衰減阻抗 的英文怎麼說
中文拼音 [shuāijiǎnzǔkàng]
衰減阻抗
英文
damped impedance-
Compared with straight ray tracing, inversion of bending ray tracing is better when data of test are accurate. on the other hand, natural weight is introduced and numerical simulations and experiments of wlm on inversion of velocity and attenuation are also made, which show that wlm, with resistance of noises and convergence of iteration, may get good re - construction images
本文引入了物理意義明確的自然權，對基於自然權的加權阻尼最小二乘反演演算法（ wlm ）在速度反演、衰減反演中進行了數值模擬和試驗研究，結果表明wlm均能獲得良好的重建圖像，迭代收斂，抗噪能力強。Great intermittent noise, wide variety of impendence along with the load and great attenuation of signals have restricted the further utilization of power line
但是，電力線通信通道存在間歇性噪聲大、阻抗隨負載變化大、信號衰減大等缺點，嚴重製約了它的有效利用。The system can resolve the noise and impedance on the power line and obviously improve the abilities of anti - disturbance and successful rate of communication. at the same time, the software realy method and arithmetic is also introduced to settle the problem of attenuation and increase the distance of carrier communication, it can satisfy the need of remote reading meter system
該系統有效地克服了電力線噪聲和阻抗變化等干擾因素，提高了抗干擾能力和通信成功率，同時提出軟體中繼的思想和演算法並加以實現，進一步抑制了線路衰減快的問題，使載波通信的距離增加，滿足了遠程抄表系統的要求。A system scheme of digital image collection plus spread spectrum communication ( abbreviated as ssc ) is presented in this paper after a full analysis of noise characteristics, attenuating characteristics and impedance characteristics of low - voltage power lines
本文首先介紹了低壓電力線的噪聲特性、衰減特性和阻抗特性，然後提出一種數字圖像採集+擴頻傳輸的系統總體方案。Seismic data processing practices demonstrate that the seismic convolution model can be used to correct transmission attenuation component by means of impedance inversion, with the merit of avoiding the screen effect of strata
採用含透射衰減的褶積模型做正演運算，能夠校正地層透射對波阻抗反演結果的影響，尤其能夠消除地層的遮罩現象。To investigate the influence of transmission attenuation of seismic waves in a layer - cake model, the authors formulated a seismic convolution model by considering the coefficient of transmission attenuation, and then provided a new forward algorithm for the model - based seismic inversion of impedance
摘要研究了地震波在層狀地質模型內透射衰減對地震反射信號振幅的影響，給出了含透射衰減的褶積模型，為基於模型的波阻抗反演提供了一種新的正演方法。Constant impedance attenuator
恆阻抗衰減器System scheme of speech coding plus spread spectrum communication was presented based on a full analysis of noise characteristic, attenuation characteristic and impedance characteristic of low - voltage power line. spread spectrum carrier ( abbreviated as ssc ) technology is adopted to overcome problems existing in signal transmission over power line. high quality, low rate mbe compression algorithm was used to complete speech encoding and decoding
在對低壓電力線路的噪聲特性、衰減特性和阻抗特性三個方面充分分析的基礎上，本文提出一種語音編碼+擴頻傳輸的系統總體方案，採用擴頻載波（ spreadspectrumcarrier ，縮寫為ssc ）技術克服電力線傳輸信號存在的問題，採用語音合成質量高並具有較低碼率的mbe壓縮演算法完成語音信號的編解碼。While testing ofeis at different depth of dischargeand charge - discharge at different charge - discharge rate reveale that, these material indicate lower conductivity at highcharge - discharge rate, resulting in bad electrochemical perforemence. melting - cooling and inorganic sol - gel were adopted, which facility - simpleand operating - easy, to prepare v _ 2o _ 5 xeroxes as positive material of li - ion battery. the comparision of structual and electrochemical performance between thesecathode materials were investigated for the first time. their electrochemicalbehaviorswerestudiedbygalvanostaticcharge - discharge, cyclicvoltammetry ( cv ), and electrochemical impedance spectroscopy ( eis ) techniques. the results indicte the sample that prepared by melting - cooling revealed moreexcellent performance at low charge - discharge rate, which achieved a high initialdischarge specific capacity of approximate 320 mah ? g - 1
通過各種充放電測試，循環伏安（ cv ）曲線以及電化學阻抗譜（ eis ）等測試手段對材料的電化學性能進行表徵，結果發現，在低倍率放電下，熔融淬冷法合成的材料具有更好的電化學性能， 0 . 1c恆流放電至1 . 8v時首次放電容量達320mah ? g - 1 ，並且發現， v _ 2o _ 5作為正極材料組裝成的鋰離子二次電池，除首次循環具有較大的不可逆容量外，其餘循環可逆且容量保持能力較好， 20次循環后，容量只衰減了6 . 40 % 。Real - time characteristics of data transmission, remarkable transmission, error - detection and automatic retransmission built in can protocol make it a good option for power line carrier communication, which has some obvious drawbacks such as wide - range variant input impedance, interference and signal attenuation
Can協議中數據的實時傳輸、卓越的錯誤檢出及自動重發功能為建立高效的基於電力線載波（電力線介質存在著大范圍變化的輸入阻抗，較強的干擾和信號衰減）的can通信系統提供了方便。In this paper based on the test and simulation of different power networks, the reliability and practicability of carrier communications are discussed and the impedance characteristic, transmission characteristic, the effect of noise on the low - voltage are also analyzed
本文基於對不同電網環境下的載波傳輸情況進行系統綜合測試和模擬的基礎上，針對載波通信的可靠性、實用性進行了探討。分析了低壓電力網的阻抗特性、傳輸衰減特性以及噪聲特性影響。The fuctions of impedance matching, over voltage protection, ac / dc coupling and amplification / attenuation in the analog circuit are designed to enhance the reliability and testing precision of the module
設計了具有阻抗匹配、過電壓保護、 ac / dc耦合、放大/衰減功能的前端信號處理電路，提高了模塊的可靠性和總體測試精度。But because of the disadvantages of noise, attenuation and rapid impedance changing, it will greatly affect the reliability of communication
不過由於中壓電力線具有噪聲大、信號衰減快、線路阻抗變化大等不利因素，在很大程度上影響了通信的可靠性。分享友人