裂谷底面 的英文怎麼說
中文拼音 [liègǔdemiàn]
裂谷底面
英文
rift-floor surface- 裂 : 裂動詞[方言] （東西的兩部分向兩旁分開） open
- 谷 : 谷名詞1 （兩山或兩塊高地中間的狹長而有出口的地帶） valley; ravine; gorge 2 （姓氏） a surname 3 ...
- 底 : 底助詞（用在定語后, 表示定語和中心詞之間是領屬關系, 現在多寫作「的」）
- 面 : Ⅰ名詞1 （頭的前部; 臉） face 2 （物體的表面） surface; top 3 （外露的一層或正面） outside; the ri...
- 谷底 : valley bottom; valley floor谷底灘地 strath; 谷底腫脹 bulging in valley （凍土區）
-
( 2 ) according to the forming model of the deep pull cracks, they can be divided into three classes pulled cracks -, pressed cracks and sheared cracks. ( 3 ) based on the two - dimensional and three - dimensional finite element methods. the following results can be affirmed : in the slope excavating process, the base surface will rebound in the direction of the excavating surface ' s excerior normal. the maximal displacements of the left and right bank are + 3. 6cm and + 2. 4cm ; the arch abutment will rebound in the direction of the river valley, the maximal displacements of the two bank are + 3. 5cm and + 2. 2cm ; the upstream and downstream surface will rebound in the direction of the normal direction. the maximal displacements are + 2. 1cm and + 1. 7cm. ( 4 ) the natural slope is stable
（ 3 ）通過二維及三維有限元分析得知，左右岸拱肩槽邊坡在開挖過程中，開挖底面主要表現為朝開挖面外法線方向發生回彈，左右岸最大位移量分別為+ 3 . 6cm 、 + 2 . 4cm ；拱端面主要表現為向河谷方向發生側向回彈，左右岸最大位移量分別為+ 3 . 5cm 、 + 2 . 2cm ；上下游坡面主要表現為向臨空方向的回彈，左右岸最大位移量分別為+ 2 . 1cm 、 + 1 . 7cm ；開挖使巖體產生由卸荷回彈導致的傾倒拉裂現象。This segregation behavior of sn accords with the mechanism of non - equilibrium segregation. it can be obtained through the theoretical calculations that the critical time of sn non - equilibrium segregation is 124 seconds at 750 and the critical cooling rate is 8 / s when cooling from 1320. it is suggested that controlling the cooling rate during continuous casting to avoid the critical cooling rate ( 8 / s ) and avoiding high stress near the trough temperature ( 750 ) may control the form
通過研究殘留元素sn的偏聚機制及其對o . 15wt . % c鋼熱塑性的影響，對試驗鋼進行脆性預測:建議在該鋼的連鑄過程中彎道矯直溫度盡量避開塑性谷底溫度750 ，二冷區的冷速盡量避開臨界冷卻速率8 / s ，從而可以減少該低碳鋼連鑄坯表面裂紋和橫向裂紋，提高其成材率。
分享友人