衰減矩 的英文怎麼說

中文拼音 [shuāijiǎnjǔ]
衰減矩 英文
damping moment
  • 衰 : 衰動詞（衰弱） decline; wane
  • 矩 : 名詞1. （畫直角或正方形、矩形用的曲尺） carpenter's square; square2. （法度; 規則） rules; regulations 3. [物理學] moment
  • 衰減 : attenuation; decay; damping; reduction; rejection; weakening; deamplification; dampening; dying o...
  1. According to the computation process of the fem and assumption, associating of the fem mesh that have separated and the grouting stress diffusion equation, the integral stiffness matrix and the load matrix can be formatted, then the displacement of the nodal point can be got after solving the simultaneous linear equations. and then the grouting parameter can be computed and analyzed

    然後，依據有限元法的計算步驟和所作的假設，結合已經離散化了的網格、灌漿壓力擴散衰減公式，形成整體剛度矩陣、荷載矩陣，經求解后得到結點的位移，並依此計算分析灌漿參數。
  2. Abstract : this paper considers the decentralized stabilization problem via local state feedback control laws for a class of large - scale linear discrete - time systems with delay interconnections. a sufficient condition for decentralized stabilizability is derived and is expressed as a system of linear matrix inequalities. furthermore, the problem of designing a decentralized state feedback control law with smaller feedback gain parameters is formulated as a convex optimization problem, and latter can be solved by using existing efficient convex optimization techniques. the obtained controller enables the closed - loop systems to be not only stable, but also of any prescribed stability degree

    文摘:用一組線性矩陣不等式給出一類線性離散時滯大系統分散能鎮定的一個充分條件，進而，通過建立和求解一個凸優化問題，提出了具有較小反饋增益參數的分散穩定化狀態反饋控制律的設計方法.所得到的控制器不僅使得閉環系統是穩定的，而且還可以使得閉環系統狀態具有給定的衰減度
  3. 5. standard h2 / h and robust h2 / h mixed control problems are systematically analyzed by the method of linear matrix inequation. design method of the optimum guaranteed performance control rule as well as the one which satisfies the given disturbance attenuation degree and performance constraints are discussed 6

    運用線性矩陣不等式方法，系統分析了標準h _ 2 h _混合控制問題及魯棒h _ 2 h _混合控制問題，探討了滿足給定的擾動衰減度和性能約束的保性能控制律及最優保性能控制律的設計方法。
  4. A method is provided to measure the friction parameters of the bed. the maximum friction torque, coulomb friction torque, viscous friction coefficient and moment of inertia can be gotten by fitting the free reduced rate curve of the gimbals and measuring the motor current when the motor begins to rotate

    提出了一種測量轉臺摩擦特性的方法，通過對轉臺在無外推力作用下的速度衰減曲線的擬合以及電機啟動過程電流和轉速的測量，可以得到最大靜摩擦力矩、庫侖摩擦力矩、粘滯摩擦系數及轉動慣量。
  5. To obtain an accurate measure of the precessional rate one has to attenuate the signal proportional to torquing current by cosβ.

    為了準確測量進動角速度，必須使與加矩電流成比例的信號衰減cos倍。
  6. The electric field, magnetic field, critical frequency, surface current, power transmission and attenuation, as well as te and tm modes in waveguides are discussed

    給出計算等效矩形截面波導的te模和tm模、電磁場、臨界頻率、波導壁電流、功率傳輸和衰減的公式。
  7. When frequency slightly higher than cutoff, using perturbation method it is to know that tunnel wall wet make attenuation of electromagnetic wave lower not only in rectangular tunnel but also in circular tunnel

    當頻率略高於隧道截止頻率時利用微擾法可知：不論是矩形隧道還是圓形隧道，隧道壁潮濕使電磁波的衰減率降低。
  8. When frequency much higher than cutoff, using classical formulation method it is to know that tunnel wall wet make attenuation of electromagnetic wave increase in rectangular tunnel and make attenuation of other electromagnetic wave mode increase but te mode with tunnel wall permittivity

    當頻率遠高於截止頻率時，利用傳統公式法可知：矩形隧道中隧道壁濕潤引起衰減增大；圓形隧道中e模式衰減率因電容率的增大而減小，其他各模式則因電容率的增大而增大。
  9. In this paper, we analyzed the theory of several linear methods for the pole extraction, such as prony method, kt method and matrix pencil method. then, numerous results based on scattering responses synthesized from weighted sums of two exponentially damped sinusoids are provided to compare theirs performance

    本文主要分析了幾種極點求解線性演算法? ? prony法、 kt法、矩陣束法的基本原理，並比較了這幾種演算法對于只含兩個指數衰減信號模型參數估計的模擬結果。
  10. A time - variant reliability formulation is presented in this paper to account for the effects of fatigue, corrosion and maintenance actions on the first yield reliability of midship section modulus. a probabilistic model for long - term distribution of wave - induced fatigue stress range is established. for the purpose of obtaining the performance of structure that stands random fatigue load, the concept of stress parameter and equivalent stress range are introduced

    船舶在由波浪彎矩引起的交變應力作用下，船體構件焊接點處的微小裂紋逐漸擴展；同時，隨著船齡的增加，眾多結構構件遭受腐蝕的作用；從而使船體梁剖面模數減小，船體梁承載能力衰減，船舶結構的安全性將受到相當大的影響。
  11. Based on the radio waves propagation models of circular tunnels and rectangular tunnels, the relation between attenuation and conductivity is analyzed and the concept of conductivity breakpoint is presented

    根據圓形巷道和矩形巷道的電波傳播模型，分析了電波衰減率和電導率的關系，並且提出了電導率斷點的概念。
  12. Fibre optic interconnecting devices and passive components. basic test and measurement procedures. part 3 - 12 : examinations and measurements. polarization dependence of attenuation of a single - mode fibre optic component : matrix calculation method

    光纖互連裝置和無源元件.基本試驗和測量程序.第3 - 12部分:檢驗和測量.單模光纖元件衰減的極化依賴:矩陣計演算法
分享友人
分享到 Line

分享到臉書