角接取壓 的英文怎麼說
中文拼音 [jiǎojiēqǔyā]
角接取壓
英文
corner taps-
However, df pre - processing is not required in a interferometer direction finder. it only makes use of the phase relations or differences of sensors disposed at different position. azimuth and elevation are caculated from the phase differences or displayed directly on a crt drived by the voltage or current from the phase differences
干涉儀測向不必進行測向信號預處理而是直接或間接求取在空間上分開的傳感器上感應電勢之間的相位關系,即干涉相位差,方位角或仰角是直接由干涉相位差計算得到,或將兩基線正交的天線陣的干涉相位差轉化為驅動電壓(電流)分別加到crt陰極顯示器的垂直偏轉線圈和水平偏轉線圈,模擬顯示出來波方位,干涉儀測向為典型的相位測向方法。In this paper, the preparing technological parameters, formation mechanism and structures of ( lithium ) vanadium oxides ( nanocrystalline vo2, amorphous v2o5, layered li1 + xv3o8 and inverse spinel linivo4 ) are systematically studied and discussed, and some properties of the products are measured as cathode materials for lithium ion batteries. the main results are as follows : ( 1 ) nanocrystalline vo2 has been successfully synthesized by a solution chemical reaction method in normal temperature and pressure. the procedure involves v2o5 reacts with koh to form k3vo3 in water and then k3vo3 is reduced with kbh4 around ph = 4 forming vo2 precipitation in aqueous
本文從實驗與理論分析相結合的角度對(鋰)釩氧化物(納米vo _ 2 、非晶態v _ 2o _ 5 、層狀li _ ( 1 + x ) v _ 3o _ 8及反尖晶石型linivo _ 4 )制備過程中工藝參數、結構和形成機理等方面進行了系統深入的研究,對(鋰)釩氧化物電性能進行了初步測試,取得的主要結果如下: ( 1 )成功的在常溫常壓下通過溶液化學反應直接制得具有納米結構的vo _ 2粉。The formula for mach number has been optimized with least - squres solution, thus the precision of a polynomial of power of 5 is better than that of 9. 2. after the solving of angle of attack and angle of sideslip, the theory of general inverse of matrix is used to simplify the nonlinear equations and to calculate the total pressure and the modified dynamic pressure ratio. these two parameters together with the angle of attack and angle of sideslip contain enough information to work out the dynamic pressure and static pressure
其中包括: 1 .應用最小二乘法,對馬赫數的泰勒求解公式進行優化,優化后的求解公式採用5次多項式即可在精度上優于原有的9次多項式,可以提高運算速度; 2 .提出應用廣義逆矩陣簡化非線性方程組:在已經求解出迎角與側滑角的前提下,直接從原始的壓力向量中提取出總壓,並且提出了動壓修正比的概念。
分享友人