計算溫度 的英文怎麼說

中文拼音 [jìsuànwēndù]
計算溫度 英文
accounting temperature
  • 計 : Ⅰ動詞1 （計算） count; compute; calculate; number 2 （設想; 打算） plan; plot Ⅱ名詞1 （測量或計算...
  • 算 : Ⅰ動詞1 （計算數目） calculate; reckon; compute; figure 2 （計算進去） include; count 3 （謀劃;計...
  • 溫 : Ⅰ形容詞（不冷不熱） warm; lukewarm; hot; gentle; mild Ⅱ名詞1 （溫度） temperature 2 （瘟） acute ...
  • 度 : 度動詞[書面語] （推測; 估計） surmise; estimate
  • 計算 : 1 （求得未知數） count; compute; calculate; reckon; enumerate 2 （考慮; 籌劃） consideration; pla...
  • 溫度 : [物理學] temperature
  1. The temperature cracks are calculated by use of a crack band model, and the stress and cracking of the concrete wall are computed by using the half - analytical iteration method

    採用裂縫帶模型計算溫度裂縫，用半解析迭代法進行了混凝土墻的溫度應力和開裂計算。
  2. In order to improve the prediction accuracy, the sensitivities of pipe friction coefficients, pressure loss coefficients in bents, wall temperatures and heat transfer coefficients in pipes and cylinders on the volume efficiency are investigated

    為提高充氣效率的計算精度，由模擬計算和相關試驗，分析了管道的摩擦系數、彎管的壓力損失系數、進氣管壁和氣缸壁溫度及其傳熱系數對充氣效率的影響程度。
  3. In order to search the demolishing effect pf the thermal stress on the hearth and bottom of the blast furnace, the distribution of temperature field and the thermal stress have been studied with the thermal elastic law and finite element method

    摘要為了探討熱應力對不同材質構成的高爐爐缸磚襯的破壞作用，在計算溫度場的基礎上，應用熱彈性理論和有限元法對高爐爐缸進行應力分佈計算。
  4. Calculation of temperature stress coefficient on board thickness design of cement concrete pavement

    水泥混凝土路面板厚設計的溫度應力系數計算
  5. The model was built up according to transmission heat subject of temperature field in prestress concrete members, and analyzed the regulation of difference in temperature, divided different in temperature into transverse difference in temperature and lengthways difference in temperature, and gave some formulas

    藉助于傳熱學，建立預應力構件內部溫度場的計算模型。並在此基礎上，分析溫差分佈規律，將計算溫差的分解為橫向溫差和縱向溫差，並提出相應的計算公式。
  6. Based on the theories of gear engagement, contact analysis, friction and heat transfer, a three - dimensional finite element model of gear tooth was established to investigate temperature distributions and variations along the contact path over a range of applied loads and operating speeds with consideration of lubrication conditions. sensitivity analysis of surface temperature to gear configuration, frictional heat flux, heat transfer coefficients, and oil and ambient temperature was conducted and the major parameters influencing surface temperature were evaluated

    本文基於齒輪嚙合原理、輪齒接觸分析、摩擦學和傳熱學，以有限元分析方法和理論分析計算相結合為手段並以實驗測量結果作為參考，建立了適用於工業應用並具有較高計算精度的高速齒輪傳動輪齒溫度分析的模型和方法，系統地分析了輪齒本體溫度的大小和分佈以及齒輪幾何、載荷及轉速和潤滑冷卻條件等對輪齒本體溫度的影響。
  7. The author argues that the model can be used to calculate the longitudinal force caused by the temperature or the load acting on one of the double railway tracks, as well as the braking force and the breakage force

    此模型可計算溫度的影響，探究雙線橋樑上的單線荷載作用下的撓曲力、制動力和單軌斷裂時的斷軌力。
  8. Generalized constraint matrix method for calculation of temperature stresses

    計算溫度應力的廣義約束矩陣法
  9. The thermal process model of imbed pipe floor heating room at intermittent operation was set up by analyzing the thermal storage of enclosure. then, a solution method was give for it basing on duhamel theorem. the calculation results shown a good indoor thermal environment can be hold when the system, which designed on out door temperature for heating basis, operates half day in night under outer door mean temperature in winter

    對典型房間的計算結果顯示:系統間歇運行時，供暖系統開啟和關閉后室內溫度呈指數規律變化;當系統按供暖室外計算溫度設計，實際運行日的室外平均溫度等於供暖期室外日平均溫度時，在室外逐時溫度較低的時段低溫熱水地板輻射供暖系統運行半天左右可滿足全天供暖室內計算溫度要求。
  10. This paper introduces two methods of computing density and enthalpy : combination of " sectional average value " and " look - up tables " will improve the temperature resolution to 0. 1, that is / 0. 1 and h / 0. 1 ; " mathematical simulation " method will get density and enthalpy value with error less than 0. 01 %

    在本文中，提出了兩種計算密度值和熱焓值的方法：用「區間平均值法」與查表法相結合，來求密度值和熱焓值，可將求的密度值和熱焓值所對應的溫度解析度，提高到0 . 1 ，即0 . 1 、 h 0 . 1 。
  11. This paper analyzes on the meteorological data of taiyuan city from 1961 to 2001, recalculates the outdoor calculated temperature of heating in winter, and puts forwards the possibility of energy - saving from the angle of science

    在分析太原市1961 ? 2001年氣象資料的基礎上，重新計算了冬季採暖室外計算溫度，並從科學角度提出了節能的可能性。
  12. The temperature stress is analyzed by formula and numerical method respectively ; and the fit temperature step is obtained. the interactions of undamaged pavement and soft clay ground, damaged pavements and soft clay ground are studied under the conditions of temperature change

    其次，採用公式法和有限單元法計算一維瀝青混凝土桿低溫下變溫的溫度應力，通過分析給出了採用有限單元法計算溫度應力時的合適溫度步長。
  13. To obtain the mechanism, we find the temperature " contribution to the magnetic anisotropy. the change of the temperature have a main effect on the occupied probability to all the energy levels. to the diverse crystal site, the probability is not identical

    為進一步分析ergag石榴石磁性各向異性的產生機理，我們計算溫度的變化對ergag磁化的貢獻，發現溫度的變化對不同方向磁化的影響也很大，溫度的變化影響了離子占據能級的幾率，並且沿不同磁化方向，對不同晶座，溫度的影響也有著不同的差異。
  14. Based on thermal comfort formula and pmv / ppd evaluation indices, design indoor temperature of residential building with household heating and heat metering systems was studied in this dissertation. it was determined that the range of indoor temperature is 16c ~ 24c when design indoor temperature is 20c

    本文從熱舒適、工作效率以及健康標準等方面出發，以熱舒適方程及pmv ppd評價指標為依據，對採用分戶計量供熱系統的居住建築的室內設計計算溫度的確定進行了研究，確定其為20 ，室內溫度的變化范圍是16 24 。
  15. Based on the previous research results, the author takes nonlinear temperature load equivalent to linear temperature load and calculates temperature stress by fem. it analyses the whole and the part temperature effect on rigid - framed arch bridge and compares different thermal stress of different bridge structure by the simplified methods. the research offer advices for this new style bridge

    本文在總結前人工作的基礎上，分析探討將非線性溫度荷載等效為線性溫度荷載，同時採用有限元計算溫度應力的簡化方法；並利用這種計算方法對剛架拱橋的整體和局部的溫度效應以及不同橋型溫度效應的不同進行了分析比較，為這種新橋型的工程設計提供參考，還通過實測結果驗證上述方法的正確性，並進行了修正。
  16. The model is used to process the data of multi - spectral thermometer, the simulation experiment shows that this method has higher precision on high temperature

    利用該方法對多光譜測溫數據進行處理，其結果表明:該方法在高溫段（ 1500 ~ 3000k ）有更高的計算精度。
  17. The dynamics study of carbonate - clay minerals reactions shows that high temperature will benefit the reactions process and high pressure will be disadvantageous to the reactions

    根據co _ 2生成反應的熱力學計算，溫度的增加有利於碳酸鹽礦物與粘土礦物作用形成co _ 2 。
  18. ( 2 ) a continuous measurement method based on brightness temperature is proposed by processing the measured data of the multiwavelength pyrometer at two different times, the true temperatures and spectral emissivities at two different times can be calculated simultaneously. the experimental results show that this method improves the measurement precision of true temperature and spectral emissivity

    （ 2 ）提出了基於亮度溫度模型的連續測量法，通過處理多波長溫度計兩個不同溫度處的測量數據，可以同時求得兩個不同溫度處被測目標的真溫及光譜發射率，試驗表明:該方法可以提高計算精度。
  19. The attenuation are also calculated and discussed with fog drop size distribution model and empirical relations of the liquid water content and the visibility or other parameters of fog and clouds. the measured results of sea fog attenuation in qingdao at 33. 5ghz and 93. 5ghz are analyzed and discussed

    提出了一種較其它經驗模式適用頻率和溫度范圍更寬，計算精度更高的雲霧衰減經驗公式，並對雲霧的毫米波衰減特性及海霧的毫米波衰減實驗結果進行了分析和討論。
  20. This paper develops the models of evaporation of water and moisture transfer by considering the water moving, whereby the calculation of temperature field is amended with high accuracy

    本文嘗試在一定假設條件的基礎上建立簡單的水分蒸發遷移模型來考慮水分時混凝土板溫升過程及溫度分佈的影響，進而時計算溫度場進行適當修正。
分享友人
分享到 Line

分享到臉書