試驗電極 的英文怎麼說

中文拼音 [shìyàndiànjí]
試驗電極 英文
test electrode
  • 試 : 名詞（古代占卜用的器具） astrolabe
  • 驗 : 動詞1. （察看; 查考） examine; check; test 2. （產生預期的效果） prove effective; produce the expected result
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 極 : i 名詞1 （頂點; 盡頭） the utmost point; extreme 2 （地球的南北兩端; 磁體的兩端; 電源或電器上電流...
  • 試驗 : trial; experiment; test
  • 電極 : electrode; pole
  1. Tests and analyses performed by experts and technical personnels show that, the brown coal used by hongwei power plant is extremly prone to produce reside in the process of power generation. this paper discusses the problem of burning residue in the coal fired boiler 410t / h of hongwei heat & power plant

    本文對宏偉熱電廠410t / h燃煤鍋爐的煤灰特性等進行了試驗分析，試驗結果表明，宏偉熱電廠燃用的褐煤是一種有嚴重結渣傾向的煤，運行中極容易結渣。
  2. First, a simple discussion for the mechanism about electrostatic atomization of the liquids has been given ; then the paper theoretically analyzed waving course, liquid drop producing course, and the liquid drop diffusing course in electrostatics atomization process., gave an analysis about the methods about carrying charges to the liquid drop, and analyzed that liquid with high electrical conductivity can be carried charges and atomized by electric field, while the isolated liquid with low electrical conductivity can be charged fully with the soakage electrode and inducing charge methods. at last the paper designed and configured the experimental equipment, conducted the atomization experiment to the three liquid medium - kerosene, emulsifier and alcohol under the same environment, handled the experimental results, then summarized the relationship between liquid electrostatic atomization effect and liquid surface tension, electronic conductivity and viscosity, along with the influence of voltage to electrostatic atomization and so on, found out the liquid atomization rule in high voltage electrostatic field

    首先，對液體介質的靜電霧化機理作了初步的探討，理論上分析了液體霧化過程中射流區、波紋區、霧滴區和霧滴擴散區;然後對液體荷電方法進行了研究分析，對于高電導率的液體，場致荷電和接觸荷電可以使其霧化，而對于電導率較低的絕緣液體，需用浸潤電極荷電和感應荷電方法使其充分帶電;最後，根據前面的研究分析，設計和組裝試驗裝置，在同一環境下對煤油、乳化劑、酒精三種不同液體介質進行高壓靜電霧化試驗，並對試驗結果進行分析處理，總結出液體靜電霧化與液體表面張力、電導率和粘度的關系及電壓對液體靜電霧化的影響等，得出高壓靜電場中液體霧化的一般規律。
  3. The membrane excitability of pc12 cells in experimental group is enhanced after 6d ' s culture as action potential can be elicited by depolarizing stimulus

    培養6天，試驗組pc細胞的膜興奮性提高，可在去極化刺激下發生動作電位樣的膜電位改變。
  4. This heating helps to break down weak spots in the dielectric that otherwise might pass through the electrode undetected, only to fail during a later spark or hipot test

    這熱量幫助擊穿電線絕緣較薄的地方?否則線材通過電極而沒有被檢測到?結果在以後的火花測試和高壓絕緣試驗將會失效。
  5. Standard test method for measuring transistor and diode leakage currents

    晶體管及二極體泄漏電流測量的標準試驗方法
  6. Since the current produced by light activated triode is larger, it is possible to use common microammeter to measure the photocurrent, making the experiment easier

    由於光敏三極體的光電流較大，測試光電流時，可用普通的電流表（微安表）進行測量，使實驗變得簡單可行。
  7. This project which is based on the demand of increasing the electron tube ’ s qualities totally and reducing the manufacture cost has done a large amount of investigative work as follows to improve and perfect the technologies for the important part of electron tube manufacture ? the grid surface processing : on the surface processing of the molybdenum grid, the primary purpose is to reduce thermionic emission and secondary electronic emission of the grid. by the constantly experiment and grabbling the different technology routes, we have successfully developed these new technologies on the tac and zrc electrophoresis and electroplating platinum black of the grid, and made its surface cladding quality very stable and reliable

    本課題是基於整體提高電子管的質量和降低生產成本的要求，對電子管生產中的重要部分? ?柵極的表面處理技術進行改進和完善，主要在以下方面進行了深入研究:在鉬柵極表面處理方面，主要為實現降低柵極的熱電子發射和二次電子發射，通過不同工藝路線的不斷試驗和摸索，成功開發出柵極電泳tac 、 zrc和電鍍鉑黑的新工藝，使柵極的塗覆質量穩定可靠。
  8. Railway fixed equipment. high speed unipolar circuit - breakers for direct current traction systems 750, 1500 and 3000 volts. characteristics and tests

    鐵路固定設備.直流電壓為750 1500和3000v的牽引設備的高速單極斷路器.性能和試驗
  9. The research and development and industrial test of aluminium electrolysis wetness cathode

    鋁電解可濕潤性陰極的研究開發與工業試驗
  10. Standard test method for measurement of soil resistivity using the two - electrode soil box method

    使用雙電極土壤箱法測量泥土電阻率的標準試驗方法
  11. The effects of various additives elements and doping methods on foam nickel electrode ' s performance were studied using constant current charge - discharge test. we compared two doping methods : mechanical mixing doping and chemical co - precipitation doping

    利用恆流充放電實驗等電化學測試方法研究了不同摻雜元素及摻雜方式對泡沫鎳電極的影響作用，對機械混合摻雜和化學共沉積摻雜進行了比較。
  12. Methods of sampling and test for carbonaceous materials used in aluminium manufacture - electrode pitch - determination of water content dean and stark method

    制鋁工業用炭素材料取樣與試驗方法.第1部分:電極硬柏油脂.第2節:水分測定
  13. This paper introduces a simulation experimental system of 3 - phase ac arc furnace, developing a dsp based electric - arc furnace electric pole fluctuation control system

    摘要介紹一種按照實際交流電弧的特性設計的三相交流電弧爐模擬試驗系統，針對電弧爐電極升降控制提出了一種基於dsp的控制方案。
  14. Predication of the insulation ageing for power capacitor according to the pole - to - case insulation partial discharge test

    極對殼絕緣局部放電試驗對電容器絕緣老化的評定作用
  15. Standard test method for conducting cyclic potentiodynamic polarization measurements for localized corrosion susceptibility of iron -, nickel -, or cobalt - based alloys

    鐵鎳鈷基合金的局部腐蝕敏感性的循環動電勢極化強度的試驗方法
  16. Standard test method for determination of contaminants in gas turbine and diesel engine fuel by rotating disc electrode atomic emission spectrometry

    轉盤電極原子發射光譜法測定氣輪機和柴油發動機燃料中雜質的標準試驗方法
  17. The sol - gel method and solid - state thermal reaction technique were used to prepare the composite oxides with variable lithium content. the doping treatments of some compounds were conducted. dta and tg were used to analyse synthesis mechanism, xrd to analyse phase composition, sem to observe morphology, li - b / licl - kcl / oxide simulated thermal cells to analyse the lithium - intercalation mechanism and properties of cathode material

    實驗中採用溶膠?凝膠工藝和固相熱反應技術制取相應的不同鋰含量的復合氧化物，並嘗試對某些化合物進行適當的摻雜處理，應用dta和tg分析合成機制、 xrd分析所得物的物相組成、 sem觀察其形貌，模擬li - b / licl - kcl /氧化物的單體熱電池來分析陰極材料的嵌鋰機制及其電極性質。
  18. The action of the combined brightener was studied by hull cell test, the determination of cathodic current efficiency and polarization curves

    通過赫爾槽試驗，電流效率及陰極極化曲線的測量研究了該光亮劑的作用效果。
  19. 2 for an impulse source there shall be a peak reading instrument voltmeter connected directly to the electrode head, indicating continually the potential of the electrode with or without a grounded test wire in the chamber

    脈沖火花機，電壓表直接接在試驗電極上，顯示的是測試電線沒有接地的情況下的峰值電壓。
  20. The main contributions to the study on the flashover of insulators in vacuum are as follows : 1. a set of test system for the studies on flashover of insulators in vacuum has been developed, which consists of vacuum system, electrode system, e - dot pulse voltage measurement system, surface charge measurement system, current monitor system and luminescence signal measurement system

    本文主要完成了以下工作： 1 .通過設計加工真空及試驗電極系統，研製e - dot沖擊電壓測量系統、真空中表面電荷測量系統、沖擊電流和表面微弱光信號測量系統，建成了國內第一套用於研究真空中絕緣子沿面閃絡現象的試驗平臺。
分享友人
分享到 Line

分享到臉書