角位對位孔 的英文怎麼說

中文拼音 [jiǎowèiduìwèikǒng]
角位對位孔 英文
corner reg. hole
  • 角 : 角Ⅰ名詞1 （牛、羊、 鹿等頭上長出的堅硬的東西） horn 2 （古時軍中吹的樂器） bugle; horn 3 （形狀像...
  • 位 : Ⅰ名詞1 （所在或所佔的地方） place; location 2 （職位; 地位） position; post; status 3 （特指皇帝...
  • 對 : Ⅰ動詞1 （回答） answer; reply 2 （對待; 對付） treat; cope with; counter 3 （朝; 向; 面對） be tr...
  1. Secondly, programmed the image processing arithmetic code which include the bottom arithmetic for the general condition comprises threshold division, region combination and informate and the middle level arithmetic for the given task comprises detecting the line dation creirection according to the hough transform in order to fix on the hole ’ s azimuth angle, detecting the aiguille tip position according to the image movement according to the environment and the image format

    然後，根據目標環境要求和攝像機採集圖像格式，開發了圖像處理演算法程序。圖像處理演算法包括底層演算法和中層演算法兩部分，底層演算法針對通用情況，包括閾值分割、區域合併和信息生成。中層演算法針對具體任務設計，包括利用hough變換檢測棱線的方向，從而確定圓孔的方位角和利用基於圖像運動檢測鉆頭尖端位置。
  2. Kongxi buried hill shows following features in the seismic profiles : the structures are asymmetric. there is flexural syncline on the east side and a monocline on the west side. asymmetric repetition of stratigraphic units is present in the drill wells and the dips of beds and faults are gentle. the permo - carboniferous system of both sides almost lie in the same slope and the events of cambrian or upper proterozoic are continuous from east to west. the phenomenas suggest that kongxi buried hill could be a thrust belt been traced which consists of reverse faults. the imbricate faults mainly effect pre - jurassic strata. there are obvious angular unconformity between jurassic - cretaceous system and paleozoic involved deformation of thrust. the thrust front in some place has cut off the beds of jurassic - cretaceous system. the structural style of the thrust structure changes along the strike of the kongxi buried hill

    地震和鉆井資料揭露的孔西構造帶前第三系潛山的地質特徵可以歸納為：構造帶總體上不對稱構造帶內部有地層重復現象石炭二疊系地層的位置明顯高於兩側的同一地層的高度。用由34條向東傾斜的逆沖斷層組成的疊瓦扇構造模式能夠比較合理地解釋上述地質特徵。該帶向東傾斜的逆沖疊瓦狀斷層組主要影響前侏羅系地層，侏羅白堊系與捲入逆沖構造變形的古生界地層之間有明顯的角度不整合。
  3. The shm ( single hole microblowing ) as a new perturbation active control technique has been applied to the slender body with different model noses at zero sideslip and high angle of attack

    摘要在亞臨界流動范圍內，對具有不同頭部形狀的尖拱形細長旋成體在無側滑大迎角下進行單孔位微吹氣擾動控制實驗。
  4. The position and size of the monochromator, focusing curvature radii and tilting angles of the germanium focusing monochromator under different different take - off angle, size and divergency of the second collimator and intensity loss due to the use of it were determined. the neutron flux at different wavelength, under different reflection and take - off angle of the monochromator and divergency of the first collimator, were given. the simulation on the aperture used for limiting beam size in front of the sample showed that, smaller the size of the aperture and further the distance from the aperture to the sample, greater the loss of the intensity and more serious the spread of the beam along vertical direction at the sample position which makes the practical sampling volume greater than expected

    用蒙特卡羅模擬方法對中子應力衍射譜儀的設計方案進行了優化研究，提出了一系列可供參考的數據：確定了單色器的位置、尺寸、垂直聚焦單色器在不同起飛角下的聚焦曲率半徑和傾角；討論了第二準直器的尺寸和發散，以及使用第二準直器造成的強度損失；給出了在不同單色器反射面、起飛角、中子波長和第一準直器發散度的情況下樣品處的中子注量率，以及多種組合情況下譜儀的解析度曲線；對限束方孔的尺寸、距離樣品遠近對強度損失和測量中的影響做了深入研究。
  5. The research result indicated : for the strip primary mirror discussed in this article, the hexagon light - weighted cell has the best structural rigidity quality, the square cell is a little worse, the triangle cell is the worst ; there is an optimum on primary mirror thickness ; on condition of 1g gravity load combining with 4 centigrade uniform temperature rising, the thinner and higher of the flexible support reed, the better of the primary mirror surface figure. the decision of the structural parameters of the flexible support reed must take static rigidity, dynamic rigidity, static strength and dynamic strength of primary mirror assembly into account

    研究結果表明：對于本文的長圓形主鏡，採用正六邊形輕量化孔，鏡體結構剛性品質最好，正方形次之，正三角形最差；主鏡鏡體厚度存在最佳值；主鏡組件在1g重力、均勻溫升4共同作用的工況下，主鏡柔性支撐簧片厚度越小、高度越高，主鏡綜合面形誤差（ p - v值）越小，但同時主鏡組件的剛體位移增大、固有頻率下降，因此柔性支承結構參數的確定要綜合考慮主鏡的綜合面形誤差和主鏡組件靜態剛度、動態剛度、靜態強度和動態強度等因素。
  6. The measurements of discharge coefficients and pressure coefficients along the models with aspect ratios of 0. 5, 1. 0 and 2. 0 were carried out under various aerodynamic and geometric parameters ( reynolds numbers : 20000, 40000, 60000, 80000 ; suction rates : 0. 3, 0. 45 and 0. 6 ; rib angles : 45, 60, 90, 120 ; rib height - to - width ratio h / e : 1. 0 and 2. 0 ; film hole location : middle of ribs. upstream of ribs and downstream of ribs ). based on the abundant experimental data and figures, rules of discharge coefficients and pressure coefficients in dependence of geometric and aerodynamic parameters were given out

    根據實驗課題的要求，在寬高比分別為1 . 0 、 2 . 0和0 . 5的內流冷卻通道里，在不同的氣動和幾何參數（雷諾數re分別為20000 、 40000 、 60000 、 80000 ，出流比sr為0 . 3 、 0 . 45和0 . 6 ，肋角分別為45 、 60 、 90 、 120 ，肋高h e分別為1 . 0和2 . 0 ，孔位分別為肋中間、肋下游和肋上游）的情況下，對流量系數和壓力系數以及流場進行了實驗研究，獲得了大量的實驗數據和圖形，較為詳細地給出了流量系數和壓力系數隨不同氣動參數和幾何參數而變化的規律。
  7. On the other hand for four main vegetation typies, which are picea crassifolia, forests sabina przewalskii forests, bushes and pastureland, whose soil permeability function was analyzed from angle of its physics, capacity of water, storing water in it. the results show as follow : permeability function of soil is controlled by quality of soil hole. the quality and quantity of soil hole under picea crassifolia forests are the best, and the permeability also is the best

    另外，從土壤物理性質、蓄水量、貯水量等角度對祁連山苔蘚雲杉林、祁連圓柏林、亞高山灌叢林、牧坡草地4種主要植被類型的土壤滲透功能進行分析，結果表明：土壤的滲透功能主要由土壤非毛管孔隙度的質和量決定的，苔蘚雲杉林土壤非毛管孔隙度的質和量最好，它的滲透也最好；雖然亞高山灌叢林的滲透功能次之，但由於它所處的位置和面積大，現實貯水量在祁連山四種主要植被類型中最大。
  8. Using the eye - gaze distinguishing and tracking method based on the image processing technique, the position relationship between pupil center and glint which produced by the corneal reflection and the near - infrared light was analyzed, the fixation point of the eye - gaze on display screen was deduced, and the mouse accuracy by eye - controlled in the screen may achieve to 40 pixels

    摘要利用基於圖像處理技術的視線方向識別、跟蹤方法，通過近紅外光線在眼睛角膜反射產生的光斑和瞳孔中心的位置關系來確定視線方向，推導出人眼在計算機屏幕上的注視點，進而實現人眼對鼠標的定位與操作，其在顯示屏上定位精度可達到40 40像素。
  9. A new angular superresolution technique called angle weighting superresolution method ( awsm ) is proposed

    針對實孔徑天線的特點，提出了角度權重方位超分辨法。
  10. It can be used not only to infer position of the magnetic body relative to the drill hole but also to make quantitative - semi - quantitative calculation and inverse interpretation and calculation of the distance and depth from head or tail of ore bodies to the known drill hole at surface by rotating an angle so as to design drilling depth, dip angle and orientation of the next drill hole

    其作用不僅可以判斷磁性體相對于鉆孔的位置，而且可以進行定量和半定量計算，以及經旋轉一角度採用地面方法作反演解釋，計算礦體頭部或尾部距已知鉆孔的距離、深度，設計下一鉆孔的深度、頂角、方位角。
  11. The analyses indicate that the shm ' s control ability has strong adaptability to various slender body at high angles of attack, and its control ability is determined by the original state of the flowfield around the slender body

    實驗分析表明，單孔位微吹氣擾動這一大迎角非對稱控制手段具有較強的適應能力，其控制能力的大小則由該頭部形狀的初始狀態決定。
  12. Adopting the sectionalized lumped parameter method with dynamic friction, the dynamic performances of the typical segments in lineweb, i. e. short channels, rectangular elbows, forked channel, chamber of additional holes, are analyzed using the effective approach - power bond graph ( pbg ). thus the pbg model of lineweb with the sectionalized lumped parameter method i : ; iii established. this model is proven by digital simulation and physical experiment

    作為校驗線網性能約束的后續環節，本文引入包含動態摩擦的管路分段集中參數鍵合圖模型，對集成塊線網中存在的短管、直角拐彎、分支管路、工藝孔容腔等典型結構進行分析，建立起具有典型結構的線網的分段集中參數鍵合圖模型，並通過數字模擬和物理實驗得到驗大連理工大學博士學位論文證。
分享友人
分享到 Line

分享到臉書