調度指令 的英文怎麼說

中文拼音 [diàodùzhǐlìng]
調度指令 英文
standard command,instruction command
  • 調 : Ⅰ動詞1 （配合得均勻合適） harmonize; suit well; fit in perfectly 2 （使配合得均勻合適） mix; adju...
  • 度 : 度動詞[書面語] （推測; 估計） surmise; estimate
  • 指 : 指構詞成分。
  • 調度 : 1 （調遣） dispatch （trains buses etc ） 2 （調度員） dispatcher 3 （安排） manage; control 4 （...
  • 指令 : 1 （指示; 命令） instruct; order; direct2 （上級機關對下級機關的指示） instructions; order; direc...
  1. In this thesis, we focused our attention on demodulation and digital signal processing ( dsp ) technique in the dpsk differential detection system used in pico - satellite test and control instructions, mainly from the point of view of software

    論文圍繞皮衛星通信中測控指令的dpsk差分解調系統，重點從軟體角度對通信解調技術和數字信號處理的一系列問題進行了實踐和研究。
  2. When solving the tna problem based on fleet dispatching commands, a stage - assignment algorithm is build to overcome the defect of fifo algorithm, which can be widely applied to cope with fixed job scheduling problem. 3

    在解決基於飛機調度指令要求的飛機排班問題時，本文提出的分階段指派演算法較好地克服了標號演算法的缺陷，該演算法能普遍地應用於處理類似的固定工件排序問題。
  3. Based on these two factors mentioned above and the difficulty to implement in c compiler, this paper proposed a method of modifying operand type by inserting instruction lw or sw at assemble level as well as instruction scheduling. therefore, this can generate effective parallel instructions and correspondingly improve the performance and density of object code

    本文在分析了上述兩個限制并行指令生成的主要因素以及很難在編譯器中實現并行指令生成的基礎上，提出了在匯編級檢查指令的操作數類型，通過插入lw或sw指令來改變操作數類型及指令調度的方法，能夠有效的生成并行指令，提高了代碼運行效率和代碼密度。
  4. This thesis makes use of instruction split, delay - slot scheduling and peephole optimization in porting. the new cross - compiler system, zltcg, not only supports the new target but also absorbs the old system ' s advantages on code optimization and portability. at first, this thesis describes the developing history and theories of compiler, especially on its architecture, bootstrapping and porting

    本文根據新目標機的特點，利用了指令拆分，延時槽調度，窺孔優化等技術，既實現了對新目標機的支持，又吸收了原有系統高度優化和可移植的優點。
  5. These included number of directory services calls, number of database calls, amount of memory used, and path length number of instructions executed

    其中包括目錄服務調用數、數據庫調用數、內存使用量和路徑長度（執行的指令數） 。
  6. Figure 3 shows the four metrics that we tracked for each single click analysis : number of instructions, memory, number of directory services ldap calls, and database calls

    圖3展示了為每個單擊分析跟蹤的四個度量：指令數、內存、目錄服務（ ldap ）調用數和數據庫調用數。
  7. In this paper, a new control strategy based on the adaptive deadbeat voltage space vector is presented. this control scheme has a lower sample frequency and a smaller difference between switch frequency and sample frequency. it has many advantages, such as producing zero vectors organically, tracing exactly, non - shaking, etc. and its dynamic response is better

    對于電能質量調節器來講， pwm跟隨指令參考信號的控制性能在很大程度上影響著裝置的補償效果，本文選擇無差拍電壓空間矢量控制為系統控制策略，這種控制方法具有采樣頻率低，開關頻率與采樣頻率的差距小，能有機地產主零矢量、跟蹤精確以及無抖振等優點，動態響應快。
  8. Firstly, a 0 - 1 integer programming mathematical model is constructed to describe tail - number - assigning work happened in domestic airline, since the problem is npc, a unified polynomial algorithm which satisfies engineering requirement is unavailable. illuminated by the practical experience, a specific tna problem is classified into one of three typical tna modes : tna based on fleet dispatching commands, tna based on fleet balance application, tna based on minimum fleet requirement ; secondly, by simplifying and relaxing some minor constraints, corresponding mathematical models and heuristic algorithms are reconstructed for each typical tna mode ; finally, computing complexities are discussed

    為此論文在借鑒手工編制排班計劃經驗的基礎上，將一個具體的飛機排班問題，歸結為三種典型排班模式中的一種，即：基於飛機調度指令要求的排班問題，基於飛機使用均衡要求的排班問題和基於最少需用飛機數的排班問題，對于每種典型的飛機排班模式，在對次要的約束條件進行簡化、松馳的基礎上構造出相應的能夠滿足工程應用要求的啟發式演算法，並分析了演算法的復雜性。
  9. Superscalar risc microprocessor is the further development of reduced instruction set computer, it improve the instruction - level - parallism by means of adding parallel pipelining function units and dynamic on - chip scheduling. this thesis anslysises the architecture and the diversified techniques of superscalar computer

    超標量risc微處理器是精簡指令結構（ risc ）的進一步發展，它通過增加并行流水執行單元並結合片上硬體動態調度來提高指令并行度。
  10. In addition to bypassing the complexity of building a kernel to emulate and a file system image to boot into, and configuring a virtual network device for io, this shortcut also speeds up emulation, as the reams of kernel instructions that would have run to handle the system call - from the exception handler through the vfs and the device driver - are bypassed

    除了繞開構建一個用於模擬的內核和一個用於啟動到其中的文件系統鏡像，以及為io配置虛擬網路設備的復雜性之外，這條捷徑還加快了模擬的速度，因為繞開了從異常處理程序到vfs再到設備驅動程序的很多內核指令，而這些內核指令本來就是用來處理系統調用的。
  11. The fixed - point dsp program is given which are based on the analysis in the feather of the video signal and the 16 - bit fixed - point dsp - - tms320c5402. at last, the result and quantity of calculation are analyzed to prove that the speed and precision of calculation are matched to the system requirement

    在深入分析了線性調頻脈沖壓縮信號產生過程和特性的基礎上，結合16位定點dsp ? ? tms320c5402的硬體結構和指令系統的特點，編寫了定點dsp程序，並對程序的計算量和計算結果進行了分析，表明演算法的速度和精度都可以滿足系統的要求。
  12. Here a delaying - allocation optimizing strategy is proposed, it adopts a coarse - grained adjustment of the stack frame. at the call site allocations, the caller ’ s stack frame is reduced according to the actual usage while the callee only be allocated a limited stack frame, consequently, the potential spill is reduced to the best advantage

    本文提出一種基於延遲分配的棧寄存器分配策略，為了減少額外代價，採用粗粒度的棧幀調整策略，在調用點處使用alloc指令調整調用者的棧幀大小，並為被調用過程分配部分棧幀，在調用點處從調用者和被調用者兩個角度盡量縮減各自的棧幀，從而減少棧幀的溢出。
  13. To improve visual tracing precision and environment adaptability, it presents a method of soccer robot visual tracing based on action - vision coordination. the method validates the coherence of target action and command by vision. it can keep uninterrupted tracing in visual blind area, and correct the target tracing error

    為提高多目標視覺跟蹤的準確度和環境適應能力，提出一種基於動作視覺協調的多目標視覺跟蹤方法，通過視覺驗證目標動作與廣東工業大學工學博1學位論義指令的一致性，保持目標在視覺盲區的連續跟蹤，並能糾正目標跟蹤錯誤。
  14. Directives to thread scheduling at the application level

    應用程序級別的線程調度指令
  15. The traditional transmission mode of electric power production information is drawing, report form, instruction, which is time - consuming and strenuous

    傳統的電力生產信息的傳遞模式是圖紙、報表、調度指令，這種信息傳遞方式費時、費力。
  16. If the execution of contingency dispatch directives causes damage to the artificial coal gas and natural gas producing enterprise, the municipal or county / district people ' s government shall make appropriate compensation

    執行應急調度指令造成人工煤氣、天然氣生產企業損失的，市或者縣（區）人民政府應當予以適當補償。
  17. Article 74 any staff member or employee of an electric power enterprise who violates rules and regulations, makes a dispatch contrary to regulations, or disobeys the dispatch order and thereby causes a serious accident, shall be prosecuted for criminal liability according to provisions of article 114 of the criminal law

    第七十四條電力企業職工違反規章制度、違章調度或者不服從調度指令，造成重大事故的，比照刑法第一百一十四條的規定追究刑事責任。
  18. The chapter one of the thesis introduces the development status of the present digital program exchange system and the main task of devising a new console ; chapter two gives the relevant theories about channel encoding ; chapter three simply introduces digital program exchange system named nd120 ; chapter four presents how to find out relevant data ; chapter five and six describe in detail the hardware structure and software structure of the new console respectively ; chapter seven demonstrates in detail the new interface of this console

    論文第一章介紹了數字程式控制調度交換系統的發展現狀和設計新型調度平臺需做的主要任務;第二章詳細介紹了調度平臺的總體設計及相關的通道編碼理論;第三章簡要介紹了nd120數字程式控制調度交換系統;第四章描述了調度指令的提取過程;第五章和第六章分別介紹了新型調度平臺的硬體結構和軟體結構;第七章則詳細描述了調度平臺介面的設計過程，這也是本文的主要創新點。
  19. Therefore, in order to ensure system real time needs and decrease software power consumption of wearable computing system, this thesis proceed the research from two parts : one is seeking low power consumption design to achieve efficient running via choosing and applying instructions ; the other is adopting the proceeding optimization attemperment to realize efficient and low power consumption software attemperment

    在基本保證系統實時需求，並有效地減小可穿戴計算系統的軟體能耗的目標前提下，本文嘗試從指令和程序設計上進行低功耗設計方法的研究。針對指令級別，本文希望藉助指令的低功耗選用與執行，實現高效運算的低功耗設計。針對程序設計，本文嘗試採用進程優化調度的方式，實現可穿戴計算系統低功耗且高效的軟體調度。
  20. The system is based on chopper constant current drive technique, according to the top level design idea, adopting advanced specical subdivision control integrate circuit and powerful function 80c196kc to organize the system frame, desiging the minimum system of single - chip microcomputer, multifunction i / o interface circuit, relay switch circuit, keyboard and display circuit, multifunction digital setting interface circuit and so on, utilizing the hso and hsi interface circuit which are owned by this single - chip microcomputer exclusively and its powerful command system to realize dual - degree switch control, automation orientation, automatically searching zero position, locking machine when stopping, frequency to set digitally, automatically adjusting speed through changing frequency, swithing subdivision or squarewave control, on the basis of above, the system also have the function of running according to the setting steps and the frequency, voltage and current to display through the led, etc

    系統基於斬波恆流驅動技術，按照頂層設計思想，採用先進的專用細分控制電路和功能強大的80c196kc單片機來組建系統構架，設計了單片機最小系統、多功能i o介面電路、繼電器切換電路、鍵盤顯示電路和多功能數字設定介面電路等，利用該單片機獨有的hso和hsi介面及其強大的指令系統，實現了雙余度混合式步進電動機的余度切換控制、自動定位、零位自動搜索、停機鎖定、數字化頻率設定、自動調頻變速控制、細分方波切換控制，在此基礎上，該系統還設有按預置步運行、 led頻率電壓相電流顯示等功能。
分享友人
分享到 Line

分享到臉書