試驗性操作 的英文怎麼說

中文拼音 [shìyànxìngcāozuò]
試驗性操作 英文
pilot operation
  • 試 : 名詞（古代占卜用的器具） astrolabe
  • 驗 : 動詞1. （察看; 查考） examine; check; test 2. （產生預期的效果） prove effective; produce the expected result
  • 性 : Ⅰ名詞1 （性格） nature; character; disposition 2 （性能; 性質） property; quality 3 （性別） sex ...
  • 操 : Ⅰ動詞1 （抓在手裡; 拿; 掌握） hold; grasp 2 （做; 從事） act; do; operate 3 （用某種語言、方言說...
  • 試驗性 : experimental
  • 試驗 : trial; experiment; test
  • 操作 : 1 （按照一定的程序和技術要求進行活動） operate; manipulate; handle 2 （所進行的若干連續生產活動的...
  1. Design philosophy of hardware and software is established. the paper bases control algorithm of operator and control program diagram on thorough investigation into truck crane operation reliability action flow, which makes sure of accurate and effective control over handle and accelerograph and achieves test process automatization

    文章在深入研究汽車起重機作業可靠性試驗動作流程的基礎上確定了對執行機構的控制演算法，並給出控製程序框圖，準確有效地實現了對操縱手柄及油門的控制，達到試驗過程自動控制的目的。
  2. Protocol of the isolation of equine viral arteritis virus from stallions semen

    從精液中分離馬病毒性動脈炎病毒試驗操作規程
  3. A rabbit was infected with a cloned yntatl, blood was collecting from from the rabbit every 3 days after infection within 30 days, 10 clonal trypanosome populations were gotten, infecting a new rabbit by the last non - cloned trypanosome population. repeated above all, thus infected 5 rabbits sequentially. twenty different vats ( variant antigen type ) were monitored and characterized from those fifty mono - clonal populations by indirect immunofluorescence test ( ift ) and avidin biotin enzyme immunoassay ( abc - eia )

    用伊氏錐蟲雲南水牛單克隆株yntat1感染兔，感染后30天內，每3天從兔血中分離錐蟲並單蟲克隆，最後一個未單蟲克隆的蟲株感染另一隻兔，重復以上操作，這樣順序感染5隻兔子，共獲得50個單克隆錐蟲種群（ tp ） ，經間接免疫熒光和abc酶標試驗鑒定共為20個抗原性互不相同的抗原變異體（ vats ） 。
  4. Simultaneously, combine with his own work experience, the author gets an advanced detail and general design steps. and then illustrates an actual engineering which is designed with the article ’ s recommendatory method and steps. by combining with the test results, it is proved that the ground treatment result obtains the design requirement and the commendatory method is right, which is able to provide reference value to the engineering

    本文首先對加筋土的研究現狀做了詳細的介紹和分析，在此基礎之上，對加筋土地基設計方法做了一定的研究，對地基承載力力設計方法做了對比分析，選擇極限分析法作為本文的推薦方法，並結合作者自身的工作經驗，提出了加筋土地基詳細和全面的設計步驟，然後用一個加筋土地基實際工程為例，採用本文推薦的設計方法和步驟進行設計，並通過現場試驗結果，證明該地基處理達到設計要求，也證明了推薦方法計算的準確性，這對廣大工程師在實際工程操作中有較高的參考價值。
  5. Protocol of agar gel immunodiffusion test for enzootic bovine leukosis

    牛地方流行性白血病瓊脂免疫擴散試驗操作規程
  6. Abstract : by analyzing the double meaning of the effect mechanism of water on the oxida tion and spontaneous combustion of residual coal in goaf, and through investigat ion of the results both in laboratory and field practice, it is confirmed that w ater pouring, which is suggested by authors, is a new, economic, efficient and e asy ? to ? operate measure for controlling the spontaneous combustion of the resid ua l coal in goaf

    文摘:通過對水在采空區遺煤氧化及自燃的作用機理兩重性的分析以及實驗室試驗與現場應用實際效果研究，證實了筆者提出的清水灌注措施是一種新的、經濟有效的、操作簡便的防治采空區遺煤自燃的技術措施。
  7. Nowadays, the ways to detect the piles are various, and all of them are limited in some aspects. for instance, coring test do large scathe on the piles, and static load test will waste much time, money and energy, while some ways are hard to operate as the limitation of the length and the diameter of the piles, and the special condition on the spots, such as high - strain, low - strain, and so on. furthermore, the result can only be gained under the complex analysis of the collected wave, and under the validation of the coring test

    目前，工程中常用的樁基檢測方法很多，但都存在著一些弊端：有的對樁破壞性嚴重，例如抽芯檢測；有的耗時、耗財、耗力，例如靜載荷試驗；還有的如低應變、高應變等檢測技術由於受到樁長、樁徑以及現場一些特殊情況的限制，操作很不方便，而且採集到的波形要經過比較復雜的處理分析方能得出結論，而這個結論卻還要輔助取芯手段加以驗證。
  8. Furthermore, referring to the literature and considering the specific experimental conditions given by the research, expression of the change of feed rate with time is presented, to obtain the linear growth of the diameter of pre - sintered glass beads, thus the distribution of beads size is relatively well controlled and raw material is spared in some extent. eventually, during the experiment discrete change of feed rate is implemented, and the practical changes of average diameter are plotted, then the results are compared with the theoretical calculated data

    另外，本文通過對造粒技術、燒結過程的大員文獻調研，結合本研究的具體情況，通過控制進料速率呈連續性變化，基本實現了燒結前球坯直徑的線性生長變化，從而更有利於實際生產中的產品粒度控制以及做到節約用料，並在試驗操作中以離散型進料速率變化來加以比較驗證。
  9. Domestic furniture. seating. test method for the determination of the durability of reclining and or tilting mechanisms and operating mechanisms for convertible sofa beds

    傢具.座椅.活動沙發床向後靠和或微傾機構以及操作機構的耐用性測定的試驗方法
  10. Domestic furniture - seating - test method for the determination of the durability of reclining and or tilting mechanisms and operating mechanisms for convertible sofa beds

    傢具.座椅.活動沙發床斜靠和或微傾機構以及操作機構的耐用性能測定的試驗方法
  11. Because the monitoring of electricity equipment is still in the condition of traditional prophylactic test ( monitoring off line ), wordage list and management method of handwork operation, to strengthen the real - time monitoring of the operation state of electricity equipment ( monitoring on line ), find out the anomaly of equipment, monitor and analysis the fault, then take a corresponding measures to lower the fault loss so that we can make the transition between the regulations of periodic repairing equipment and the regulations of reasonable state repair, is the work which the department of power supply and operation make much of

    針對對現有電氣設備的監測大都還處于傳統的預防性試驗（離線監測） 、文字報表、手工操作的管理方式的現狀，加強對電力設備的運行狀態進行實時的監測（在線監測） ，及時發現設備的異常徵兆、對故障進行診斷分析，並採取相應措施，把故障損失降低到最低水平，進而將目前實行的設備定期檢修制過渡到更為合理的狀態檢修制，一直是供電和運行部門十分重視的工作。
  12. Standard test methods for operability of zippers

    拉鏈可操作性的標準試驗方法
  13. Mechanically actuated combustion air flaps ; safety requirements, testing and marking

    機械操作的燃燒空氣風門片.安全性要求.試驗和標記
  14. As to how to exert learning assessment successfully, this article has some probes, and attempts to form a learning assessment system. this system advocates collaboration between teachers and students, attaches importance to testing, daily assessment, science explorations ’ portfolio assessment and science experiments ’ authentic assessment, and guides students to assess themselves. to sum up, this system requires its ideal, objective, measures and results be “ appreciated ” and be received by all students

    基於以上研究，本文制定了相應的具有可操作性的學業評定標準，並對學業評定如何實施進行了有益的探索，認為當前亟需構建一個強調師生合作，重視考試（書面測試） 、日常評定、科學探究的檔案袋評定以及科學實驗的表現性評定相結合，引導學生開展自我評定和同伴評定的學業評定體系，這一體系強調學業評定的理念、目標、方法和結果必須被學生所真正「欣賞」和接受。
  15. Standard practice for the nondestructive testing of geomembrane seams using the spark test

    使用火花試驗對土工膜縫的非破壞性試驗的標準操作規程
  16. In order to look for the key factors governing fluidization characteristics in the dense phase pulverized powder feeder, the effects of the different operating conditions and the geometrical variables on the mass ratio of powder and gas and the stable conveying time of the system were investigated in the self - developed special dense phase powder conveying test - bed

    摘要為了尋找影響濃相粉體給料器流化特性的關鍵因素，在自行設計的專用小型濃相粉體輸送試驗臺上，考察了不同操作參數和結構參數對輸送固氣質量比和穩定給粉時間的影響，總結了各因素對流化質量的影響規律。
  17. To apply neural networks to the simulation of ship maneuvering motion, an nnrm ( neural network recursive model ) is designed and used to simulate a serial full - scale tests conducted in yangtze river and the comparison between simulated results and the measured ones is satisfactory. ship trajectory tracking is a well - known maneuvering problem with an increasing practical and theoretical interest. but the real - world tracking applications encounter a number of difficulties caused by the presence of different kinds of uncertainty due to the unknown or not precisely known system model and environmental effects

    本文利用智能控制技術的優越性，嘗試將智能化控制技術用於船舶操縱運動模擬，初步探索了將現代控制理論和智能技術融入船舶操縱預報、模擬的研究方法，提出了用於船舶操縱運動模擬的線性神經網路（ lnn ） 、神經網路遞推模型（ nnrm ）和nnrm 、交錯航跡距離（ cte ）和視距（ los ）混合控制器模型三種控制模型：並將控制模型的理論研究應用到實船試驗數據分析、計算，將模擬結果與實際的試驗結果作了比較。
  18. Using this equipment, the residual current protection test and operation reliability test were be done. and the failure reason of rcd was analysed. the method to improved the reliabilty level of rcd was introduce. so the reliability study can be processed

    應用剩餘電流動作保護器可靠性試驗設備進行了成功率驗證試驗和操作故障率可靠性驗證試驗，分析了剩餘電流動作保護器的故障原因，提出了提高剩餘電流動作保護器可靠性的方法，從而真正地將可靠性研究工作付諸實施。
  19. Acceptance tests for oxygen cutting machines. reproducible accuracy. operational characteristics

    氧氣切割機驗收試驗.可重復準確性.操作特性
  20. Acceptance testing for oxygen cutting machines ; testing the accuracy and operational characteristics iso 8206 : 1991 ; german version en 28206 : 1992

    氧氣割機的驗收試驗.復驗結果的準確性.操作特性
分享友人
分享到 Line

分享到臉書