調整孔 的英文怎麼說

中文拼音 [diàozhěngkǒng]
調整孔 英文
access
  • 調 : Ⅰ動詞1 （配合得均勻合適） harmonize; suit well; fit in perfectly 2 （使配合得均勻合適） mix; adju...
  • 整 : Ⅰ形容詞1 （全部在內; 完整） whole; all; complete 2 （整齊） neat; tidy; orderly Ⅱ動詞1 （整理; 整...
  • 調整 : adjust; tune up; trim; trimming; variation; modulation; arrangement; debug; rectification; redres...
  1. Can adjust polishing medias, prevent parts from colliding, polish hole and gap of parts to reduce polishing cost of low relievo jade article

    可調整拋光介質，避免工件的的互相?撞，使工件上的孔隙溝縫?得以拋光，從而降低淺浮雕類的玉器拋光成本
  2. Aiming at the problem that the seeds picked up by the suction plate of the seed metering device cannot accurately fall into the seed pit opener as well as into the seed pit, an innovated seed metering device on which the seed dropping angle can be adjusted within a certain range and a new testing stand have been developed in accordance with the mathematical calculation model that had " in accordance with the mathematical calculation model that had been established previously. then an experimental study is conducted and the seed dropping law has been found out through the study

    本論文根據2bqm - 2型氣吸式精量鋪膜播種機的結構和工作原理，針對該機在實際播種中，吸種盤吸出的種子不能滿足準確地落入在膜上滾動開穴的鴨嘴內，並及時地排入到鴨嘴所成的穴孔內的設計要求，進行了一定的試驗研究，利用已建立的計算數學模型，設計新的試驗臺，改進排種器，使排種器的落種角度可以在一定的范圍內調整。
  3. Manage all the machine spare parts stock and ordering issues, sourcing supplier for all metal spare parts such as aiguilles, blades, etc

    調整，管理機械零部件庫存，尋找機械零部件，如鉆孔器，刀具的供應商。
  4. In blasting experiments, durations of subordinate basting seismic waves and intensity of influence among them are changed by adjusting the number of subordinate blasting, explosive weigh of subordinate blasting, total quantum of explosive, interval, hole - net parameters and wave resistance of rock, etc

    摘要在爆破實驗中，通過調整段數、分段炸藥量、炸藥總量、間隔時間、孔網參數、巖石波阻等爆破相關因素，以改變各分段爆破地震波持續時間、段別間爆破地震波重疊程度來研究爆破地震強度與爆破相關因素間的相互關系。
  5. If pre - drilling mode was taken in an offshore oil development, pgb - free well drilling technology might be adopted for supplementary wells when the pgb slots were totally occupied

    摘要採用預鉆井方式開發的海上油氣田，對水下鉆井基盤鉆井槽孔用完后增鉆的調整井，可採用無基盤鉆井方式作業。
  6. Railway transport equipment. unbored axles with threaded and slotted ends. tab washers

    鐵路運輸設備.帶螺紋端頭和帶槽端頭的未鉆孔軸.調整墊片
  7. A tapered steel pin for enlarging and aligning holes

    打孔器用來擴大或調整孔洞的尖鋼針
  8. The paper researches the relations between blasting effect and blasting parameters, including diameter of drill, non - coincidence coefficient, hole spacing, hole row - spacing, cartridge diameter, charge per hole, density of line charge, charging structure and detonating manner, and how to adjust the blasting parameters to get the best blasting effect under the given geological condition

    本文在重慶市某高速公路合同段進行了現場預裂爆破試驗的基礎上，研究了炮眼直徑、不耦合系數、炮孔間距、炮孔排距、藥卷直徑、單孔藥量和線裝藥密度、裝填結構、起爆方式等爆破參數與爆破效果之間的聯系，以及如何在給定的地質條件下調整爆破參數獲得最佳的爆破效果。
  9. The advantage is that we work without any risk of breaking taps on particularly expensive work pieces and it saves also a lot of time by simplifying tapping operations

    這種夾頭的優勢：在鉆孔和攻絲的轉換的時候，只要更換轉換接頭就可以了，不需要再做其他的調整，帶有扭力保護的轉換接頭可以避免絲錐的斷裂，同時還可以節省很多的時間。
  10. Remember the following words and expressions : e. g. multimeter ； circuit ， current ； voltage ； resistance ； digital multimeter ； analogue multimeter ； analogue multimeter scales ； zero adjustment control ； zero adjustment control for resistance ranges ； measurement ranges switch ； transistor test socket ； meter probe ； positive terminal ； negative terminal ； anode ； cathode ； red lead ； black lead ； power supply ； connect in parallel ； connect in series

    記住萬用表、電路、電流、電壓、電阻、數字萬用表、模擬萬用表、表頭、機械零位調整器、歐姆零位調整器、量程選擇開關、晶體管插孔、表棒、正接線端、負接線端、陽極、陰極、紅導線、黑導線、電源、並聯、串聯等常用英文單詞，並逐步掌握。
  11. The experiment results show that the samples can not be sintered when the addition phases were in a very low level, and their strength and thermal shock resistance performance were neither, there were too much liquid phase created when the addition phases were in a high level, it can decrease the pore rate of the samples, and the space for structure adjusting during thermal shock, resulting in the decrease of their thermal shock resistance performance

    實驗發現，當外加劑含量較少時，樣品的燒結程度低，強度不理想，抗熱震性能不好。外加劑含量過多則生成過多的液相，使樣品的氣孔率大大減小，減少了材料在熱沖擊過程中的結構調整空間，從而降低了材料的抗熱震性能。
  12. It is found that changing of catalyst and solvent will influence the relatively reaction velocity of hydrolysis and polycondensation and therefore change the pore structure of resulted silica gel glass matrix. as the result, the ideal prescription for silica gel glass matrix is proposed

    確證通過調整催化劑和溶劑的種類及控制乾燥化學試劑的添加，可以改變水解和縮聚反應的相對速率，有效實現對硅氧凝膠玻璃基質孔結構的裁剪與設浙江大學博士學位論文計。
  13. New becomes the hole material as the ceramic cement blowholegrinding wheel, the - fine naphthalene compares with traditional chengkongji, has the blowhole to be even, does not have merit and so onpollution, odorlessness, easy to operate, price small advantage, alsomay wilfully adjust to the grinding wheel blowhole size

    作為蜂窩陶瓷製品和陶瓷結合劑氣孔砂輪的新型成孔材料，與傳統的成孔劑?精萘相比，具有氣孔均勻，無污染、無氣味、使用方便、價格便宜等優點，且對砂輪氣孔大小可任意調整。
  14. The surface roughness of the fabricated micro - optics structure is in the nanometer range ; the feature height of the diffractive phase step is in the sub - micrometer range ; and can be adjusted according to requirements ; and the optical aperture of the microlens can be changed from millimeter to centimeter magnitude

    所制微光學結構的表面粗糙度在納米量級，衍射相位臺階的高度在亞微米量級並可以根據需求靈活調整，通光孔徑在毫米至厘米量級的范圍內可調。
  15. This charged fiber can be directed or accelerated by electrical forces and then collected in mats or other useful geometrical forms. the diameters of electrospun fibers are in the range of tens of nanometers to several micrometers. in this paper, polyacrylonitrile ( pan ) nanofibers are made by electrospinning pan / dimethylformamide ( dmf ) and pan / dimethylacetamide ( dmac ) with adjusting the main process parameters including electrostatic voltage ( 20 ~ 50kv ), sprinkler aperture ( 0. 5 ~ 0. 8mm ), collection distance ( 15 ~ 25cm ), solution concentration ( 6 wt % - 14 wt % )

    本文主要對聚丙烯腈（ pan ）二甲基甲酰胺（ dmf ） 、 pan二甲基已酰胺（ dmac ）體系進行電紡絲，調節靜電壓（ 20 50kv ） 、噴頭孔徑（ 0 . 5 0 . 8mm ） 、接收距離（ 15 25cm ） 、溶液濃度（ 6wt 14wt ）等過程參數，制得pan納米纖維，纖維平均直徑在200 1000nm ；詳細分析了過程參數對纖維細度、形態等的影響，認為高聚物溶液濃度及靜電壓對纖維細度有決定性影響，其它過程參數如接收距離、噴射孔徑、紡絲溶液溫度、溶液電導率等的調整應以這兩參數為基礎進行。
  16. ( 3 ) the free - standing porous silicon films with continuous porous structure were prepared on single crystal silicon wafer by the method of anodic oxidation and electrochemical etching - electropolishing, and firstly used as the anode materials for lithium ion secondary batteries. the capacities of lithium ions storage and the process of charge and discharge of this nano - silicon anode materials as well as the influence of the structure of ps on behavior of storing lithium ions were inspected at length. on the other hand, through the process of charge and discharge in cells, the lithium of light metal element could be electrochemically doped into ps at different doping levels

    胡勁松河北師死大學碩士學位論文（ 3 ）利用陽極氧化法在單晶硅基底上制備了多孔硅自支撐膜，並首次將這種具有連續多孔結構的硅材料用作了理離子電池的陽極材料，考察了這種納米級硅陽極的儲鉀性能和充放電過程，分析了材料結構對其儲理行為的影響；另一方面，利用這種電池充放電過程在多孔硅中電化學引入了不同點綴程度的輕金屬鉀元素，考察了鉀點綴對多孔硅自身結構，及至性質所帶來的影響，提供了一種通過電化學方法插入埋離子從而連續調整多孔硅發光性質的有效方法。
  17. Drilling track is key factor which decide trenchless success or failure, but controlling drilling track stay around rectifyed phase at the present. guided the theory of force is the key affectting the drilling track, the paper discuss primary factors on contralling drilling track, and advance the formulary ahout reckoning deviation force and azimuth force, expect to achieve the aim that drilling track were controled real time and be anticipated, and have the initiative on drilling track contaolling

    巖層鉆進軌跡是決定非開挖成敗的關鍵因素，目前對鉆孔軌跡的控制僅僅停留在被打糾偏層面上，本文在力是影響鉆進軌跡本質因素理論指導下，對影響巖層鉆進軌跡控制的因素進行了理論探討，並針對造斜力和變方位力提出了計算模式，希望最終能實現鉆孔軌跡的實時監控與調整，變被打糾偏為主動鉆進。
  18. Pls adjust size of garment button hole to the size of button

    請根據扣的尺寸調整孔的大小。
  19. With the coated tih2, the foaming process of aluminum has been researched in the laboratory. the results indicate that the weight of foamer and viscosity increaser sending to the melt aluminum, the time of agitation and holding at foaming temperature, will influence the structure as well as porosity of foam aluminum, so that the structure of foam aluminum can be adjusted by improvement technology parameter which is practical

    西安理工大學工程碩士學位論文利用包覆的發泡劑在實驗室對發泡工藝進行了研究，結果表明發泡劑的加入量、增粘劑的加入量、攪拌及保溫時間都對制備泡沫鋁的孔隙率和孔結構有明顯影響，因此，通過調整工藝條件，可以調節泡沫鋁的結構。
  20. Mega - truss - suspended steel tall buildings provide abundant design freedom to architects, also promote their creativities. take advantage of the suspended floor, space hole can be placed through building in variable form and at different position

    由於該結構用懸掛體系構成內部樓層，可實現在空間不同位置設置大型孔洞，通過調整孔洞的位置、形狀、大小，可顯著減小結構的風荷載和風振響應。
分享友人
分享到 Line

分享到臉書