裂化試驗 的英文怎麼說

中文拼音 [lièhuàshìyàn]
裂化試驗 英文
cracking test
  • 裂 : 裂動詞[方言] （東西的兩部分向兩旁分開） open
  • 試 : 名詞（古代占卜用的器具） astrolabe
  • 驗 : 動詞1. （察看; 查考） examine; check; test 2. （產生預期的效果） prove effective; produce the expected result
  • 試驗 : trial; experiment; test
  1. Standard test method for evaluating stress - corrosion cracking of stainless alloys with different nickel content in boiling acidified sodium chloride solution

    沸騰酸化氯化鈉溶液中不同鎳合量不銹鋼合金應力腐蝕裂紋評定的標準試驗方法
  2. Test method for stress crazing of acrylic plastics in contact with liquid or semi - liquid compounds

    丙烯塑料在與液態或半液態化合物接觸中產生的應力裂紋的試驗方法
  3. A second more severe water test is to place the catalyst in boiling water and observe for any disintegration.

    第二個更苛刻的泡水試驗是將催化劑放在開水中檢查有沒有開裂。
  4. To pass the water test the catalyst should not disintegrate or crumble.

    經過泡水試驗，催化劑應不開裂或破碎。
  5. Here the hsc of sompa is achieved through adding super - effective water reducer, fined slag and silicon fume, and decreasing the water / cement ratio. by varying the area ( spacing ) of tension bars, compressive bars, vertical links and distribution steel and embedding steel fiber and polypropylene fiber we try to improve the behaviors of reinforced high performance concrete one - way spanning slabs in bending, so that its ductility be greater than 5. with the same arrangement of steel the width of bending member is varied to observe the effect of the width / depth ratio on the ultimate compressive strain of concrete

    通過變化受拉筋含筋率和受壓筋、箍筋（鉤筋、分佈筋）含量，或摻加纖維使之成為鋼纖維高強混凝土（ sfrhsc ）和聚丙烯纖維高強混凝土（ pfrhsc ） ，對高強混凝土雙筋截面梁、板的受彎性能進行了試驗研究，試圖改善高強混凝土受彎構件的延性，使其延性比大於5 ；並在相同配筋情況下，通過變化截面寬度，研究了高強混凝土受彎構件的寬高比對壓區混凝土極限應變的影響；並對試驗構件的裂縫發展情況進行了觀測。
  6. The results of experiment on the relationship between tensile strength, shrinkage, self - desiccation shrinkage and flat restraint cracking show that sra ' s physical shrinkage - reducing effect and ea ' s chemical expansion effect greatly enhance the volume stability of concrete and reduce the probability of early - cracking

    對減縮劑與膨脹劑抗拉強度、干縮、自乾燥收縮及平板約束開裂的試驗結果表明： sra的物理減縮作用及膨脹劑的化學膨脹作用，大大提高了混凝土早期的體積穩定性，降低了早期開裂的概率。
  7. Many studies in the related area of stress corrosion or subcritical crack growth use simplified test systems.

    許多有關應力腐蝕或亞臨界裂紋發展領域的研究使用了簡化的試驗系統。
  8. The relative disadvantage angle of transfixion crack how to affect rock mass stabilization can be researched in this article, and the mechanics characteristic in the unloading process for unloading rock mass with single transfixion crack also be analyzed, which affords theory reference to projects of unloading rock mass with single transfixion crack

    通過試驗，探討了貫通裂隙影響巖體穩定的相對不利傾角以及單貫通裂隙巖體卸荷過程的力學特徵，得出裂隙位置的變化促成巖體變形的遞變；特殊位置的裂隙促使巖體的各向導性更加明顯的結論，為相關工程問題提供理論參考。
  9. Through the dry and wet cycling experiment on unmarred beam and pre - cracked beam, the position of initial corrosion and influence of crack on the reinforcing bar corrosion are studied in this paper both the flexural bearing capacity performance and the material mechanical performance of the beams are studied on the test of full scale concrete beam a model of 3d fem is established to simulate the state of the actual full - sized rc beam and electronic accelerating test beams, computational results and test results are compared

    通過對混凝土梁的干濕循環試驗，研究了在混凝土梁中的鋼筋初始銹蝕情況，以及不同寬度的裂縫對于鋼筋初始銹蝕的影響。通過對足尺銹蝕混凝土梁的試驗，研究了混凝土梁在海洋環境侵蝕作用下的材料性能的變化和抗彎承載能力的變化。
  10. Based on the experiment results, the damage form of abnormal exterior joint are summarized, characteristics of hysteresis curve are studied, the effect of stirrup ratio and height of column section and beam section on anti - shear property of abnormal joint are discussed, working mechanism of abnormal exterior joint is researched, the conclusion that the anti - crack and bearing capacity of abnormal joint are studied by analyzing the minor core of abnormal exterior joint is proposed, the basic data is provided for the design formula of abnormal joints

    根據試驗結果，總結了異型邊節點的破壞形態，研究了節點滯回曲線的特徵，討論了節點核芯配箍率、樑柱截面高度變化對異型邊節點抗剪性能的影響，分析了異型邊節點的受力機理，提出應以「小核芯」為分析單元來研究此類節點抗裂和承載力的建議，為異型節點設計公式的建立提供了基礎數據。
  11. Based on the construction of the testing section for the lining of jiping main canal in shandong province of south - to - north water transfer project, the main causes of the cracking from the mechanized lining concrete slabs are analyzed from the aspects of foundation treatment, bedding layer placement, quality of the raw materials for the concrete, placement of the concrete, cutting of the hardened concrete and the curing of the concrete, and then the relevant prevention and control measures are pertinently put forward

    摘要結合山東省南水北調濟平乾渠工程襯砌試驗段施工情況，著重從地基處理、墊層料鋪設、混凝土原材料質量、混凝土澆築、成型混凝土割縫及養護幾個方面分析了機械化襯砌混凝土板裂縫產生的主要原因，並針對性地提出了預防及控制措施。
  12. Taking bench shooting of the shuibuya yihongbao project as example, it makes use of the digital television system of drilling overall - hole wall to actually measure, the testing result of lateral fractural range is 4 - 5m, and that of bottom fractural range is about 3m

    本文試驗工作是以水布埡溢洪道工程梯段爆破為實例，採用鉆孔全孔壁數字電視系統對混裝乳化炸藥爆破破裂范圍進行了實際測試，測試結果為：側向破裂范圍為4 5m ，底部破裂范圍值為3m 。
  13. When the conglomeration becomes serious, it will threaten the steady, safe, and long - term operation of the overall system. on the basis of the technology of purification of hot gas of biomass gasification and biomass utilization technology, this thesis focused attention on the experimental and applied research biomass tar catalytic pyrolysis aimed to the characteristics of biomass resource in china

    本文在綜述國內外有關生物質焦油脫除的基礎上，圍繞生物質熱解氣化集中供氣系統的攻關項目，針對我國農村經濟發展現狀及生物質資源特點，對適合我國農村應用的生物質焦油催化裂解技術進行了詳細的試驗及應用研究。
  14. Tga. insulating and sheathing materials of electric and optical cables - common test methods - part 4 - 1 : methods specific to polyethylene and polypropylene compounds - resistance to environmental stress cracking - measurement of the melt flow index - carbon black and or mineral filler content measurement in polyethylene by direct combustion - measurement of carbon black content by termogravimetric analysis - assessment of carbon black dispersion in polyethylene using a microscope

    電纜和光纜的絕緣和護套材料.通用試驗方法.第4 - 1部分:聚乙烯和聚丙烯化合物專用方法.抗環境應力致裂.熔化流動指數測量.通過直接燃燒測量聚乙烯中炭黑和或礦物填料含量.通過熱重分析法
  15. Insulating and sheathing materials of electric and optical cables - common test methods - part 4 - 1 : methods specific to polyethylene and polypropylene compounds - resistance to environmental stress cracking - measurement of the melt flow index - carbon black and or mineral filler content measurement in polyethylene by direct combustion - measurement of carbon black content by thermogravimetric analysis - assessment of carbon black dispersion in polyethylene using a microscope

    電纜絕緣護套材料的通用試驗方法.第4部分:聚乙烯和聚丙烯專用方法.第1節:耐環境應力破裂性.在空氣中熱老化后的卷繞試驗.熔體流動指數測量.聚乙烯中炭黑和
  16. Pe. insulating and sheathing materials of electric and optical cables - common test methods - methods specific to polypropylene and polypropylene compounds - resistance to environmental stress cracking - measurement of the melt flow index - carbon black and or mineral filter content measurement in pe by direct combustion - measurement of carbon black content by tga - assessment of carbon black dispersion in polyethylene using a microscope

    電纜和光纜的絕緣和護套材料.通用試驗方法.聚丙烯和聚丙烯化合物專用方法.抗環境應力致裂.熔化流動指數測量.直接燃燒法測量聚乙烯
  17. The highlights of this paper include : hoop toughness criterion for longitudinal heat checking of tool joint was introduced firstly ; failure criterion for crescent - shaped wear casing was established according to the results of full - scale collapse tests ; new - typed alloy for hardbanding of tool joint was developed, its property has showed good performance in the tests

    本文的主要創新點在於：以現場失效案例分析為基礎，提出了鉆桿接頭縱向熱裂的橫向韌性判據；通過對已磨損套管的實物擠毀試驗研究，確定了不均勻磨損套管的擠毀失效準則；設計出了具有獨立知識產權的鉆桿接頭硬化帶用新型耐磨減摩合金的成分，經實驗室試驗表明其性能可以達到或超過國外同類產品。
  18. By virtue of the experiments carried out on the modified pilot - scale biomass gasification system, the temperature field in the gasifier is made explicit. and also some principles about how the temperature, feedstock and extraction mode exert influences on heat value and production rate of gas are attained. in addition, some tentative tests of tar cracking and thermodynamic characteristics of biomass gas burner have been performed, which are that indispensable to design and operation of biomass gasification demonstration project

    接著，通過對生物質中熱值氣化中試試驗系統的多次改造和反復試驗，了解了氣化爐內溫度場分佈，得出了溫度、物料、抽氣方式等因素對生物質熱解氣的成分、熱值和產氣率影響的一些基本規律，並進行了初步的焦油催化裂解試驗和煤氣燃燒器的熱力特性、燃燒特性試驗，為面向工程應用的集中供氣示範項目提供了必要的設計和運行依據。
  19. Common test methods for insulating and sheathing materials of electric cables - part 4 : methods specific to polyethylene and polypropylene compounds - section 1 : resistance to environmental stress cracking - wrapping test after thermal ageing in air - measurement of melt flow index - carbon black and or mineral filler content measurement in pe

    電纜絕緣和鎧裝材料通用試驗方法.第4部分:聚乙烯和聚丙烯復合物專用方法.第1節:耐環境應力裂化試驗.空氣中熱老化后的纏繞試驗.溶體流動指數的測量. pe中炭黑和或礦物填充料的含量測量
  20. Insulating and sheathing materials of electric cables. common test methods. part 3 : methods specific to pvc compounds. section 1 : pressure test at high temperature. tests for resistance to cracking

    電纜絕緣和護套材料.通用試驗方法.第3部分:聚氯乙烯化合物專用方法.第1節:高溫下的壓力試驗.耐斷裂性試驗
分享友人
分享到 Line

分享到臉書