試驗曲線 的英文怎麼說

中文拼音 [shìyànxiàn]
試驗曲線 英文
assay curve
  • : 名詞(古代占卜用的器具) astrolabe
  • : 動詞1. (察看; 查考) examine; check; test 2. (產生預期的效果) prove effective; produce the expected result
  • : 曲名詞1 (一種韻文形式) qu a type of verse for singing which emerged in the southern song and ji...
  • : 名詞1 (用絲、棉、金屬等製成的細長的東西) thread; string; wire 2 [數學] (一個點任意移動所構成的...
  • 試驗 : trial; experiment; test
  • 曲線 : [數學] curve; bight; bought; profile; net曲線板 french curve; irregular curve; curve board; splin...
  1. In this article i do a lot of analysis for the data formed in the mobile samples with the basis of the research of data mining, mainly including : it analyses and summarizes the theory and technology of data, especially the further discussion of the data mining algorithm for time sequential. it introduces the course of the test curve of the power transmission system of electric mobile and discusses the technology and methods of pretreatment for curve data. it studies and develops the antitype system for the analyses of test curve data of the power transmission system of electric mobile with the mining and analysis of test curve data of the power transmission system of electric mobile and the basis of the algorithm of time sequential

    本文以目前數據挖掘的研究為基礎,對汽車樣品中形成的大量數據進行分析處理,主要研究內容包括:分析和綜述了數據挖掘理論基礎和相關技術,特別是對時間序列挖掘演算法進行了深入的討論介紹了電動汽車動力傳動系統檢測生成的基本過程,討論了數據的預處理技術與方法以時間序列挖掘演算法為基礎,對電動汽車動力傳動系統檢測數據進行了挖掘與分析,研究並開發了電動汽車動力傳動系統檢測數據分析原型系統。
  2. Abstract : propagation characteristics of r wave in a pavement structures are analysed in this paper. based on the propagation characteristics of r wave, the horizontal propagation wave is simulated by using r wave, the vertical propagation wave is also simulated by using body wave in calculating dynamic response of pavement structures. the availability and accuracy of dispersion curves measured by sasw in pavement structures is analysed by using the presented method used to calculate dynamic response

    文摘:利用有限單元法分析了道路結構的r面波傳播特性:在深度方向上衰減較慢,傳播較深,波動性大.提出了在道路結構動力響應計算中,利用面波來模擬水平向傳播波,利用體波來模擬豎直向傳播波.通過算例來證該方法的可靠性和精確性,並利用這一動力響應計算方法分析了道路結構表面波測中所獲彌散的可靠性
  3. ( 2 ) based on indoor test, two typical soft rock of brecciated mudstone and siltstone in luohu jiancheng district is carried systemically though interior rheological testing ; moreover combining with preceding studying results of rock rheological constitutive model, rheological numerical constitutive model suited to rock mass mechanics characteristics and stratum structure of luohu fracture zone, and numerical parameters of the model are processed with studying of curve fitting

    ( 2 )立足於室內,對羅湖建成區兩種典型的軟弱巖石?含角礫泥巖和粉砂巖進行系統的室內流變研究,又結合前人對巖石流變本構模型的研究成果,分析並確定了適合羅湖破碎帶巖體力學特性及地層構造特徵的流變計算本構模型,並對該模型的計算參數進行了擬合研究。
  4. A load - displacement full - process analyzing program of cfrp - confined rc eccentrically loaded columns is given. the computed results of load - displacement coincide with test results

    編制荷載-撓度全過程計算程序對碳纖維布約束偏壓柱進行數值分析,程序計算試驗曲線吻合良好。
  5. The existed material fatigue performance test curves are dealt with and analyzed, and the non - dimensional stress - strain curve, tangent modulus factor curve and fatigue life curve are drawn based on the experiment data, and these three non - dimensional parameter curves are used to find the inherent rules that the test curves can be replaced each other to some extent. it can be concluded that if the common character and system error of these materials are found, the test curve of a certain material can be used for reference by another material. this is a simple approach about fatigue life estimate and is engineering practical

    對已有的材料力學疲勞性能試驗曲線進行分析整理,利用數據繪制了相對應力應變、切模量因子和疲勞壽命,利用這三種無量綱參數發現了其中存在的規律性,即在某種程度上實可以互相取代,並用數據對此進行了討論,並由此推斷,如果找出材料彼此的共性或彼此之間的系統誤差就可以將一種材料的試驗曲線供其它材料參考使用,這是一種估算材料的疲勞壽命的簡便方法,對工程而言具有實用性。
  6. Based on the creep experimental curve, the creep deformation law of silty soft clay of the first marine layer and its constitutive relationship among stress - strain - time is studied in this paper

    本文在蠕變試驗曲線的基礎上,研究了天津市第一海相層淤泥質粉質粘土的蠕變變形規律,得出應力、應變、時間三者之間的本構關系。
  7. Model identification for rheological load test curve and its application

    流變荷載試驗曲線的模型識別及其應用
  8. If asphalt concrete specimen is in stabilization by exert confining stress before the static triaxial test, it is then found that under the condition that time is long enough, the volume of the specimen will shorten gradually and stable around a fixed value, and the amount of compression is essentially the half of the volume of void itself. it is also found that in stabilization by exert confining stress the linear phrase will be shorten in the figure of the static triaxial test of specimen, while the initial tangent modulus will be augment. 3

    在進行靜三軸以前先對瀝青混凝土件進行圍壓穩定,發現在時間足夠長的條件下,件的體積會逐漸縮小,並逐漸穩定在某一定值,其壓縮量基本上為其本身孔隙體積的一半;經圍壓穩定后的件靜三軸試驗曲線上的性階段明顯縮短,而初始切模量增大。
  9. Through analyzing and comparing, the results are presented below : that applying light structure design and selecting larger elasticity coefficient linear motor can improve greatly displacement output dynamic capability of positioning system and controlling precision of position motion, and this is helpful to meet the demand of increase productivity

    分析比較模擬試驗曲線可知:採用結構輕量化設計、選用較大彈性系數的直電機等可以大幅度改善定位系統的位移輸出動態性能,提高定應運動的控制精度,並有利於滿足設備高生產率的需求。
  10. According the field test of conduit with high embankment, this paper states the main cause of conduit damage is that the formula or the experience curves with a smaller earth. value of the top of conduit from calculation are used. in order to get rid of the damage the better means is that soft material paved on the top of conduit

    涵洞(管)縱向開裂病害存在非常普遍,本文結合高填土涵洞現場測,指出一些設計部門採用了計算值偏小的公式或經計算涵洞頂的垂直土壓力,是病害產生的主要原因,較好的解決措施是在涵洞頂鋪填壓縮性大於填土的柔性材料,可以大大減小洞頂垂直土壓力。
  11. 4. based on the theory - character parameter, this paper presents the theory equation for stress - stain complete curves of the rpc filled steel tube, it is founded that computed curves are in good agreement with the tested one, and it can be applied for the all course analysis of the rpc filled steel tube

    4 、基於上述圓鋼管rpc軸壓柱的理論特徵參數,推導建立了圓鋼管rpc軸壓柱應力應變全理論方程,該方程理論試驗曲線相當吻合,可用於圓鋼管rpc構件的全過程分析。
  12. ( 2 ) experiment analysis of swr soil moisture sensor because of cropland information excessive, ca n ' t experiment everyone, penman process soil containing water or moisture data experiment to vegetable terras cropland and gravel, prevailed experiment data, and draw experiment curve drawing of differ soil

    ( 2 ) swr型土壤水分傳感器的分析由於農田信息繁多,不能一一研究,故筆者只對菜地、田間、礫石地分別進行了土壤含水量,獲取了數據,並繪出了不同土質的試驗曲線圖。
  13. Textiles. testing of yarns. determination of the twisting of yarns

    紡織品.紗.紗加捻捲的測定
  14. The computational load versus deflection curves agree with the test results

    計算得到的荷載?撓度基本吻合試驗曲線
  15. Lastly, by comparison between calculation results of the three models and the test results, it has been found that the three models can all stimulate the softening and dilatancy characteristics of loess

    最後,將三種模型的計算試驗曲線進行比較,表明三種模型均能模擬土的軟化和剪脹特性。
  16. In the end, computer simulation of the test with ansys is given, together with hysteretic curve of simulation

    最後採用ansys對過程進行計算機模擬,給出了模擬的滯回,並與試驗曲線進行了對比。
  17. Basing on the pid simulation model, simulation test for multinomial coefficients and parameters is carried out, and simulation experimental curves are gained

    在該模擬模型基礎上進行了針對多項系數及參數的模擬,得到多組試驗曲線
  18. The paper has proved the correction of the methods & results of calculating by comparing the curved line of the loading - displacement of chs with that gained in experiments

    把本文計算的管節點的荷載位移與文獻的試驗曲線進行了比較,證了本文計算方法和計算結果的正確性。
  19. Damage evolution laws are analyzed by the load - unload tests. analysis results show that obvious damage occurs in the inner of the cemented soil stabilized with nanometer silica fume and the added nanometer silica fume can improve the damage

    研究表明,納米硅粉水泥土內部存在明顯的損傷現象,摻迦納米硅粉,水泥土損傷特性發生改變:與試驗曲線的對比結果表明,本文採用的損傷變量和損傷模型能夠較真實地反映納米硅粉水泥土的損傷特性。
  20. During the test procedure, the compliance test method is adopted to increase the load cyclically until the crack extends over the height of the specimen. then the record data are rationally smoothed and calibrated for next use, at the same time, the response on the tail of measured curve is expressed in mathematical function to eliminate its errorous influence on gf

    在測過程中採用了柔度測法以循壞的方式增加荷載直到件完全斷開,然後對試驗曲線進行了合理的光滑處理,並對試驗曲線的尾部進行了擬合表達盡量消除其對結果的誤差影響。
分享友人