解聚 的英文怎麼說

中文拼音 [jiě]
解聚 英文
[化學] depolymerization; depolymerize解聚劑 depolymerizing agent; 解聚酶 depolymerase
  • : 解動詞(解送) send under guard
  • : 動詞(聚集; 聚積) assemble; gather; get together
  1. Water treatment chemicals - hydrolyzed polymaleic anhydride

    水處理劑水解聚馬來酸酐
  2. Biological catabolic mechanism and structural features of biological catabolic polymer are surveyed in this paper. biological catabolic two - stroke oils are outlined. the prospect of application of biological catabolic polymer in engine oils is explained

    本文綜述了生物降機理和生物降解聚合物的結構特徵,以及生物降二沖程油的概況,闡述了生物降解聚合物在發動機油料方面的應用前景。
  3. When the cells synchronized at a late cytokinesis stage were treated with w7, the dissolving of the midbody was delayed ; furthermore, we found that the dissociation of y - tubulin from the midbody was also inhibited

    W7處理同步化在胞質分裂後期的細胞,不但使中體解聚發生延遲,而且抑制了y一微管蛋白與中體的離。
  4. This type of degradation is also called depolymerization.

    這類降也可稱作解聚合。
  5. Php partially hydrolyzed polyacrylamide c

    部分水解聚丙烯酰胺
  6. Study on biodegradation of partially hydrolyzed polyacrylamide

    部分水解聚丙烯酰胺生物降的初步研究
  7. Phpa partially hydrolyzed polyacrylamide

    部分水解聚丙烯酰胺
  8. ( 2 ) the reaction factors optimized by orthogonal tests are : the emulsion polymerization temperature is 60, the reaction time is 3 hours, the amount of emulsifier is 8wt %, the hydrophile lipophile balance ( hlb ) value of emulsifier is 15, the stirring speed is 4000r / min, the dropping speed is 1. 1g / min

    用正交實驗確定的最佳合反應工藝參數為:水溫度60 ,水解聚合時間3h ,乳化劑用量8wt ,復合乳化劑hlb值為15 ;攪拌速度為4000r min ,滴加速度為1 . 1g min 。
  9. The higher concentration of extracellular calcium could influent the stability of microtubules in protoplast. mts in the protoplasts would depolymerize when the extracellular calcium concentration was rising up to lommoi / l. the intercellular washing fluid ( iwf ) of wheat - leaf rust fungus interaction which contains elicitor were used as stimulator to interact with the protoplast of cv

    試驗結果表明,在小麥葉肉細胞原生質體中,微管骨架呈網路狀分佈於整個細胞質中;胞外較高的ca ~ ( 2 + )濃度對微管骨架的穩定性有影響,在本試驗系統中當胞外ca ~ ( 2 + )達到10mmol / l時,微管骨架即開始發生解聚
  10. Mechanistic study of the hydrolytic oligomerization of - aminopropyltriethyoxysilane and characterization of the products

    氨丙基倍半硅氧烷的水解聚合機理研究及產物結構表徵
  11. Degradation of polyethylene film by fe3 tio2 photocatalyst

    2光催化降解聚乙烯薄膜的研究
  12. This uncoiled condition is thought to facilitate transcription and probably indicates an area where genes are active

    解聚的狀態可以幫助轉錄的完成,預示著這個區域內的基因是活躍的。
  13. Through screening a lot of mutants with the method of transparent zones and culture filtrate, the best four were obtained with high - yield of stable phb depolymerase, named as 02, 04, 09 and 14

    以青黴( penicillium . sp ) ds9701為出發菌株,通過紫外線誘變分生孢子,採用透明圈初篩和搖瓶培養復篩的方法,獲得4個能穩定遺傳的phb解聚酶高產菌株。
  14. The md simulation data were analyzed in terms of average atomic positions, root mean square ( rms ) fluctuations, monomer - monomer interactions, hydrogen bond ( h - bond ) network, secondary structure, and so on. through the comparison, we found that when the system includes zn2 + ions and phenol, the stability of insulin hexamer is enhanced, but the conformational flexibility related to its biological activity is decreased. in addition, the insulin hexamer tends to dissociate in the absence of zn2 + and phenol

    通過對這兩個模擬所得到的軌跡在原子的平均位置、方均根漲落、方均根偏差、單體之間相互作用、氫鍵網路、二級結構等方面進行的比較分析發現,對于包含鋅離子和苯酚的體系,胰島素六體的穩定性得到了增強,但其構象柔性卻受到了削弱;對不含鋅離子和苯酚的體系,胰島素六體的穩定性明顯減弱,構象柔性卻表現得較為突出,在這種情況下,胰島素六體還表現出解聚的傾向。
  15. Rheological property of the aqueous solution of branched partly hydrolyzed polyacrylamide

    帶支鏈的部分水解聚丙烯酰胺溶液的流變性
  16. Standard test methods for rubber - evaluation of oil - extended solution br polybutadiene rubber

    加油溶解聚丁二烯橡膠評定的標準試驗方法
  17. A mixture of three amino acids ( arg, gly, glu ) labeled with fluorescein isothiocyanate ( fitc ) was separated in pdms microfluidic chip, the separation voltage is 200v / cm, the separation time is less than 120 seconds ; according to ccd fluorescence images, two distinct physical processes - stacking and destacking during sample injection were studied qualitatively ; rhodamine b, a kind of temperature - dependent fluorescence dye, was used as probe to develop a temperature - fluorescence intensity equation, then temperature - color map in microchannels was constructed, and temperature trait in microchannels on the pdms microfluidic chip was analysed. according to the results, we conclude that the electric field applied to the pdms microfluidic chip should not exceed 400v / cm

    利用pdms微流控晶元對fitc標記的精氨酸、甘氨酸、谷氨酸混合物進行了電泳分離,分離電壓為200v cm ,分離時間不到120秒;通過拍到的熒光顯微圖像對電泳注樣過程中復雜的樣品分子積解聚現象作定性的分析;以熒光染料rhodamineb為溫度熒光探針,建立了pdms微流控晶元上的溫度-熒光強度的關系公式,並利用matlab圖像處理工具箱構建出微流體溝道內的溫度色圖,對pdms微流控晶元的微流道溫度特性進行了分析,根據實驗結果,我們認為對于pdms微流控晶元來說,在進行需要外加電場作用的試驗時,外加電場不應超過400v cm 。
  18. As portions of the cell plate are completed, the microtubules again depolymerize.

    一旦細胞極安置完成,微管又再行解聚
  19. Study on vapor - phase depolymerization of dicyclopentadiene

    雙環戊二烯氣相解聚工藝的研究
  20. ( 3 ) prepare a series of solid superacid sample and use as catalyst in the synthesis of lactide to select the most active sample

    5小時,解聚反應終止溫度在230 - 240 ,粗產物的收率達到90 。
分享友人