試驗體積 的英文怎麼說

中文拼音 [shìyàntǐjī]
試驗體積 英文
test volume
  • 試 : 名詞（古代占卜用的器具） astrolabe
  • 驗 : 動詞1. （察看; 查考） examine; check; test 2. （產生預期的效果） prove effective; produce the expected result
  • 體 : 體構詞成分。
  • 積 : Ⅰ動詞（積累） amass; store up; accumulate Ⅱ形容詞（長時間積累下來的） long standing; long pending...
  • 試驗 : trial; experiment; test
  1. Three steps were involved : ? ) estimation of the ileum volume of the animal using single compartment model. ? ) measurement of the flex of each compartment. ? ) determination of the amino acid content of chymus of abomasums and ileum, and calculation of the amino acid digestibility

    試驗分為3步：一是測定回腸體積，二是測定各分域的流率，三是測定真胃和回腸食糜中氨基酸含量和計算小腸氨基酸消化率。
  2. Refractory ceramic fibre products - determination of bulk density

    體積密度試驗方法
  3. Standard test method for determination of isothermal secant and tangent bulk modulus

    測定等溫正割和正切體積彈性模量的標準試驗方法
  4. In the course of working, ， the plow will make use of the shuttling method so that it can dig alternately either on the left or on the right. compared to the unilateral plow, it can improve the productivity because it can help leave off the soil 、 take from the consumed energy and reduce the empty journey. to meet the requests above, we will use a remote cylinder with both a small cubage and double functions, approximately designing the plow to be columniform and symmetric. after the experiment for a period in the field, we found that the most frayed areas had happened at the places of both plow shank and share and at the same time the base of the remote cylinder had ruptured suddenly

    與單向犁相比，其優點在於：耕地無開、閉壟，地表平整，降低了耕后整地的能量消耗，減少了地頭的空行程，因而大大提高班次生產率。為了滿足犁體梭式作業的要求，我們採用了一隻小容積雙作用的液壓油缸；同時對犁壁曲面的形狀採用了近似圓柱形的對稱設計。但經過一段時間的田間試驗，我們發現：該犁犁胸部分的犁脛和犁鏵上的犁尖在工作中磨損較為嚴重；主犁梁和油缸缸體的連接部分（即油缸底座）突然發生了斷裂，造成整個犁體無法正常工作。
  5. A hundred and ninety - four test pieces are tested which involved six kinds of slenderness ratios and five cubic contents, and studies are done on the influence of cubic content and slenderness ratio to compressive strength, split strength and flexural strength of concrete, which lays the foundation of further study

    完成了涉及6種長徑比和5種體積摻量的194個試件的試驗，對短切玄武巖纖維體積摻量、長徑比等因素對混凝土抗壓、劈拉、彎拉強度的影響進行研究，積累了大量的數據，為進一步研究奠定了基礎、積累了經驗。
  6. So, this paper researches the principle of measuring system of insulating oil dielectric loss and volume resistivity. during the measuring process, the insulating oil must be heated and kept at 90 in 15 minutes. medium - frequency induction heating method is presented to instead of the electrical resistance furnace heating method on chapter 2, and a kind of subdivision - controlled integral - separated digital pid algorithm is designed to control the medium - frequency induction heating apparatus

    本文對恆溫控制系統進行了研究，提出了以中頻感應加熱方式取代原有的電阻爐加熱方式，設計了一種分段控制的積分分離式數字pid控制器來控制中頻感應加熱裝置，並通過通信設計將恆溫控制系統與介損及體積電阻率測試系統有機結合為一體機，實驗結果表明該恆溫控制系統完全滿足介損及體積電阻率測試中的控溫要求。
  7. Now there are many inspecting method of compound foundation bearing capacity, but most of them are base on the static load test or the original place test to obtain the compound foundation bearing capacity. these methods are time - consuming and laboursome, and they ca n ' t give the compound foundation a wide - ranging, integral inspection and evaluation

    目前，關于復合地基承載力的檢測方法有很多，但大多採用靜載試驗或原位測試方法獲取復合地基承載力，費時費力，而且不能進行大面積、整體的檢測和評價。
  8. The structure and operating principle of an air - charged split - type adjustable shock absorber was described, e non - linear parameterized mathematical model of this shock absorber ' s damping characteristics was established according to fluid mechanics theory and the main structural affection factors to shock absorber ' s damping performance, such as the diameter of piston valve orifice, the diameter of adjustable orifice, the initial volume of gas chamber, the diameter of piston rod, the inner diameter of oil pipe and so on, were analyzed by simulations

    摘要通過分析一種分體式充氣可調阻尼減振器的結構和工作原理，運用流體力學理論，建立了該減振器阻尼特性的非線性參數化模型，模擬分析了活塞阻尼閥孔徑、阻尼調節孔徑、氣室初始體積、活塞桿直徑、油管內徑等主要結構參數對減振器阻尼性能的影響，通過試驗測試，得到了減振器樣件的阻尼特性及其可調范圍。
  9. Standard test method for determining volume fraction by systematic manual point count

    用系統的人工逐點計數法測定體積因數的標準試驗方法
  10. Test method for measuring sleeping bag packing volume

    測定睡袋包裝體積的試驗方法
  11. The results of experiment on the relationship between tensile strength, shrinkage, self - desiccation shrinkage and flat restraint cracking show that sra ' s physical shrinkage - reducing effect and ea ' s chemical expansion effect greatly enhance the volume stability of concrete and reduce the probability of early - cracking

    對減縮劑與膨脹劑抗拉強度、干縮、自乾燥收縮及平板約束開裂的試驗結果表明： sra的物理減縮作用及膨脹劑的化學膨脹作用，大大提高了混凝土早期的體積穩定性，降低了早期開裂的概率。
  12. In the field of calculating the distance of two points in the body internal organ image and in the field of calculating the volume of body organs, we test a new method - stereology, and provide reference experience of the application of stereology in the medical field

    在計算臟器斷層截面上某兩點間距及計算三維臟器的體積方面，我們嘗試應用了新的方法? ?體視學的方法，對體視學在醫學領域的應用提供了參考經驗。
  13. The geometrical model built in the scale of representative volume unit is wildly applied and is justified by mechanical experiment

    建立在代表性體積單元尺度的幾何模型應用最為廣泛，得到了力學性能的試驗驗證。
  14. It is found that the appropriate lowering of the chamber temperature of water gas producer and the thickness of coal bed is favorable to controlling the volume fraction of o2 and co in the recovered flue gas

    通過試驗與分析，發現適當降低水煤氣發生爐爐溫與煤層厚度，有利於控制回收煙氣中o2及co的體積分數。
  15. Static and dynamic trial experiments indicate that the system, not only can well simulate the prime governor and self _ equilibrium characteristics of a prime mover with its simple hardware line, small size and versatility, but also can highly improve the whole system ' s control precision, reliability and stability when compared with the system design of the analogy circuits

    靜態、動態測試實驗表明：該控制系統，不僅硬體線路大為簡化、體積小、通用性強，能夠很好地實現對原型調速器及原動機自平衡特性的模擬，而且與模擬電路的設計方案相比，整個系統的控制精度、可靠性和穩定性等大幅度提高，具有明顯的優勢。
  16. Secondly, paper introduces the composition structure and the manufacture craft characteristic of airplanes, describes the structure and the main assembly process and the assembly characteristic of the n # fuel tank section, points out the assembly accuracy control of the n # fuel tank section. thirdly, paper analyses in detail problems which exist in the current riveted assembly of the n # fuel tank section, proposes the improve measures against the existent problems. finally, paper forecasts in theory the positive effect that the new plan will bring, introduces the practical result after approval test, analyses the differences of both

    具體做了以下幾方面工作:第一，詳細闡述了工作研究的基本原理;第二，介紹了飛機的組成結構、飛機製造工藝的特點、 n #油箱段的主要結構、 n #油箱段的主要裝配過程、 n #油箱段的裝配作業特點和n #油箱段的裝配準確度的控制方法;第三，具體分析了n #油箱段鉚接裝配生產線現行作業中存在的問題，針對存在的問題，提出了具體的改進建議，並形成了新的改進方案;第四，從理論上預測了新方案將會帶來的積極效果，介紹了新方案在現場試驗驗證的實際結果，並對兩者之間存在的差異進行了對比分析與研究。
  17. Specification on evaluation methods of hazards of liquid chemicals transported in bulk by shipping - bioaccumulation testing method for aquatic organism

    船舶散裝運輸液體化學品危害性評價規范水生生物積累性試驗方法
  18. Creep specimens ( different braiding structure, surface braiding angle, fibre volume content and under different loads ) were tested, which is the basis of studying their creep behaviors

    並對不同編織結構、不同編織角、不同纖維體積含量、不同應力水平的三維編織復合材料試樣進行了蠕變行為測試實驗。
  19. On the base of the iec standard of dc suspension insulators, we designed a new ion migration test for 500kv dc ceramic support insulators, including the regulation between the bulk resistance and the temperature, the test samples, the test voltage and the temperature for long - term ion migration test, and the amount of accumulative charges

    以懸式絕緣子離子遷移試驗標準為基礎，完整的設計了500kv直流支柱式瓷絕緣子離子遷移試驗，其中包括研究了試品體積電阻隨溫度場強變化的規律，成功的設計了試驗試品，確定了長期離子遷移試驗電壓（ 40kv ）和試驗溫度（ 130 ） ，計算了50年累計電荷量（ 0 . 173c ） 。
  20. Physical testing of rubber - determination of volume resistivity

    橡膠的物理試驗.體積電阻系數的測定
分享友人
分享到 Line

分享到臉書