觸發發脈沖 的英文怎麼說

中文拼音 [chùfāfāmàichōng]
觸發發脈沖 英文
starting pulse
  • 觸 : Ⅰ動詞1 （接觸） touch; contact 2 （碰; 撞） strike; hit 3 （觸動） touch 4 （感動） move sb ; sti...
  • 發 : 名詞（頭發） hair
  • 脈 : 脈名詞1. （動脈和靜脈的統稱） arteries and veins2. （脈搏的簡稱） pulse 3. （像血管的組織; 連貫成系統的東西） vein
  • 觸發 : detonate by contact; touch off; trigger; strike
  1. From the sa node, electrical impulses spread through the heart muscle to trigger the heartbeat.

    從竇房石結出來的電脈沖傳播到心臟肌肉觸發心臟跳動。
  2. Magnetic sensors are an important branch that can be used to detect the non - electronically characteristics through the magnetic field. the insb magnetoresistance photoelectric sensor in this paper is designed for the fine measurement of the photosignal of the luminant device. through the sensor, the photo - pulse signal is changed to electric pulse which can provides to other second instruments

    通過磁場的無接觸特性，對非電量的測量是磁傳感器應用的一個重要方面，本文所研究的銻化銦磁阻型光電傳感器即是針對于發光物體的光脈沖信號進行高精度無接觸測量的一類傳感器，它可以把光脈沖信號轉換成電脈沖信號，供二次儀表使用。
  3. At the same time the principles of triggering pulse to the three - phase thyristors is discussed, and a way using monostable multivibrator to produce the pulses has been given below. the hardware control system based on tms320f240 is designed, which includes sampling circuit, protective circuit, phase - compensated circuit and so on

    對三相晶閘管控制電抗器的觸發脈沖產生原理進行了分析，採用單穩態觸發器實現六相觸發同步；設計了以tms320f240為控制核心的硬體控制平臺，包括采樣電路、保護電路、六相觸發同步等外圍電路。
  4. Scr direct - reverse zero - crossing control output d type

    Scr可控硅過零觸發脈沖輸出
  5. Scr zero crossing triggering pulse output

    Scr可控硅過零觸發脈沖輸出
  6. Silicon controlled rectifier control output - scr zero - acrossing trigger pulse output, ac 400 v 0. 5a

    可控硅控制輸出scr過零觸發脈沖輸出
  7. In the paper, on the basis of research of static state and transient state in the scr and series connection valve circuit, the high voltage scr changing current valve device has been developed for ac - dc - ac high voltage commutatorless motor. the series connection valve circuit has been designed and simulated. the hardware design and software programming of trigger pulse system and monitoring system in the photo - electronic - photo fashion has been completed

    無換向器電動機在火電廠等工礦企業的電機調速節能領域中有十分廣闊的應用前景，本文在對晶閘管元件和串聯閥電路的靜態特性和動態特性研究的基礎上，研製了用於交直交電流型高壓無換向器電動機的高壓晶閘管換流閥裝置，進行了串聯閥電路的設計和模擬，完成了電光電方式的觸發脈沖系統和監測系統硬體設計及軟體編程，並進行了裝置的實驗調試。
  8. The counter output, which represents a binary number, decreases by 1 any time the counter is triggered by a pulse.

    每當計數器被時鐘脈沖觸發一次時，計數器輸出的二進制數便累減1。
  9. Thus, space - charge field in excitated photoconductor can intensity influence not only the shape of photo - electric current of pcss ' s, but also the terahertz out put of photoconducting antenna. in this paper, the forming and movement of space - charge field are simulated by means of fdtd method

    觸發條件下光電導體內部電場不僅顯著的影響光電導開關產生超快電脈沖的功率、波形，而且對thz偶極天線的輻射功率也有明顯的影響。
  10. The technology of alternating - current - boosting by way of constant current is successfully used to charge capacitors with 25 kilojoules of energy in only eight seconds. rail - gap switch with performances of long life and highly steady state are designed. and the high voltage pulse generator, which can produce low - excursion and fast - rise pulses, are designed by using double trigger circuit and hydro - thyristor as switch

    在大功率恆流充電技術上，成功的應用了交流調壓式恆流技術，可以在8s內讓電容器儲存25kj的能量;設計出了長壽命、高穩定的軌道開關;採用氫閘流管做開關，使用雙觸發電路，研製出了低抖動、快前沿的高壓脈沖發生器（點火機） ;採用單片機和pld ，研製出了精度為10ns的延時同步機。
  11. The counter output, which represents a binary number, decreases by 1 any time the counter is triggered by a pulse

    每當計數器被時鐘脈沖觸發一次時，計數器輸出的二進制數便累減1 。
  12. This dissertation majorly researchs and designs full digital dc driving system with fuzzy control. it makes a scheme argumentation firstly, analyzing the pid algorithm and fuzzy control algorithm the ordinary digital pulse trigger algorithm and the double remainder method of pulse trigger in detail, and fuzzy control and the double remainder method are put forward to settle the under - mentioned problems, namely, the new viewpoint and the task having finished in this dissertation as follows : ( 1 ) in rder to overcome the influence of dc motor ' s parameter changing with time and nonlinear on the control system performance, this dissertation adopts fuzzy control as outside regulator and pi control as inside regulator in double regulators of the full digital dc motor driving system design ;. ( 2 ) aiming at the pulse trigger reliability of the ordinary d igital pulse trigger being low and leaking the pulse or the order of pulse confusion, this paper adopts the double remainder algorithm with short response time high pulse trigger reliability good adaptability and anti - jamming ; ( 3 ) this dissertation adopts tms320lf2407 which has good performance as major control chip this chip has power function with fast calculation capability, and accomplishes the software and hardware design in the dc motor driving system with fuzzy control ; ( 4 ) this dissertation also puts emphases on anti - jamming in hardware and software ; ( 5 ) after having designed the sample of full digital dc motor driving system with fuzzy control, a lot of experiments are performed to verify the performance and settles problems during experiment. the result of experiment proves the feasibility of design

    首先進行了方案論證，對模糊控制演算法和數字pid調節演算法、觸發脈沖的一般演算法和雙余演算法進行了詳細地研究分析，提出應用模糊控制和雙余法解決下述問題，即該論文主要的新見解和所完成的工作： （ 1 ）為了克服直流電機參數時變性和非線性因素對控制性能的影響，本設計中，雙閉環調速系統的外環採用模糊控制，內環採用pi控制，使系統在一定范圍內對直流電機參數變化和非線性因素影響有自適應能力； （ 2 ）針對常規數字觸發器演算法中觸發脈沖的可靠性不高，經常出現漏脈沖或是脈沖混亂的情況，本文採用雙余法，該演算法具有響應快，可靠性高，具有良好的適應性及抗干擾能力； （ 3 ）本設計中採用了速度快、功能強的tms320lf2407作為系統的主控晶元，應用該晶元完成系統的軟硬體設計： （ 4 ）本文對系統抗干擾的軟硬體措施進行了重點研究； （ 5 ）設計了具有模糊控制的全數字直流傳動系統原理樣機，並進行了試驗驗證，對試驗過程中出現的問題及時解決，最終實驗結果證明設計是可行的。
  13. According to the requirements of static compensator ( statcom ) to triggering pulse generator, an autonomous triggering system for statcom was developed based on complex programmable logic device ( cpld )

    針對靜止無功補償器（ statcom ）對觸發脈沖發生電路的要求，利用復雜可編程邏輯器件（ cpld ）開發了一種自治型statcom觸發系統。
  14. By analyzing the equivalent circuit of statcom, the basic requirements to the triggering system was pointed out, and the cpld - based functional structure for triggering pulse generator was established

    通過對statcom工作原理與等效電路的分析，指出了statcom對其觸發系統的基本要求，建立了基於cpld的觸發脈沖發生電路的功能邏輯結構。
  15. The system is composed of parallel microprocessor interface, spwm generator, deadtime compensation module and pulse blocking module. the pwm pulse signal is automatically generated as soon as the control variables ( s, x ) input from microprocessor

    該系統由并行微處理器介面、 spwm脈沖發生模塊、死區補償模塊和脈沖封鎖模塊組成，可以按照微處理器給定的控制變量、自行產生觸發脈沖。
  16. Contactless impulse generator

    無觸點脈沖發生器
  17. With the mathematic model of tracking beam current by velocity, real - time tracking can be obtained ; with current simulation controlling transducer and subsection linearity, precision of velocity ( error in ? 1 % ) is triumphantly can be controlled ; with inspection of the pulse numbers of switches, the position of all vehicles are checked to eliminate the error of calculating distance between all ones

    通過建立速度跟蹤束流的數學模型，較好地解決了速度跟蹤束流的實時性問題;通過採取用電流模擬量控制變頻器和分段線性處理的辦法，成功地解決了速度精度問題（誤差在士1 %內） ;通過檢測接近開關觸發的脈沖數，適時校核所有小車位置，消除各車之間距離計算誤差，從而很好地解決了距離累計計算誤差。
  18. The main circuit is consisted of 18 thyristors circuit and protection circuit. with the help of control subsystem, it can get the output of low frequency voltage ( current ) with the shape of sine wave ; the core of the control subsystem is the cpu of 87c196kc, and the synchronization circuit, the pulse - widen circuit, and the power - enlarged circuit form the accessorial subsystem of the control system. it possesses all the functions of digital triggering, digital tuning, analog / digital conversion ; the input transfer can isolate the input and output ; and the circumfluence reactor can reduce the circumfluence

    主迴路採用由18個晶閘管組成的三相零式電路，並輔以晶閘管的保護電路，通過控制可以得到低頻正弦波的電壓（電流）輸出；控制迴路主要以87c196kccpu為核心，其外圍電路包括同步電路，脈沖拓寬電路，功率放大驅動電路等，完成了數字觸發、數字調節、模數轉換等功能；進線電源變壓器具有變壓和隔離作用；環流電抗器則實現了有效抑制主迴路瞬時脈動環流的功能。
  19. Trigger gate delay

    觸發門脈沖延遲
  20. When the triggering light goes, the avalanche impact ionization and recombination radiation in the domain result in the formation of the carriers " conductive channel in the body of the devices and control the current of the lock - on switching

    當觸發光脈沖消失后，單極電荷疇內雪崩電離和輻射復合在開關體內形成了載流子高導電通道，成為了載流子倍增的源泉，控制著lock - on電流。
分享友人
分享到 Line

分享到臉書