設備需求總量 的英文怎麼說

中文拼音 [shèbèixūqiúzǒngliáng]
設備需求總量 英文
facilities requirements summary
  • 設 : Ⅰ動詞1 （設立; 布置） set up; establish; found 2 （籌劃） work out : 設計陷害 plot a frame up; fr...
  • 備 : Ⅰ動詞1 （具備; 具有） have; be equipped with 2 （準備） prepare; provide with; get ready 3 （防備...
  • 需 : Ⅰ動詞（需要） need; want; require Ⅱ名詞1. （需用的東西） necessaries; needs 2. （姓氏） a surname
  • 求 : Ⅰ動詞1 （請求; 要求） ask; beg; request; entreat; beseech : 求人幫忙 ask sb a favour; ask a favou...
  • 總 : Ⅰ動詞（總括; 匯集） assemble; gather; put together; sum up Ⅱ形容詞1 （全部的; 全面的） general; o...
  • 量 : 量動1. （度量） measure 2. （估量） estimate; size up
  • 設備 : equipment; device; facility; implementor; apparatus; installation; appointment; furnishing; setou...
  • 需求 : needs; need; demand; requirement
  1. Considering the high correlation between quantity demand of spare parts and life of equipment, this paper offers an inventory model to determine the times of order, reorder point and quantity of spare parts during the whole life of equipment on condition that the demand rate of spare parts changes with time while the total cost of ordering and stocking is lowest

    基於備件的需求量與設備使用周期密切相關這一關鍵點，從設備的整個使用周期入手，結合設備的使用情況，在備件需求率隨時間變化的情況下，對備件庫存控制問題進行了研究，建立了在設備整個使用周期內使備件總訂貨成本和存儲費用最低的數學模型，給出了備件最佳訂貨次數、訂貨時間和訂貨批量的計算公式。
  2. In chapter two the general design requirements for a measuring system for fast neutron reactors and fuel pins are presented and the brief introduction of mechanical equipment is also given

    第二章介紹了快堆組件套管及燃料棒測量控制系統總體設計需求，以及機械設備的概況。
  3. With the increasement of instruments and the information shared between them in ultra - precision measurement, the measurement and control networks constructing by rs - 232, rs - 485, can and gp - ib can no longer meet the requirement of high - speed data exchanging between measuring instruments

    隨著超精密測量過程中儀器設備的增加以及各種儀器間共享信息量的增大，採用傳統rs - 232 、 rs - 485 、 can 、 gp - ib等總線為主導將測量儀器設備組成測控網路的模式已經不能滿足測量儀器之間高速數據交換的需求。
  4. It has been playing an important role in equipping all kinds of arms and services for campaigns, tactical exercises and emergent actions etc. based on the detailed analysis of the exchange ' s architecture and implementing, this thesis points out some disadvantages of the device, such as too many absolute components, not very high enough reliability and security, very large size and weight, operating and maintaining difficultly. considering low power requirement and man - machine interface optimizing design at the same time, the thesis come up with an integrated design scheme to the previous device based on " mcu + cpld / fpga architecture " : ( 1 ) signal frequency dividing, timing frequency producing, 20 customers " led states controlling are implemented in cpld ; ( 2 ) decoding, latching data and controlling signals are implemented in cpld by bus interface between mcu and cpld ; ( 3 ) chip selecting principles and mcu idle mode design are completed under the consideration of low power requirement ; ( 4 ) operation by chinese lcd menus is adopted in the man - machine interface

    本項目以該交換機為研究對象，在詳細分析原設備的系統結構和功能實現方式的基礎上，指出該機型在使用過程中存在技術相對陳舊、分立元件過多、可靠性和保密性不夠、體積大、重量大、維修困難等問題，同時結合系統的低功耗需求和優化人機介面設計，本文提出基於「單片機+ cpld fpga體系結構」的集成化設計方案：在cpld中實現信號音分頻和計時頻率生成電路、 20路用戶led狀態控制電路； cpld與單片機以總線介面方式實現譯碼、數據和控制信號鎖存功能的vhdl設計；基於低功耗設計的器件選型方案和單片機待機模式設計；人機介面的lcd菜單操作方式。
分享友人
分享到 Line

分享到臉書