計算平均照度 的英文怎麼說

中文拼音 [suànpíngjūnzhào]
計算平均照度 英文
annual illumination
  • : Ⅰ動詞1 (計算) count; compute; calculate; number 2 (設想; 打算) plan; plot Ⅱ名詞1 (測量或計算...
  • : Ⅰ動詞1 (計算數目) calculate; reckon; compute; figure 2 (計算進去) include; count 3 (謀劃;計...
  • : Ⅰ形容詞1 (沒有高低凹凸 不頃斜) flat; level; even; smooth 2 (高度相同; 不相上下) on the same l...
  • : Ⅰ形容詞(均勻) equal; even Ⅱ副詞(都; 全) without exception; all
  • : Ⅰ動詞1 (照射) illuminate; light up; shine 2 (反映) reflect; mirror 3 (拍攝) take a picture ...
  • : 度動詞[書面語] (推測; 估計) surmise; estimate
  • 計算 : 1 (求得未知數) count; compute; calculate; reckon; enumerate 2 (考慮; 籌劃) consideration; pla...
  1. The cost of these items is calculated quarterly or haft - yearly by the bank ' s computer and against this is set off “ notional ” rate of interest on the customer ' s average credit balance during the period

    這些項目的費用由銀行的機按季或半年一次,按該期間內客戶貸方余額的「名義上」的利率抵消這些費用。
  2. You can also formulate corresponding 80 %, 100 % and 120 % of reference substance solutions according to tested items of calibration factors of each type, plus specified amount of internal standard solution to make 3 different density solutions, blend samples for continuous 3 times, and calculate calibration factor

    也可按各品種校正因子測定項下,配製相當於80 % 、 100 %和120 %的對品溶液,加入規定量的內標溶液,配成3種不同濃的溶液,分別迸樣3次,校正因子。
  3. Because of decrement in pesticide use, from 1999 - 2001, the poisoning probability caused by pesticides use for farmers who plant bt cottonseeds is respectively 17 %, 22 % and 4 % lower than those who plant non - bt cottonseeds, with an average number of 11 % in this three years. meanwhile, bt cotton planting farmers in yellow river watershed and changjiang river shed saved 48. 4 yuan and 107. 8 yuan per time in pesticide and wage losing cost, with the average of 68 in sample areas

    中岡農業和學院博卜學泣論文中英義摘芙山于農戶大幅減少了衣藥投入, 1999 2001年調查的種植bt抗蟲棉的農戶發生農藥中毒的概率分別要比種植非bt棉的農戶低17見2肌和4 「三年總要低11以同時按樣本所在棉區的bt棉種植農戶相應節約的農藥和誤工費用分別為黃河流域棉區48
  4. Last the paper employs five - point method to calculate average illumination of major action area, and according to the average illumination determines the optimal setting way of dimming - ballasts, and by the

    提出採用5點法主要活動區域的,由此確定調光鎮流器的最佳設置方式,使系統實現智能調光。
  5. Referring to three kinds of plan irregularity, structures individually with four kinds of irregularity as eccentricity in one direction, eccentricities in two directions, re - entrant corner irregularity and diaphragm discontinuity have been analyzed to investigate the relationship between torsion effects and parameters of above irregular structures. the parameters and the schemes for determining the scope of structures with different kind of irregularity considering seismic action in two directions simultaneously are proposed, some conclusions have been get as following : it is indicated by the analysis results that torsion effect has no dependency relation with eccentric torsional angel adopted in code for seismic design for buildings. it is suggested that the eccentric torsional angel should not be take as the parameter of torsion effect of structures considering seismic action in two directions simultaneously ; for the structures with regular plan and elevation and with eccentricity in one direction due to irregular mass layout, the relative eccentricity can be take as the parameter of torsion effect of structures considering seismic action in two directions simultaneously ; for the structures with regular plan and elevation and with eccentricities in two directions due to irregular mass layout, the ratio of relative eccentricities in two directions and the angel of them can be take as the parameters of torsion effect of structures considering seismic action in two directions simultaneously ; it is indicated by the analysis results that the torsion effect has no dependency relation with re - entrant corner ratio adopted in code for seismic design for buildings as

    所取得的主要結論有:結構的扭轉效應與《抗震規范》所採用的扭轉不規則指標即偏心扭轉角之間的相關性較差,偏心扭轉角不宜作為判斷結構是否及扭轉效應及需考慮雙向水地震作用的界定指標;對于樓層間勻偏心的多層單向偏心結構,建議採用相對偏心距作為需考慮雙向水地震作用的界定指標,並給出針對不同面尺寸的界限相對偏心距;對于樓層間勻偏心的多層雙向偏心結構,建議採用兩個主軸方向的相對偏心距及其夾角作為界定指標,結合單向偏心結構的界定方案進行需考慮雙向水地震作用的結構范圍界定;凸凹不規則結構的扭轉效應與凸凹比例無正相關關系, 《抗震規范》要求所有面布置不對稱的凸凹不規則結構及扭轉效應的規定欠妥當,建議凸凹不規則界限值從30改為15 ,只要求分析採用空間模型比較合適; 《抗震規范》關于有效樓板寬較小的結構需及扭轉效應的規定很有必要,樓板局部不連續的結構需採用符合樓板實際剛模型予以分析,可使用相對偏心距(及其夾角)參單向(和雙向)偏心結構的界定方案,界定樓板局部不連續結構是否需要入雙向水地震作用下的扭轉效應。
  6. According to the theory of market economics, the establishment of fiscal transfer system must conform to some principals, including the principal of scientific and rational, the principal of normative and uniform, the principal of efficient preferably, the principal of equitable concurrently, the principal of public and transparent, and the principal of paying more attention to performance. the design of fiscal transfer system of jiangsu province should comply with periodic goals. we also should calculate the standard for fiscal revenue per capital and fiscal expenditure for all regions in the method of factor and regression, and then decide rationally the fiscal capacity of different regions

    根據市場經濟理論,財政轉移支付制的建立,必須遵循科學合理、規范統一,效率優先、兼顧公,公正透明、注重績效的原則,江蘇財政轉移支付制的設要按分階段目標,採取因素法和回歸法測各地的標準財政收入和標準財政支出,進而合理確定各地的財力水,保證各地居民享受相對等化的公共服務擁有相應的財力,同時,採取與目標相適應的政策措施,才能逐步建立符合江蘇特色的財政轉移支付制
  7. On basis of this property a new type of coherence function was proposed and a simplified method of analyzing structure ' s wind - induced response and equivalent load was proposed. wind tunnel experiments with the caarc standard tall building model was executed to verify the proposed method with the dynamic balance technique. the comparisons show the good agreement on the basis of linear mode shape assumption that is used in balance technique

    簡化方法的基底傾覆彎矩功率譜、基底彎矩響應、頂部加速和位移響應等參數能與高頻底座天試驗的結果較好的符合,等效設荷載的結果也與按《建築結構荷載規范》的結果具有一定的可比性。
  8. On the basis of application of machinery and power - generating product design, this paper analyzes and quantifies the theory of equilibrium and stability via analyzing the pictures of product, which is one of aesthetics standard method in design process. therefore, the theory of visual gravity and its calculating model are advanced. with applying the technology of detecting edges and gray histogram, the required image information cire picked up

    在機電產品造型設應用的基礎上,論文從實際產品的片分析入手,重點對設應用到的美學法則? ?衡與穩定理論,進行分析與量化研究,提出了有關機電產品設的視覺重心理論與的框架模型;運用圖像處理中的邊緣檢測與灰直方圖技術,提取操作需要的圖像信息;綜合產品的形態與色彩,分別結合視覺張力與力矩衡理論提出了兩種演法;建立了產品視覺重心的相關模型並在solidworks臺上用vc + +編程實現。
分享友人