觸點調整器的英文怎麼說

中文拼音 [chùdiǎndiàozhěng]
觸點調整器英文
contact adjuster

  • : Ⅰ動詞1 (接觸) touch; contact 2 (碰; 撞) strike; hit 3 (觸動) touch 4 (感動) move sb ; sti...
  • : Ⅰ名詞1 (液體的小滴) drop (of liquid) 2 (細小的痕跡) spot; dot; speck 3 (漢字的筆畫「、」)...
  • 調: Ⅰ動詞1 (配合得均勻合適) harmonize; suit well; fit in perfectly 2 (使配合得均勻合適) mix; adju...
  • : Ⅰ形容詞1 (全部在內; 完整) whole; all; complete 2 (整齊) neat; tidy; orderly Ⅱ動詞1 (整理; 整...
  • : 名詞1. (器具) implement; utensil; ware 2. (器官) organ 3. (度量; 才能) capacity; talent 4. (姓氏) a surname
  • 調整: adjust; tune up; trim; trimming; variation; modulation; arrangement; debug; rectification; redres...

※中文詞彙觸點調整器在字典百科國語字典中的解釋。

  1. Chain adjusters and crank cotter pins for bicycles

    自行車鏈調和曲柄扁銷
  2. In the self - calibration scheme, the thesis emphasizes the accuracy of camera intrinsic and extrinsic parameters. we presents an accurate f method based on corresponding point adjustment. the method adjusts coresponding points according to the fixedness of projective transformed cross ratio, then calculates f matrix accurately through linear and non - linear methods. when computing intrinsic parameter, a matrix, we simplify the step, and stress on the two important parameters of a. the result will be getten through solving kruppa equation based on svd decomposition. in order to compute extrinsic parameters, we use linear method to get initial r and t, then apply non - linear method to accurate them

    提出了基於匹配調的f求精方法,先根據攝影交比不見性對手工選擇的匹配進行調,再用線性、非線性結合的方法求精f矩陣;在計算內部參數a中,進行了一定的簡化,把重心放在a中重要的兩個參數上,用svd分解法計算kruppa方程;在計算外部參數時,首先用線性法求解r 、 t ,然後再用非線性法迭代求精。
  3. Step 3 : center your primary mirror ' s sweet spot in the eyepiece ' s field of view

    把主鏡的甜調到目鏡視場中。
  4. Undershoot undershoot refers to the amount by which voltage or frequency drops below the nominal value as the voltage regulator or governor responds to changes in load

    下超調下超調指電壓調或控制在應對負荷變化時,電壓或頻率低於額定的量。
  5. Application of one - chip computer control thyristor and replacing combination for timing compensation adjustment enable it to realize fast non - contact adjustment

    採用單片機控制晶閘管,切換組合進行適時補償調節,實現了快速無調節。
分享友人