計數取樣檢驗 的英文怎麼說

中文拼音 [shǔyàngjiǎnyàn]
計數取樣檢驗 英文
sampling inspection by attribute
  • : Ⅰ動詞1 (計算) count; compute; calculate; number 2 (設想; 打算) plan; plot Ⅱ名詞1 (測量或計算...
  • : 數副詞(屢次) frequently; repeatedly
  • : Ⅰ動詞1 (拿到身邊) take; get; fetch 2 (得到; 招致) aim at; seek 3 (採取; 選取) adopt; assume...
  • : Ⅰ名詞1. (形狀) appearance; shape 2. (樣品) sample; model; pattern Ⅱ量詞(表示事物的種類) kind; type
  • : Ⅰ動詞1 (查) check up; inspect; examine 2 (約束; 檢點) restrain oneself; be careful in one s c...
  • : 動詞1. (察看; 查考) examine; check; test 2. (產生預期的效果) prove effective; produce the expected result
  • 計數 : count; tally; counting計數卡 numbered card
  • 檢驗 : checkout; test; examine; inspect; verify; survey; check;checking;testing;[英國]jerque(指檢查船舶...
  1. The structure of air - blast pipe was improved on. an orienting object was installed based on theoretical analysis, that increase the spraying span. it has been found that both spraying span and droplets uniformity improved, by installing the orienting object. according to the results of a great number of experiments, orderliness of droplets diameter along the spraying span was researched, and rational spraying span of air - assisted sprayer was suggested

    通過試噴霧機機的噴霧性能,並提出對各項參的優化設方案。通過正交試和對比試對霧滴,證明導流器的安裝不僅增加了噴幅,而且還提高了霧滴均勻性系。根據大量試的結果分析,找出了霧滴直徑在噴幅方向上所呈現的變化規律,並提出了合理的噴幅范圍。
  2. By means of laboratory and field experimentation of typical semi - rigid base materials, the relationships among laboratory experimental values, field maintain values, field core values and construction criteria are put forward. and the relationships between different test methods are established. using time - temperature conversion principle, it processes the intensity assessment of field cores, then offers the method of determining the test deflection of pavement surface

    通過典型半剛性基層材料的室內外試,研究主要設的室內試值、野外養生值、現場芯值及施工指標間的關系,建立了不同試方法間的相關關系,運用時溫換演算法則,對現場芯進行強度評定,並提出了路表彎沉測標準的確定方法。
  3. Through the theory of light radiation and intensity, we can use the fewest leds to satisfy the luminous intensity demand. through image segmentation theory, we can accurately pick module up from the test stripe when it is put in wrong directions. through image processing theory, we can acquire correct information and avoid the bad effects from the asymmetric chemistry reaction and instability of the devices

    用光的輻射和強度理論,我們算出了獲得足夠圖像強度所需的最少光源;用圖像分割理論,我們在試紙條傾斜放置或有垂直方向上的偏移時,準確地提出了各模塊的據;用平滑濾波和均值濾波理論,我們濾除了由於反應不均勻及硬體設備不穩定帶來的噪聲;用交遇區設線性分類器的方法,我們降低了有限本設線性分類器帶來的誤差,提高了準確度。
  4. The whole process of using this method was discussed on making the proofs of solid colors, acquiring data of the proofs, choosing reference standard, analyzing of the proofs in the chromaticity diagram, and calculating the total color difference between each proof and the reference standard with an example of four color metals printing

    以金屬四色印刷為例,討論了使用這種方法獲得四色印刷實地色標準的全過程:製作實地色、色據獲、參考標準選擇、色品分析、算總色差和三色實地疊印的灰平衡程度。
  5. This paper simulates the effect of voltage fluctuation inspection through the tool of matlab. and proves the filters ' s stability. in the part of self - checkout, pi ( proportional integral ) control arithmetic is put forward to check the gain k and the calculated results show the method ' s effectiveness. then many comparements toward pst are done in different realization methods such as different interpolation points classification number and sample frequency. though simulation and calculation we can see the designed flicermeter can meet our country ' s standands

    文中利用matlab對電壓波動的測效果進行了模擬;並對涉及到的濾波器的穩定性做了證明;在自校部分提出了將pi (比例、積分)演算法用於字濾波器增益k值的確定,得了不錯的效果;然後分別從不同插值點、不同分級和不同采頻率這幾個方面出發,對算出的p _ ( st )值進行了比較。
  6. This text completely and systematically studies the status and the development of the pyrolysis and the fluidization of biomass, which distill the bio - oil in the domestic and international area, as well as the existing problems. this thesis primarily include following aspects : ( l ), by experimenting and measuring the energy ( heat value ) and the content of c, h, n chemical element of right 20 kinds of common biomass, on the base of the experimental result, and respectively established the biomass energy predict experiment formula with the element of h and c is from change, and passed the ro. os examination, which provides the basis and convenience for flash pyrolysis fluidization device energy to convert the rate to compute with biomass energy utilization calculation ; ( 2 ), proceeded the tg and dtg experimentation equal velocity ( 10 ? / min, 20 ? / min, 40 ? / min, 60 ? / min ) heating and constant temperature heating by studying on eight kinds of biomass samples, according to the experimental data and arrhenius formula, we established the dynamics model of pyrolysis of, then, using the goast - redfern and p function, we also solved the dynamics parameters and analyze out every kind of biomass ' s frequency factor and parameters of activation energy, and established the every kind of dynamics model of pyrolysis of biomass, all of these provide the theories and basis to make sure the reactor ' s flash pyrolysis work temperature scope design and the describing of pyrolysis reactor dynamics ; ( 3 ), in order to study and ascertain the process of heat completely getting to pyrolysis time of varied size biomass particles, we observed and measured the ratio of length and diameter ( l / d ) with the varied biomass through electron microscope, we concluded the l / d ratios usually is from 5. 0 to 6. 0, the average is 5. 3 ; ( 4 ), we studied the process of biomass transiting and the theory of complete pyrolysis time with the theory of complicated heat field, we got the time ( t ) of the varied size biomass particles arriving to complete pyrolysis, and we knew that the complete pyrolysis time and the time which get to the biggest production ratio are identical, all of these studies provide the theory base for design and forecasting the flash pyrolysis reactor solid state resort time ; ( 5 ), according to the above experiment result, synthesize to make use of the engineering the mechanics, engineering the material, machine the design to learn the principle, deduce, establish the theory of rotation cone flash pyrolysis reactor material resort time ( t ) and reasonable rotation velocity ( or frequency ) relation theory ; and ( 6 ), we gave the reactor ' s smallest cone angle certain, reactor cone wall strength design theory, the reactor production ability theory, the power design method and the critical rotation velocity theory

    本文較全面、系統地綜述了國內外生物質熱解液化制生物燃油技術研究發展現狀及存在的問題,主要研究內容有: ( 1 )實、測定了20種常見生物質的能量(發熱量)和c 、 h 、 n元素含量,根據實結果分別建立了以h和c為自變量的生物質能量預測經公式,並通過r _ ( 0 . 05 );為閃速熱解液化裝置能量轉化率算和生物質能量利用率算提供了依據和方便; ( 2 )選擇了8種生物質試作了等加熱速率( 10 min 、 20 min 、 40 min 、 60 min )和恆溫加熱的tg和dtg實,根據實據和阿倫尼烏斯公式建立了生物質熱解反應動力學微分方程,並採用goast - redfem積分法和p函對其動力學參進行了求解,解析出各種生物質的頻率因子和活化能參,進而建立了各種生物質的熱解動力學模型,為科學確定反應器的閃速熱解工作溫度范圍及熱解反應動力學描述,提供了理論和依據; ( 3 )為研究和確定不同尺度的生物質顆粒中心達到全熱解的時間,在體視顯微鏡下對不同粒度的生物質顆粒的長徑比進行了實觀察和測定,得出生物質的長徑比( l d )一般在5 . 0 6 . 0之間,平均為5 . 3的結果; ( 4 )採用復雜溫度場傳熱學理論對生物質傳熱過程及充分熱解時間理論進行了研究,解析推導出了不同尺寸生物質顆粒中心溫度達到充分熱解溫度的時間( t ) ,得出了理論推導的充分熱解時間與最大產油率的熱解時間相一致的結果,為閃速熱解反應器固相滯留時間設和預測提供了理論依據; ( 5 )根據上述實結果,綜合運用工程力學、工程材料、機械設學原理,推導、建立了轉錐式閃速熱解反應器物料滯留時間( )與轉速(或頻率)合理匹配理論; ( 6 )提出了轉錐式閃速熱解反應器的最小錐角設、錐壁強度設、生產能力設理論和功率算方法及臨界轉速理論等。
  7. Milk and milk products. sampling. inspection by attributes

    奶和奶製品..
  8. Milk and milk products - sampling - inspection by attributes

    乳和乳製品..
  9. Sampling procedures for inspection by attributes - double sampling plans using minimal sample sizes, indexed by producer ' s risk quality and consumer ' s risk quality

    計數取樣檢驗程序.分批時控制出廠質量的以信任為基礎的零抽
  10. The company establishes the special bee product examination center and the laboratory, and to develop comprehensive laboratory management system, formulating laboratory standard operating procedure room, purchase including highly effective liquid phase color spectrometer, gas phase color spectrometer, ultraviolet obviously spectrophotometer, elisa analysis, and other food security projects necessary testing equipment. employment has the higher school record and the chemical analysis specialty inspector, the establishment from the sample, receives the type, the examination, the primary data analysis, the result reported arranges integrity test routine which the difference analysis, the recording files away, establishing corporate self ? inspection system products

    高原羚蜂業有限公司建立專門的蜂產品測中心和實室,並制定完善的實室管理制度,制定實室標準操作規程,購置包括高效液相色譜儀、氣相色譜儀、紫外可見分光光度、酶聯免疫分析儀等食品安全項目必要的測設備,聘用具有較高學歷和化學分析專長的員,建立從、收測、原始據分析、結果報告到偏差分析、記錄歸檔的完整程序,從而確立產品的企業自體系。
分享友人