計數器清除 的英文怎麼說

中文拼音 [jìshǔqìqīngchú]
計數器清除 英文
clear counter
  • 計 : Ⅰ動詞1 （計算） count; compute; calculate; number 2 （設想; 打算） plan; plot Ⅱ名詞1 （測量或計算...
  • 數 : 數副詞（屢次） frequently; repeatedly
  • 器 : 名詞1. （器具） implement; utensil; ware 2. （器官） organ 3. （度量; 才能） capacity; talent 4. （姓氏） a surname
  • 清 : Ⅰ形容詞1 （純凈） unmixed; clear 2 （寂靜） quiet 3 （清楚） distinct; clarified 4 （一點不留） w...
  • 除 : Ⅰ動詞1 （去掉） get rid of; eliminate; remove 2 [數學] （用一個數把另一個數分成若干等份） divide:...
  • 計數 : count; tally; counting計數卡 numbered card
  • 清除 : clean up; dump; purge; reset; erase; clear; unset; blast; obliterate; clear away; eliminate; get ...
  1. This paper discusses the designing and making of the dynamic testing systems of engine electronic control system. base on the construction and operation principle of santana 2000gsi m3. 8. 2 engine electronic control systems, design and manufacture led circuit of dynamic testing and fault imitating electronic control unit. on the inspect board, design and equip with motronic 3. 8. 2 ecu i / o measuring joints, design and set up obd - ii diagnostic communication link, design and install fuel pressure inspecting meter. depend on the obd - ii diagnostic communication link and ecu i / o measuring joints, this dynamic testing system can inspect engine electronic fuel injection system, distributorless ignition system, idle speed control system and evaporative emission control system, and can inspect m3. 8. 2 sensors, ecu and actuators, and can interrogate fault memory and erase fault memory ; and can analyse data stream ; and can carry out fault imitating. besides, this paper analyses sensors and actuators typical fault w aves

    2電控單元電路連接器設計製成輸入輸出電子控制檢測端子，並在檢測面板上布置了obd -診斷插座和燃油壓力表。使該動態測試系統能實現對電噴發動機的燃油系統、直接點火系統、怠速控制系統和燃油蒸氣排放控制系統的動態檢測；並通過obd -診斷座、 ecu輸入輸出檢測端子和故障模擬處理單元實現對電噴發動機電控系統各傳感器、電控單元、執行器進行故障碼讀取與清除；動態數據讀取和波形測試和故障模擬等。此外，本論文還分析了傳感器和執行器典型故障波形。
  2. Discarded objects always have a lock count of zero

    被清除的對象的鎖定計數器的值始終為零。
  3. There s a method to increment the counter and a method to clear it, and that s it

    有一個方法遞增計數器，還有一個方法清除計數器，這就夠了！
  4. Detail specification for electronic components. semiconductor integrated circuit ct54161 ct74161 4 - bit synchronous binary counter direct clear

    電子元器件詳細規范.半導體集成電路ct54161 ct74161型4位二進制同步計數器異步清除
  5. It should be noted that at the beginning of their operation the feedback counters must be cleared.

    我們必須注意，反饋計數器在開始工作前，必須首先清除。
  6. You can remove the reference by clearing the

    可以通過清除數據源設計器中的
分享友人
分享到 Line

分享到臉書