解除負載 的英文怎麼說

中文拼音 [jiěchúfùzǎi]
解除負載 英文
uncharge
  • 解 : 解動詞（解送） send under guard
  • 除 : Ⅰ動詞1 （去掉） get rid of; eliminate; remove 2 [數學] （用一個數把另一個數分成若干等份） divide:...
  • 負 : Ⅰ名詞1 （負擔） burden; load 2 （虧損） loss 3 （失敗） defeat Ⅱ動詞1 [書面語] （背） carry on th...
  • 載 : 載Ⅰ名詞（年） year : 一年半載 six to twelve months; six months to a year; 三年五載 three to five ...
  • 解除 : remove; relieve; get rid of; secure; release; uncaging
  • 負載 : [電學] load
  1. Firstly, the basic theory of full - bridge phase - shift zvs pwm converters are expatiated and another three kinds of circuits of full - bridge phase - shift zvs pwm converters are discussed. there are four kinds of problems which are emphasized : how to expand the zvs range ; how to reduce the circulation in the primary side of the transformer in order to minimize the on state losses ; how to decrease the loss of effective duty circle and how to eliminate the parasitic oscillation of the output rectifiers

    本文首先分析了基本的全橋移相zvsdc dc變換器的工作原理，為解決滯后橋臂不易實現零電壓開關（ zvs ）的情況，討論了另外三種全橋移相zvsdc dc變換器的電路拓撲，重點分析並解決了四個方面的問題：如何擴大zvs的負載范圍；減小變壓器原邊環流，降低變換器系統通態損耗；減少變壓器次邊有效占空比丟失；消除輸出整流二極體的寄生振蕩。
  2. Carbon nanotubes were separately synthesized by a new pulsed laser ablation ( pla ) for in - situ growth method and cvd support method in this paper. ft - ir, uv - vis, xfs, laman, tem, xrd, bet methods were used to characterize the sol, carbon nanotube and other products in the experiment. in the pla method, the sols containing carbon nanotubes were successively obtained by using 1064nm pulsed laser to ablate the interface of fe / c, or ni / c targets and ethanol under common temperature and pressure, and then carbon nanotubes were directly acquired by evaporating the ethanol

    脈沖激光轟擊原位生長法是在常溫常壓下使用1064nm波長的脈沖激光轟擊目標靶與乙醇流動相的固液界面來連續制備含有碳納米管的溶膠，進而除去乙醇相得到碳納米管，其中目標靶為石墨與fe 、 ni等金屬催化劑混合壓製成的靶片； cvd基體法是使用自製的六方介孔mcm - 41多孔材料為基體，負載fe催化劑活性組分，通過cvd法催化裂解c2h2來生長碳納米管。
  3. The ups shuts down and will not transfer to the bypass mode when a short circuit occurs on output of the unit. after the short circuit being removed the ups will operate normally again. at short condiion, the fault led lights as a warning to end users

    當負載發生短路時，本系統自動關機，並不轉換至旁路，待短路解除后自動恢復供電，在短路情況，故障燈亮同時發出長鳴，警告使用者
分享友人
分享到 Line

分享到臉書