襯墊料 的英文怎麼說

中文拼音 [chèndiànliào]
襯墊料 英文
lining material
  • : Ⅰ動詞1 (在裏面托上一層) line; place sth underneath 2 (陪襯; 襯托) set off Ⅱ名詞(襯在裏面的附...
  • : Ⅰ動詞1 (用東西支、鋪或襯 使加高、加厚或平正) put sth under sth else to raise it or make it leve...
  • : 名詞1 (材料; 原料) material; stuff 2 (喂牲口用的穀物) feed; fodder 3 (料器) glassware 4 (...
  • 襯墊 : backing strap; bearing strip; gasket; insert; insertion; lining; bedding; spacer; washer; laying ...
  1. The development and application prospect of environmental friendly buffering cushions were compared and analyzed, on the base of discussing the buffering properties of corrugated cardboard, honeycomb cardboard, paper mould, dissoluble foam, foaming plant fiber, and expanded perlite buffering cushion

    摘要在論述瓦楞紙板、蜂窩紙板、紙漿模塑、可降解泡沫塑、發泡植物纖維、膨脹珍珠巖等緩沖材特性基礎上,分析比較了各種環保型緩沖的開發研究及應用現狀。
  2. Fill the new shipping container with at least three - inches ( 7. 62 cm ) of foam - in - place, foam corner or edge pads, inflatable packaging, loosefill peanuts or other suitable dunnage materials

    在新運輸包裝箱中填充至少三英寸( 7 . 62厘米)厚的現場發泡、泡沫稜角或邊緣、充氣式包裝、疏鬆填充顆粒或其它適用的
  3. Back - up pads for vulcanized fibre discs iso 15636 : 2003

    硫化纖維磨盤用背
  4. Standard test method for determining wicking of glass fiber blanket insulation aircraft type

    玻璃纖維絕緣材芯吸性測定的標準試驗方法
  5. Standard specification for backer material for use with cold - and hot - applied joint sealants in portland - cement concrete and asphalt joints

    硅酸鹽水泥混凝土和地瀝青接頭加熱和製冷接縫密封膠的標準規范
  6. Standard test method for creep properties of package cushioning materials

    包裝件蠕變特性的標準測試方法
  7. Execution of ceramic linings by thin mortar bed technique ; hydraulic mortar

    採用稀灰漿工藝製作陶瓷里.第1部分:液壓灰漿
  8. Standard test method for determining changes in fire - test - response characteristics of cushioning materials after water leaching

    測定水浸出后燃燒試驗響應特性變化的標準試驗方法
  9. Test method for determining changes in fire - test - response characteristics of cushioning materials after water leaching

    水淋洗后燃燒試驗響應特性變化測定方法
  10. Tile cutting disks, deep drawing tools, plain bearings, sealing and sliding sealing rings, guide gibs, liners and bushings, shaft protective sleeves, rolls for cold rolling mills, tools for diecasting pulverized materials, cutting disks

    飾面花磚切削盤、深拉工具、滑動軸承、密封圈和滑動密封圈、導向槽、和軸套、曲柄軸套、冷壓磨碎機軋輥、硬模鑄造研磨材的工具、刀盤。
  11. This is a sandwich gasket, i. e. a sheet of asbestos between two sheets of copper, both these materials being able to withstand the high temperature and pressures within the engine

    這是一個夾層,即在兩片銅之間放一片石棉,這兩種材都能禁得住在發動機內的高溫和高壓。
  12. Wet - mixed bentonite liner and its application

    土工合成材膨潤土及其應用
  13. Trim materials. determination of linear speed of combustion

    .燃燒線性速度測定
  14. Preparation of steel substrates before application of paints and related products. test methods for metallic blast - cleaning abrasives. part 2 : determination of particle size distribution

    和相關產品應用前鋼的制備.金屬噴丸處理磨的試驗方法.第2部分:粒度分配的測定
  15. Brake linings - method for determining resistance to water, saline solution, oil and brake fluid of brake lining material

    制動.第5部分:制動的抗水抗鹽水溶液抗油和制動液性能的測定方法
  16. Standard test methods for transmitted shock characteristics of foam - in - place cushioning materials

    泡沫塑傳遞沖擊特性的標準試驗方法
  17. The technology is an advanced and high efficincy welding method which is introduced in ' 90, and welding linning is a kind of welding material accompanied with the technology introduction

    該工藝是九十年代從國外引進的一種先進的高效焊接工藝方式,焊接是伴隨引進的一種焊接材
  18. Standard test method for adhesion of gasket materials to metal surfaces

    粘結到金屬表面的粘附性的標準試驗方法
  19. Geomembranes - geomembrane lining systems - determination of puncture resistance to aggregates on a rigid support

    地膜.地膜系統.集在剛性支撐架上耐穿透性的測定
  20. Ropes, string, nets, tents, awnings, tarpaulins, sails, sacks and bags not included in other classes ; padding and stuffing materials except of rubber or plastics ; raw fibrous textile materials

    纜繩網帳篷遮篷防水遮布帆袋不屬別類者及填充橡膠或塑者除外,紡織用纖維原
分享友人