襯管接頭 的英文怎麼說

中文拼音 [chènguǎnjiētóu]
襯管接頭 英文
liner adapter
  • 襯 : Ⅰ動詞1 （在裏面托上一層） line; place sth underneath 2 （陪襯; 襯托） set off Ⅱ名詞（襯在裏面的附...
  • 管 : Ⅰ名詞1 （管子） pipe; tube 2 （吹奏的樂器） wind musical instrument 3 （形狀似管的電器件） valve;...
  • 接 : Ⅰ動詞1 （靠近;接觸） come into contact with; come close to 2 （連接; 使連接） connect; join; put ...
  • 接頭 : 1 （連接起來） connect; join; joint 2 （找人聯系） contact; get in touch with; meet 3 （了解情況...
  1. Xintian enterprise corp. now manufactures and sells dn15 - dn400 welding galvanized steel pipe with pe lining, seamless galvanized steel pipe with pe lining, galvanized steel pipe with pe lining and outer coating, galvanized steel pipe with stainless steel lining, malleable iron fittings with pp lining, stainless steel fittings, grooved couplings, hubbed screwed steel pipe flanges with pe lining, integral steel pipe flanges with flat face and pe lining, and so on

    我公司目前生產和銷售dn15dn500襯塑復合焊接鋼管襯塑復合無縫鋼管內復不銹鋼凈水管襯塑瑪鋼管件不銹鋼管件溝漕式管接頭襯塑帶頸螺紋法藍襯塑平面整體鋼制管法藍鋼管外表面有鍍鋅的也有外表面包塑的。
  2. Segment joint stiffness k ( subscript ) is an important parameter for the design of shield tunnel segment

    摘要盾構管片接頭彎曲剛度k （下標）是盾構襯砌結構計算中的一個重要參數。
  3. Application of cement mortar lining for cast iron pipes, steel pipes and fittings

    鑄鐵管鋼管和管接頭的水泥砂漿管襯料的應用
  4. Compression couplings with spherical liner ; equal tees

    帶球形襯的壓接管接頭.等長度三通連接管
  5. Compression couplings with spherical liner ; equal elbows

    帶球形襯的壓接管接頭.等長度彎管
  6. Compression couplings with spherical liner ; equal crosses

    帶球形襯的壓接管接頭.等長度四通連接管
  7. Compression fittings with spherical liners ; adaptars for welding

    帶球形襯的壓接管接頭.焊接轉接器
  8. Compression couplings with spherical liner ; male studed banjo bolts for ring type nipples

    帶球形襯的壓接管接頭.環形套管的插樁式鼓形螺栓
  9. Rubber lining for pipe connector

    水管接頭橡膠襯墊
  10. 1. under the same kind of wall rock and the same condition, displacement of pipe liner is symmetry, for tunnel structure and suffered load are symmetry. as level terra stress is bigger, the maximum of displacement and the first main stress occur in tie - in of pipe liner structure, and its direction is radial and points in hole ; the direction of the third main stress is annular and its maximum occurs in top and bottom hole inner

    1 、同一類圍巖在同一種工況下，由於結構和荷載的對稱性，管片襯砌結構的位移也表現出對稱性，因水平向地應力較大，位移最大值、第一主應力的最大值發生在管片襯砌結構的接頭處，方向為徑向指向洞內；第三主應力的方向為環向，較大值發生在洞頂和洞底內側。
  11. The ceramic - lined steel composite pipes can be easily connected by welding, or with flanges and soft easy connectors

    陶瓷內襯復合鋼管可採用焊接、法蘭、柔性快速接頭等聯結方式，安裝十分方便。
  12. Standard specification for vitrified clay pipe and joints for use in microtunneling, sliplining, pipe bursting, and tunnels

    微型隧道工程滑動內襯管子爆裂及隧道中使用的釉面陶土管和接頭的標準規范
  13. Pe lining steel pipe is currently most popular and widely used in big cities of china, made of hot dipped galvanized steel pipe bonded with the inner layer of pe pipe under high temperature and pressure, the outer layer of steel pipe can be coated with pe also, which shall be connected by malleable iron fittings with pp lining, outer layer could be coated with epoxy

    公司目前生產和銷售dn15 - dn600襯塑復合鋼管內襯外覆塑鋼管內復不銹鋼凈水管襯塑瑪鋼管件不銹鋼管件溝槽式管接頭襯塑帶頸螺紋法蘭襯塑平面整體法蘭等產品，並可按用戶要求生產特殊規格的襯塑復合鋼管內襯外覆塑鋼管內復不銹鋼凈水管及管件。
  14. Using mathematic analysis method analyses the different tie - in " computation mode of fabricated lining railway tunnel. the thesis studies the contents as follows : amended rigidity method can simulate the mechanism by changing the rigidity coefficient, but it is difficult to choose the rigidity coefficients

    本文用數值分析的手段，對裝配式襯砌不同的接頭計算模式分別進行了有限元分析，主要內容如下： （ 1 ）修正剛度法可以通過改變管片接頭處的剛度折減系數來很好的模擬接頭的受力機理，但是剛度折減系數的選擇無疑是很難的。
  15. But displacement relatively value of pipe liner structure is very smallness, the tie - in of pipe liner would not move and come away. and it is bigger that the level displacement value of substrate tie - in of pipe liner than upper

    而管片襯砌結構的位移的相對值卻非常小，不會發生錯動和脫開，且管片襯砌結構接頭處的下管片較上管片的水平位移值稍大。
  16. Compression fittings with spherical liners - adapters for brazing

    帶球襯的壓合接頭.釬焊用管接頭
分享友人
分享到 Line

分享到臉書