. （姓氏） a surname
  • 表面 : surface; superficies; boundary; face; rind; sheet; skin; outside; appearance
  • 蒸發 : [物理學] [化學] evaporation; evaporate蒸發計 evaporometer; evaporimeter; atmidometer; atmometer; ...
  1. Application of the surface evaporating air condensers in the light hydrocarbon recovery units

    表面蒸發式空冷器在輕烴回收裝置中的應用
  2. The direct type of evaporative air cooler uses primary wet surfaces.

    直接蒸發式空氣冷卻器是利用原有的濕表面工作的。
  3. More meaningful comparisons can be made by comparing water loss from the potometer with that from an atmometer ( an apparatus used to measure the rate of evaporation from a porous pot or other nonliving wet surface ), which allows uncontrolled evaporation

    更有意義的是，可以比較蒸騰計的失水與蒸發計（通過有孔小罐或者潮濕表面來測量蒸發速率的儀器）的失水間的區別。
  4. This paper discusses the designing and making of the dynamic testing systems of engine electronic control system. base on the construction and operation principle of santana 2000gsi m3. 8. 2 engine electronic control systems, design and manufacture led circuit of dynamic testing and fault imitating electronic control unit. on the inspect board, design and equip with motronic 3. 8. 2 ecu i / o measuring joints, design and set up obd - ii diagnostic communication link, design and install fuel pressure inspecting meter. depend on the obd - ii diagnostic communication link and ecu i / o measuring joints, this dynamic testing system can inspect engine electronic fuel injection system, distributorless ignition system, idle speed control system and evaporative emission control system, and can inspect m3. 8. 2 sensors, ecu and actuators, and can interrogate fault memory and erase fault memory ; and can analyse data stream ; and can carry out fault imitating. besides, this paper analyses sensors and actuators typical fault w aves

    2電控單元電路連接器設計製成輸入輸出電子控制檢測端子，並在檢測面板上布置了obd -診斷插座和燃油壓力表。使該動態測試系統能實現對電噴發動機的燃油系統、直接點火系統、怠速控制系統和燃油蒸氣排放控制系統的動態檢測；並通過obd -診斷座、 ecu輸入輸出檢測端子和故障模擬處理單元實現對電噴發動機電控系統各傳感器、電控單元、執行器進行故障碼讀取與清除；動態數據讀取和波形測試和故障模擬等。此外，本論文還分析了傳感器和執行器典型故障波形。
  5. Based on the field investigations and laboratory examinations, a study of the population of the epiphytic dolichomitriopsis diversformis ( mitt. ) nog. in fanjing mountain reveals that its habitats are different among different host trees, but that there lies the common habitat characteristics of not more than 2m height from the bottoms of host trees trunks, less light, high relative humidity, slow wind speed, slow evaporation speed and long time of remaining humid in middle - lower tree bark ; that it is one dioecious moss species, the morphology is remarkably different between its perichaetium and perigonium, the number of its perichaetia is much more than that of its perigonia, its perigonium is difficult to find out, its sporophyte is upright, its seta is long and thin, its capsule is regular long oval and its calyptra is cucullate

    摘要通過野外調查和室內觀測對貴州省梵凈山樹附生尖葉擬船葉蘚種群的研究表明，其生境因其所附生的樹種不同而有所不同，但具有共同特點：附生在樹干下部距地面2m高的范圍之內，光照弱、濕度大、風速小、蒸發量小、中下部樹皮保持濕潤的持續時間長；其為雌雄異株蘚種，雌、雄器苞形態差異明顯，雌器苞數量多，雄器苞數量少並且難于發現，孢子體直立，蒴柄細長，孢蒴規則長卵形，蒴帽兜形。
  6. The equipment adopts centrifugal sliding plow groove rotor and is the newest structure evaporator at present. it can form membrane under the condition of small flow. comparing with that of fixed space drag evaporator, its evaporation capacity can increase 40

    本設備採用離心式滑動溝槽轉子，是目前國外最新結構蒸發器，在流量很小的情況下也能形成薄膜，在簡體蒸發段內壁表面附著處理液中的淤積物可被活動刮板迅速移去，和固定間隙的刮板蒸發器相比，蒸發量可提高40 69 。
  7. Thirdly, the conclusions of the two aspect applications are given as follows : the exploration of the application of the evaporation duct prediction to the flux relationship research and evaporation duct predicting shows that based on this predicting method and with microwave refractometer, as sensor, ( 1 ) the dimensionless gradient function of temperature, humidity and refractivity in the flux relationships can be determined with higher precision, ( 2 ) the limitations of conventional observations on the predicting accuracy for evaporation duct can be avoided and the precise prediction for evaporation duct can be obtained with the accurate measurement of refractivity profile within a few meters. the radar performance under given evaporation

    三、對兩個應用問題的討論表明：基於本文發展的蒸發波導預測理論，使用微波折射率儀為傳感器： （ 1 ）開展通量關系研究時，可以用於邊界層溫度、濕度和折射率無量綱梯度函數的精確測定和得到蒸發波導環境預測所需的偽折射率參數化函數關系； （ 2 ）預測蒸蒸發波導環境特性和傳播特性及其應用研究發波導環境時可以避免使用傳統氣海界面要素測量中存在的局限，並用折射率音d面不太高的精確測量結果精確預測蒸發波導環境。
  8. In this paper, the contrast experiments and theoretical researches on frosting and defrosting on low - energy surface and common metal surface are carried out simultaneously. low - energy surface restrains the frosting of air cooler, and the adhesion work of unit - area frost on low - energy surface is smaller than that on common metal surface, so pneumatic defrosting becomes easier

    本文還對低能表面與普通金屬表面的結霜、除霜進行了對比實驗和理論研究：低能表面不僅能有效地抑制蒸發器的結霜，而且單位面積霜層粘附功w _ ~ *比普通令屬壁面小，因而氣動除霜更容易。
  9. In view of results obtained in the work, the commonly 共同 made assumption 假定 of equality 均等 of heat transfer coefficients for both the bundle and its additional surface may lead to certain 確定 errors 誤差 in heat transfer calculations and discrepancies between the calculated values of heating surfaces area and later operational needs of steam generator

    在工作得到的結果，傳熱系數的做法為捆綁和它附加的表面在熱傳遞演算也許導致某些熱化表面的誤差值和蒸汽發電器之間的錯誤和差誤。
  10. One of the most key technologies of preparing cd1 - xznxte detector is to make ohmic contact film electrode on cd1 - xznxte crystal ' s surface, and the main technology usually used is evaporation, but the cohesion of evaporated film is n ' t very firm

    制備cdznte探測器最關鍵的技術之一就是在cdznte表面制備出歐姆接觸薄膜電極。關于在cd _ （ 1 - x ） zn _ xte晶體表面制備接觸電極用導電薄膜，大都是採用蒸發鍍膜技術，膜層與cdznte晶體結合不很牢固。
  11. After the rationality of theoretical model has been testified, going along a series of numerical simulation and find the best ratio of evaporation segment and condensation segment by means of analyse the temperature variety of the electronic element surface on the effect of the radiator structure change. a series of strenthen step about heat transfer put forward theoretically by means of numerical analysis focuse on the thermal resistant of each tache of the heat transfer

    在證實了本理論模型是合理的基礎上，本文根據所建立的模型進行了一系列的數值模擬計算，分析了熱管型電子器件散熱器的結構尺寸（蒸發段和冷凝段的長度比、肋片的高度等）變化對發熱器件表面溫度的影響，得到了蒸發段和冷凝段的最佳長度比。
  12. Because of the larger contact angle 9 of low - energy surface, the phase transformation energy barrier of vapor is higher than those of high - energy surface, and the frosting of air cooler is effectively restrained ; 3

    低能表面因水接觸角大，水蒸氣相變時的核化能障較大，從而有效地抑制了蒸發器的結霜。
  13. Analysis of physics characteristic of evaporation emission from gasoline - ethanol by gas chromatography - mass spectrometry

    表面蒸發空冷器的腐蝕及防護措施
  14. In the case of small molecule, the film of tcnq and snpc was prepared by thermal vacuum evaporation. the effect of substrate temperature on the surface morphology and the conductance of the thin film has been investigated. the relation between the sensitivity of thin film and temperature of the substrate was described

    對于兩種小分子材料，本文先採用真空蒸發的工藝制備敏感薄膜，探討了不同基板溫度對薄膜表面形態、膜的導電性的影響，並進一步分析了基板溫度、膜厚和電極間距對傳感器敏感特性的影響。
  15. The break was assumed to be a single tube double - ended and three - tube double - ended shear break. the diameter of the break orifice is 0. 876mm and 1. 518mm respectively. the characteristic responses of main thermal - hydraulic parameters, such as primary pressure, secondary pressure, break flow rate, pressurizer level, secondary side level of steam generator and so on, were presented in this thesis

    試驗再現了核電廠蒸汽發生器單根傳熱管雙端斷裂事故和三根傳熱管雙端斷裂事故發生后的熱工水力現象，給出了事故過程中一次系統壓力、二次系統壓力、破口流量、蒸汽發生器二次側水位、穩壓器水位、元件表面溫度等主要參數的瞬態響應。
分享友人
分享到 Line

分享到臉書