觸簧接點 的英文怎麼說

中文拼音 [chùhuángjiēdiǎn]
觸簧接點 英文
formed whisker contact
  • 觸 : Ⅰ動詞1 （接觸） touch; contact 2 （碰; 撞） strike; hit 3 （觸動） touch 4 （感動） move sb ; sti...
  • 簧 : 名詞1. [音樂] （樂器里能發聲的薄片） reed2. （器物上有彈力的機件） spring
  • 接 : Ⅰ動詞1 （靠近;接觸） come into contact with; come close to 2 （連接; 使連接） connect; join; put ...
  • 點 : Ⅰ名詞1 （液體的小滴） drop （of liquid） 2 （細小的痕跡） spot; dot; speck 3 （漢字的筆畫「、」）...
  • 接點 : （接觸點; 連接點） contact; closing; junction; connection point; terminal pad接點電阻 contact resistance
  1. Iv ) revolute joint element, nonlinear spring - damper element, 3 - d 5 points contact element are applied to simulate the revolute restriction between two caterpillar boards, suspension nonlinear vibration, contact between wheels and caterpillar boards, and contact between caterpillar boards and ground are considered respectively. drucker - prager material is employed to simulate reinforced concrete

    4 、應用大幅度轉動約束單元、非線性彈簧阻尼單元、三維五節點接觸單元分別模擬自行火炮履帶板之間的轉動約束連接、懸掛非線性振動及負重輪與履帶板之間的接觸和履帶板與地面的接觸問題；根據材料非線性理論，提出利用drucker ? prager材料建立土壤的非線性有限元模型。
  2. Detail specification for the interface of the 1. 27 - mm pitch, ribbon contact leaf spring trapezoidal shaped, self - locking i o connector

    1 . 27mm間距帶狀觸點片簧梯形自鎖式i o連接器介面的詳細規范
  3. In bimetallic thermostats a so - called snap - disc is used as a contact spring ; a fixed temperature switching point can be adjusted via the combination of materials, form and length

    在雙金屬溫度調節器中，一個所謂的速動盤作為接觸彈簧一個固定的溫度開關點則可以通過結合材料，形狀和長度進行調整。
  4. In bimetallic thermostats a so - called snap - disc is used as a contact spring ; a fixed temperature switching point can be adjusted via the combination of materials, form and length. the hysteresis is fixed, the switching and reset points are identical

    在雙金屬片自動調溫器中一個所謂的速動盤用作接觸彈簧通過材料型狀和長度的組合可以調整到一個合適的固定的溫度開關點滯後作用是固定的，開關和恢復點是固定的。
  5. The author advances that the shear connector is simulated by two spring elements, which are vertical to each other and parallel to the interface between steel and concrete, and one multipoint constraint element, mpc element, which is vertical to the interface. the author also puts forward that the crack of the deck is simulated by the gap element which ca n ' t support longitudinal tensile force but can support longitudinal compressive force

    提出了以正交的兩個平行於鋼和混凝土界面的彈簧單元及一個垂直於界面的多點約束（ mpc ）單元來模擬剪力鍵，以小間隙接觸（ gap ）單元來模擬混凝土橋面板的開裂，模型中忽略了混凝土板與鋼梁接觸面間由摩阻而產生的粘著力。
  6. The mercury wicks up the reed and wets the contacts, providing a perpetually self - renewing contact surface

    水銀沿簧片滲透並沾濕觸點，形成一層永久性自更新接觸表面。
  7. The connection mechanism which is driven by sma was designed. different electrical connectors were used in different modules. the fixed electrical connector was used in the active module and the spring electrical connector was used in the passive module

    設計了一種由sma驅動器驅動的機械式連接機構;在主動模塊和被動模塊上分別使用了固定式觸點和彈簧觸點作為線路連接部件。
  8. And the displacement control of the leaf spring center was transferred to the displacement at load point. then after the load step options configuration, the leaf spring stress circulation under cycle loadings was calculated. the model was validated by the result compare between the rigid extracted from the simulation results and the one out of the rigid test of the leaf spring

    使用加載頭和簧片的接觸行為來模擬加載狀況，並將對簧片中心的變形控制轉換為對加載點的位移約束，然後利用載荷步選項配置完成一個載荷循環，由此計算出加載階段下鋼板彈簧內部的應力循環。
  9. Because of the sliding at the loading node, this special loading condition can be simulated by contact between the loading head and leaf spring

    並且採用加載頭和簧片間的接觸行為能較準確的模擬出加載點存在著滑移狀況的這種特殊的加載形式。
  10. The switch is made from two thin, flat strips of ferromagnetic material called reeds, with contacts on the overlapping ends

    開關是由兩個扁平的磁性材料薄片組成的，這兩個薄片被稱為簧片，觸點位於簧片上相互搭接的一端。
分享友人
分享到 Line

分享到臉書