裝甲理論 的英文怎麼說

中文拼音 [zhuāngjiǎlǐlún]
裝甲理論 英文
armor doctrine
  • 裝 : Ⅰ名詞1 （服裝） dress; outfit; attire; clothing 2 （演員的化裝品） stage makeup and costume Ⅱ動詞...
  • 甲 : Ⅰ名詞1 （天乾的第一位） the first of the ten heavenly stems2 （爬行動物和節肢動物身上的硬殼） she...
  • 理 : Ⅰ名詞1 （物質組織的條紋） texture; grain （in wood skin etc ） 2 （道理;事理） reason; logic; tru...
  • 論 : 論名詞（記錄孔子及其門徒的言行的「論語」） the analects of confucius
  • 裝甲 : 1 （裝有防彈鋼板的） armoured2 （防彈鋼板） plate armour裝甲板 armour; 裝甲兵 armoured force; 裝...
  • 理論 : theory
  1. In the study of the lumber carrier, one of the very important problem is the in spot and ultimate station due to flooding which will bring tremendous threat to the ship because of the few holds in order to study the lumber carrier buoyancy, stability and longitudinal strength under the condition of flooding, the paper adopt fundamental ship principle and iterative and accumulative concept on the basis of insumersibility theory to detailedly calculate the flooding speed flooding amount front draft after draft stability and longitudinal strength considering the ship " s sinking and inclination which will change the center of gravity and the loading station both in hold and on deck and the effect of flooding and lumber amount in holdo in the last, the paper introduces an example of the actual ship named " fei yun ling " and makes a contrast between not taking measure and taking measure which draws a reasonable conclusion and comes up to some advice the method avoids the cockamamie calculating while insures enough precision the paper draws a conclusion that not all the lumber carrier will submerge when suffering the damaged flooding if the loading or measure is suitable

    為了研究運木船舶在破艙狀態下的浮性、穩性和強度，本文在抗沉性理論的基礎上，運用船舶基本原理，採用了迭代和累計的思想，將船舶的進水過程劃分為很多次進水的積累，詳細計算了運木船在破艙進水的過程中，考慮到各種破艙參數、船舶本身的下沉、艙室內木材、甲板貨的裝載情況和在進水過程中船舶本身的傾斜對進水重心的影響，以及艙室內的進水量和木材對破口處進水速度的影響，船舶總的進水速度、進水量、首尾吃水、穩性的實時狀態和最終船舶的總縱強度，給出了計算實例，並進行了在採取用泵抽水前後浮態參數的對比，得出了該船舶在艙室內的貨物積載量達到某個數值時可以保證船舶在破艙進水時不會沉沒，或者在當開口小於某數值時，採取適當的措施后，可以使船舶避免沉沒。
  2. The weight gain of powders could be slightly increased with the increasing ph value, formaldehyde dosage and powder loadage, but the most utilization ratio of silver was only 35. 2 percent. the composite powders with the silver content between 13 % ~ 70 % were produced

    盡管提高ph值、甲醛量及粉體的裝載量能在一定程度上增加化學鍍后粉體增重即銀的析出量，但遠低於理論析出值，銀的最大利用率僅為35 . 2 。
  3. In this paper, firstly the macro parameter of the series connection app was comprehensively analyzed, among which the trajectory location of the bullet emission and the terminal velocity of the bullet were mainly analyzed, and the feasibility of the series connection app to cope with explosive reactive armor was demonstrated. and then the macro design about the head of the series connection app was made, among which a particular analyse about the bullet " s launching process was made, from which we concluded the relation between the thickness of the airproof loop and the velocity of the bullet detached from the carrier and the relation between the length of the bullet and the velocity of the bullet detached from the carrier and the relation between the length of the bullet and the burning rate of the powder and the relation between the length of the bullet and the maximum pressure of the emission hole and the relation between the length of the bullet and the emitting time of the bullet, and the reasonable str ucture of the head of the carrier and bullet were designed, then the intensity of the head of the carrier was checked out using of the software of ansys

    本文首先對子母式穿甲彈總體參量作了全面的計算分析，其中主要分析了子彈射出的彈道位置和必要的子彈著靶速度，論證了子母式穿甲彈對付爆炸式反應裝甲的可行性，然後對子母式穿甲彈彈頭部進行了總體設計，其中主要對子彈的發射過程進行了詳細的分析，得出了母彈彈頭部發射孔內閉鎖環厚度與子彈飛離母彈速度的關系、子彈長度與子彈飛離母彈速度的關系、子彈長度與火藥燃燒率的關系、子彈長度與母彈彈頭部發射孔內最大壓力的關系以及子彈的長度與子彈發射所需時間的關系，設計出了合理的母彈彈頭部結構和子彈的結構，並利用ansys有限元分析軟體對母彈彈頭部的強度進行了校核。
  4. This dissertation bases on the research of battlefield armored reconnaissance tank system, which is a very important reconnaissance & information reception means for our country ? digital armored troops. the zzco2 radar armored reconnaissance tank system is the collector of radio information by use of the radiation and reflection of electromagnetic wave, at the same time it is a system which saves, processes and transmits the radar information picked up. the content of this dissertation involves the design and development of zzco2 ? software system

    本論文以我軍裝甲機械化部隊坦克師的戰場裝甲偵察系統的研製為背景撰寫。該系統是我國數字化裝甲部隊的重要偵察和信息獲取工具。其中zzc02型雷達偵察車（型）是該系統的前沿偵察車，是不可見電磁頻段的雷達信息的收集者，是以電磁波輻射、反射作為信息獲取的主要手段，以計算機主機為中心的信息採集、處理、存儲和傳輸系統。
  5. In this paper the experimental research of hydra ulic oil used on a certain composite gearbox are carried on the experimental fo rm ulas are drawn respectively between viscosity 、 density 、 specific heat and temper ature the function of viscosity to temperature and pressure is deduced the com parative analysis among the new oil 、 used oil and ordinary antifriction oil ind icates the performance of the specitic oil is excellent these conclusions are b eneficial to the advanced analysis of the vehicle transmission system and formul ate the manual of relevant armored caterpillar

    該文對某軍用履帶裝甲車輛綜合傳動系統使用的液壓油進行了試驗分析，得出了這種液壓油的粘度、密度、比熱與溫度的經驗關系式，推導出了粘度在溫度、壓力綜合作用下的函數關系，並對新油、舊油、普通抗磨液壓油的粘度進行了對比分析，這對于使用這種液壓油的傳動系的分析計算和制定相關軍用履帶裝甲車輛的使用規范提供了重要的理論依據
  6. Abstract : in this paper the experimental research of hydra ulic oil used on a certain composite gearbox are carried on the experimental fo rm ulas are drawn respectively between viscosity 、 density 、 specific heat and temper ature the function of viscosity to temperature and pressure is deduced the com parative analysis among the new oil 、 used oil and ordinary antifriction oil ind icates the performance of the specitic oil is excellent these conclusions are b eneficial to the advanced analysis of the vehicle transmission system and formul ate the manual of relevant armored caterpillar

    文摘:該文對某軍用履帶裝甲車輛綜合傳動系統使用的液壓油進行了試驗分析，得出了這種液壓油的粘度、密度、比熱與溫度的經驗關系式，推導出了粘度在溫度、壓力綜合作用下的函數關系，並對新油、舊油、普通抗磨液壓油的粘度進行了對比分析，這對于使用這種液壓油的傳動系的分析計算和制定相關軍用履帶裝甲車輛的使用規范提供了重要的理論依據
  7. Based on theory of impact dynamics, the process of penetration test is simulated and the strength of supporting frame is checked

    介紹了沖擊動力學的基本理論，對侵徹試驗中裝甲材料的破壞進行了數值模擬，校核了試驗靶架的強度，模擬結果和試驗值進行了比較。
  8. As a result the relatively reasonable basic data is designed and mathematics model on the firing effectiveness is established. then the c language program is used to solve the model and reasonable data index and relative theory on the basis of the large number of the simulation computation of the set target are obtained. the paper creatively puts forward the theory of the ship - borne artillery terminal guided projectile system and establishes the mathematics model to evaluate its firing efficiency, and creatively discusses the use of the terminal guidance system in the sea - crossing and island - landing battle, providing a theory basis for the future military struggle against taiwan

    本文的研究針對末制導炮彈這種新型的精確制導武器系統的特點，以炮兵射擊理論為基礎，以現代戰場上重要的點目標和集群裝甲目標為研究對象，設定了比較合理的基礎數據；建立了射擊效能的數學模型；採用統計試驗法，運用c語言設計計算程序對模型進行求解；對設定的重要目標，進行了大量的模擬計算分析，得出了比較合理的數值指標和相關結論；對其作戰應用進行了探討性研究，創造性地提出了船載炮發射末制導炮彈武器系統的新技術，建立了評定其射擊效率的數學模型；創造性地探討了末制導炮彈武器系統在渡海登島作戰中的應用，為未來戰場上我精確制導武器的使用，做好對臺軍事斗爭準備提供了理論依據。
  9. The primaryresearch of this paper includes : setting up the tracking theory of image tracking system on armored vehicle

    本文的研究工作包括以下幾個部分:建立了裝甲戰車圖像跟蹤系統的跟蹤理論。
  10. 5. on the study of the ballistic mechanism of fibre and composites, the ballistic properties are analyzed in details with the numeric experimental phenomenon and damage characters of composite targets, which suggests the excellent ballistic performance of kevlar composite arms

    5 、對纖維的防彈機理、復合材料的防彈機理進行了探索性研究，綜合了大量試驗現象和眾多復合材料靶板的破壞特徵，進行了防彈性能分析，從理論上說明了芳綸復合裝甲的優異防彈性能。
  11. The followings are carried out for ballistic composite with resin matrix to realize its double function of loading and bulletproof and meet various tactics technology demands in the paper 1. the resin and reinforcement for arms ballistic system are selected and ballistic properties for composites with different resin matrixs ( improved phenolic, polyethylene, rubber, bi - phenol - a, and biamaleimide ) and different fibers ( kevlar, glass, carbon and uhmwpe fiber ) are investigated, with the aim of maxwell model to explain the matrix match principle for ballistic composites

    1 、本論文從材料選擇入手，進行了復合裝甲防彈體系用樹脂、增強材料進行了選擇和研究，考核了不同樹脂類型（改性酚醛、聚乙烯、橡膠、雙酚a環氧和雙馬來酰亞胺體系） 、不同纖維（ kevlar纖維、玻璃纖維、碳纖維、高強聚乙烯纖維）復合材料的防彈性能，並引入maxwell模型較好地解釋防彈復合材料的基體匹配原理。
  12. Abstract : in this paper the development of the panel and control system in tank and armored vehicle is ana1ysised with the theory and method of man - machine - environment system engineering

    文摘:該文用人一機一環境系統工程的理論和方法，分析了坦克裝甲車輛儀表和指令系統發展的特點和規律。
分享友人
分享到 Line

分享到臉書