計數速度計 的英文怎麼說

中文拼音 [jìshǔsùdùjì]
計數速度計 英文
counting rate meter
  • 計 : Ⅰ動詞1 （計算） count; compute; calculate; number 2 （設想; 打算） plan; plot Ⅱ名詞1 （測量或計算...
  • 數 : 數副詞（屢次） frequently; repeatedly
  • 速 : Ⅰ形容詞（迅速; 快） fast; rapid; quick; speedy Ⅱ名詞1 （速度） speed; velocity 2 （姓氏） a surna...
  • 度 : 度動詞[書面語] （推測; 估計） surmise; estimate
  • 計數 : count; tally; counting計數卡 numbered card
  • 速度 : 1. [物理學] velocity; speed; blast; bat 2. [音樂] tempo3. （快慢的程度） speed; rate; pace; tempo
  1. Superficially it is quite safe to phase advance an accelerometer signal as the error signal has been filtered by the servo and the alrframe transfer function.

    從表面上看，因為誤差信號已被伺服機構和彈體傳遞函數濾波，所以讓加速度計信號經相位超前網路是不會有問題的。
  2. This dissertation uses genetic algorithm to choose optimum parameters for the widely used pid controllers. in the optimization calculation process, mutation rate, cross rate and parameter range are adaptively changed to accelerate optimization process

    本文用遺傳演算法優化工程中廣泛使用的pid控制器的參數，採用變參數區間、變交叉變異概率等方法提高計算速度，並對適應值函數進行了改進。
  3. This paper starts the research of the liquid floated pendulous accelerometer testing system according to the engineering. at first, this paper gives the brief introduction of the history and present status of accelerometer and its testing technology, the working principium and math model of the liquid floated pendu - lous accelerometer, and then, decides the binary width pulse force retrim loop as the design proposal of testing system, researches the transfer function of every part in the system emphasizly, analyses the stability of the whole accelerometer testing system from the angle of control theoretics by the open loop transfer function of system, and designed the correcting net, analyses the basal problems such as resolution, sampling restraint, precision and so on, designs the hardware testing circuits such as preamplification, band - pass filter, alternating amplifier, phase sensitive demodulatorn, pulse - width modulation, frequency scale circuit, moment current generator. finally, using the graphics program language labv - iew which is designed for testing field especially by ni accomplishes the solfware design of testing system, realized the testing functions

    首先對加速度計及其測試技術的發展歷史和現狀，液浮擺式加速度計的工作原理和數學模型等作了簡要的介紹，然後確定了以二元調寬脈沖再平衡測試迴路為設計方案，並從控制理論的角度進行了分析，著重研究了系統中各部分的傳遞函數，利用系統開環傳遞函數分析了系統的穩定性，同時設計了系統的校正網路;分析了二元調寬脈沖再平衡測試迴路的解析度、采樣約束以及測試精度等基本問題，並按照系統分析的結果設計了包括前置放大、帶通濾波、交流放大、相敏解調、脈寬調制、頻標電路以及力矩電流發生器等測試系統各部分硬體電路，驗證了電路的正確性，最後按照測試系統的要求，採用了美國ni公司專為測試領域所開發的虛擬儀器工具? ? labview作為測試軟體開發工具，利用該圖形化編程語言完成了測試系統軟體部分的設計，實現了測試功能。
  4. Abstract : the maximum tube distribution numbers in tube sheet limited circle for fixed tube sheet heatexchanger have been determinded by used of the superposition method with computer based on c language programming. it is characterized by determination the maximum tube distribution number according to the even number or singular number of center tube distribution. the method is simply and quickly, and can be used for the design and process calculation of heatexchangers

    文摘:採用迭加的方法，使用c語言編程在微機上實現管板布管限定圓最大布管數的確定.該方法可根據中心布管數是奇排列還是偶排列來確定最大布管數，簡便易行，計算速度快，對換熱器的設計及工藝計算具有實用價值
  5. The effect of the parameter of the spring beam on resonant frequency, sensitivity, cross sensitivity of the structure of the accelerometer, the effect of the electrostatic force on the accelerometer, the dynamic performance of the accelerometer are analyzed

    論文採用了一種新的建模模擬法，即原理級描述模擬法，建立了叉指式微加速度計的參數化機電混合系統模型，對其進行分析研究。
  6. In chapter three, a back / forward sweeps based on branch loss for power flow is presents, which is credited with simple program, good numerical value stability, small ems memory and rapid calculation

    第三章介紹了基於支路網損的配電網前推回推潮流演算法，該演算法編程簡單，數值穩定性好，佔用內存小，計算速度快，並且收斂性和收斂速度均優于牛頓法。
  7. The property shows that the maximal solution is well - conditioned. two new iteration methods for finding the maximal solution are proposed. of these two methods, one is a linearly convergent iteration without matrix inversion, and one is related to newton s method and quadratically convergent

    這2種方法，一種是線性收斂的，其優點是迭代過程不需要求矩陣的逆另一種是二次收斂的，數值試驗的結果表明該方法在計算速度和精度方面都明顯地優于現有的其他幾種迭代方法。
  8. Round these two respects, how to structure security elliptic curve cryptography and the implementations of ecc is first discussed in this paper. then we have analysed especially the scalar multiplication on the elliptic curves, and present a new algorithm to quickly implement the fixed point scalar multiplication according to the idea of interleaving exponentiation algorithm and power division. this algorithm is much faster than fixed - base windowing method ; and a little faster than fixed - base comb method

    圍繞這兩個方面的問題，本文首先討論了如何構造安全的橢圓曲線密碼體制和橢圓曲線密碼體制的應用；然後重點分析了橢圓曲線上數乘運算的快速實現，並結合interleavingexponentiation演算法和冪分割的思想，提出一種計算固定點數乘的快速演算法，該演算法的計算速度明顯快于fixed - basewindowing演算法，稍快于fixed - basecomb演算法。
  9. Taking intercontinental ballistic missiles as objects under research, and based on the analysis of the influence of accelerometer measurement error and gyroscope excursion error on the apparent acceleration, the error transfer model of the inertial system in a midcourse guidance segment for velocity and location is given, and the pure inertial navigation guidance error is computed with the given imu error coefficient deviations

    摘要針對洲際彈道導彈，在分析加速度計測量誤差和陀螺漂移誤差對導彈視加速度影響的基礎上，給出了中制導段慣性系統對速度和位置的誤差傳遞模型，對給定的慣組誤差系數偏差進行了純慣性導航制導誤差計算。
  10. The thesis also involves some detailed techniques come across in the numerical simulation process of elastic dynamic fem analysis, and remarks the theoretical foundation and applications to them, which covers mass scaling, hourglass deformation mode and dimensional compatibility

    本文還對彈性動力學有限元數值計算過程中遇到的若干技術細節進行了深入分析與探討。這包括質量縮放技術對時間步長的影響、單位制對計算速度的影響以及單元剛度單點數值積分的沙漏模態控制技術等。
  11. A precision force banacing accelerometer for ineration navigation application is developed. the resolution, low - sensitivity threshold and high thermal stability are considered as design parameters. in order to guarantee a low - sensitivity threshold while maintaining robustness against shock, push - pull type long flexures are used in this paper. to improve thermal stability, this paper discusses the use of electromagnets as a magnetic fied source. the silicon pendulum assembly and modified inducance type pick - up is also developed to reduce assembling procedure. the measure range of accelerometer is 0 - 70g

    加速度計的解析度、靈敏度閾值和高的熱穩定性是設計時主要考慮的參數。本論文中使用推?挽式長撓性結構來保證低靈敏度閾值，同時保證抗振魯棒性。為了提高熱穩定性，本文中討論了利用永久磁鐵作為磁場源；微加工技術被引入擺組件的結構設計和利用力矩線圈作為激勵線圈來簡化電感式的檢測裝置。
  12. The calculation software, which is compiled by microsoft visual c + +, can calculate the characteristic parameters of water and steam more quickly and precisely than before. further more, it can adjust the thermal parameters automatically

    此軟體界面合理，水和蒸汽的參數計算準確，熱力計算速度快，參數自動調節功能強，能完成多方面的功能，很好的勝任了本文的研究工作。
  13. Prevents error checking and can make integer calculations faster

    可禁止錯誤檢查，並可以讓整數計算速度更快。
  14. The speedometer indication was 45 miles

    速度計讀數是四十五英里。
  15. Using piezoresistive accelerometers and magnetoresistance sensors measure the dynamic acceleration and geomagnetic field and through avr mcu software to calculate the attitude angular and azimuth. the fact of affecting the module is discussed in detail in this report and put forward the resolving scheme of key technology of digital filter, linear compensation, temperature compensation and magnetic field adjustment. the digital module has advantages of small size, light weight, low conception, high accuracy, all solid state and high reliability

    本課題採用壓阻式加速度計和磁阻傳感器分別測量重力加速度和地磁場，通過avrmcu軟體解算出姿態角和方位角，課題詳細分析了影響模塊性能指標的因素，就數字濾波、線性補償、溫度補償、磁場修正等關鍵的技術問題提出了可行的解決方案，研製的數字化模塊具有體積小、重量輕、低功耗、精度高、全固態、高可靠等特點，所有性能指標均滿足設計要求，為姿態角測量提供了有效的手段。
  16. Along with the improvement of rlg and accelerometer and the coming forth of high speed digital processor, the key technique of sins is carried out

    隨著激光陀螺和加速度計性能的不斷提高，以及高速數字處理器的不斷涌現，捷聯慣導系統實現的技術關鍵已經實現。
  17. Consider to simplifying the process of calibrating dynamic error parameters of accelerometer and shortening the time of calibrating test, all dynamic error parameters are calibrated at one - time, based on the mathematic model of dynamic error of accelerometer and integrating the model and the testing theory of the three - axis turntable, meanwhile, the angle - vibration table is avoided

    摘要為了簡化加速度計動態誤差系數的標定過程，縮短標定試驗時間，在建立加速度計動態誤差數學模型的基礎上，結合三軸轉臺模型及測試原理，一次性標定出加速度計動態誤差系數，同時避免了角振動臺的使用。
  18. Firstly, the structure of the laser accelerometer based on psd are designed in this dissertation. the relation between the output pulse difference and the input acceleration is derived

    本論文主要研究內容:首先，設計了基於psd的激光加速度計系統的結構，針對此結構推導了該數字式力平衡加速度計輸出脈沖差與輸入加速度之間的關系。
  19. The study shows that limited difference forward method has higher precision and computing speed in geo - electrical forward modeling

    研究表明，利用有限差分數值方法進行復雜地電模型的正演計算，計算速度快，計算結果精度較高。
  20. Its products are for detecting material position, controlling liquid level, counting, measuring speed, recognizing width, postponing signal, marking color spot, correcting position, recognizing hole, protecting, alarming, etc

    健埃爾公司產品廣泛用於工業、高科技及各種設備中作物位檢測、液位控制、產品計數、速度監測、寬度判別、信號延時、色斑標記、定位糾偏、孔洞識別和安全防護裝置、防盜警戒等。
分享友人
分享到 Line

分享到臉書