諧振電位 的英文怎麼說

中文拼音 [xiézhèndiànwèi]
諧振電位 英文
resonance potential
  • 諧 : Ⅰ形容詞1 （和諧） in harmony; in accord; in tune 2 （詼諧） humorous Ⅱ動詞（商量好; 辦妥） come t...
  • 振 : 動詞1. （搖動; 揮動） shake; flap; wield 2. （奮起） brace up; rise with force and spirit
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 位 : Ⅰ名詞1 （所在或所佔的地方） place; location 2 （職位; 地位） position; post; status 3 （特指皇帝...
  1. The ring laser gyro ( rlg ) is a new photoelectric inertia sensor based on the optic interference theory. it uses the difference between the frequency of the two beams of light, which run in the opposite direction in the resonant cavity, to measure the carrier ’ s rotate speed and the orientation in the inertial space

    環形激光陀螺儀（ ringlasergyro ，簡稱rlg ）是以光學干涉原理為基礎發展起來的新型光電慣性敏感儀器，它利用環形諧振腔內順、逆運行的兩束光的諧振頻率差來測量載體對于慣性空間的轉速和方位。
  2. A transition of microstrip to waveguide based on siw technique was processed with ltcc to validate the feasibility of siw. then, a siw resonator was analyzed. the equivalent electrical wall of metallized via arrays was obtained

    從對空氣填充siw諧振器的分析，得到在ferroa6m材料中構成諧振器的金屬排孔等效電壁的位置，得到簡化的計算siw諧振器的模型。
  3. Abstract : a new waveguide which can change the wide wall of a rectangular waveguide into a symmetric arc wall is named as a cam - rectangular waveguide. comparing to sectoral waveguide, the new waveguide has the same voltage characteristics and is easier to be produced and fixed. an approximate formula of the dominant mode fields and the normalized conductance of a longitudinal resonant slot cut in the curved wall of a cam - rectangular waveguide are given. a resonant slot linear array in c & x band is designed, in which the slot voltage distribution is equiphase and the input is matched. the input voltage stationary ware ratio and the h - plane pattern of the antenna are measured. the experimental results show the conformance with theoretical results

    文摘:把常用的矩形波導一個寬面改成圓弧形構成的波導稱為圓突-矩形波導.這種波導與扇面波導相比：電性能相當；波導管結構更加簡單，容易加工，便於安裝.文中給出圓突-矩形波導中主模場，圓曲面上縱向槽歸一化諧振電導近似公式.設計了c和x波段波導曲面縱向諧振縫隙線陣，縫隙電壓相位為同相分佈，輸入端匹配.實際測量了天線輸入端電壓駐波比和h面方向圖，理論與實驗相吻合
  4. Application of signal injection method for fault line selection and fault point location in resonance grounding system

    選線定位原理在諧振接地電網中的應用
  5. In order to eliminate the voltage oscillation caused by the reverse recovery of the rectifier diodes, a resonant inductance and two clamping diodes can be introduced to the primary side

    為了消除輸出整流管的電壓尖峰，可以在原邊加入一個諧振電感和兩個箝位二極體。
  6. We decided to use the axial polarized model as our investigate object after comparing. with theoretical and emulational methods, we studied the properties of cymbal transducer are dependent of the dimensions of metal endcaps and pzt thinner circle plate. and obtained the optimized dimensions

    採用理論和有限元模擬相結合的方法，研究了金屬端蓋和壓電陶瓷片（ pzt ）的形狀參數對cymbal換能器的縱向位移及諧振頻率等性能的影響，確定了試樣的最佳形狀參數。
  7. Dr is made of microwave ceramic with high dielectric constant and very low loss. using dr, the phase noise of an oscillator could be made to be extremely low

    介質諧振器（ dr ）由高介電常數、低損耗的微波陶瓷材料製作而成，它能極其容易地實現微波頻率源的低相位噪聲。
  8. 3. compared and analyzed the influences to the mode of the electro - magnetic field and also the influences to the position where the plasmas produced when changes the size and the internal structure of the cavity

    3 .比較分析了諧振腔的結構尺寸及其內部構造改變對電磁場模式的影響，等離子體在腔體內部的產生位置。
  9. In 3. 1 the reflection characteristic of f - p cavity is presented. in 3. 2 the optical - electronic modulation is introduced and the technique of how to make a resonant eom is discussed also

    3 . 1從理論上分析了f - p諧振腔的特點， 3 . 2討論了電光相位調制的特點，介紹了共振型電光相位調制器的製作。
  10. 2 through altering the length of the resonator, more clear resonator characteristic is observed, which proves that using the method of altering the length of the resonator may be a better way that using current injecting frequency modulation

    浙江大學碩十學位論文2 、川改變諧振腔腔長的方法，觀測到了更為清晰的諧振曲線。證明采川改變腔長的方法來實現調頻，比采川電流調頻的方法可能更為優越。
  11. The clamping diodes conduct only once in a switching period, and the resonant inductance current is smaller in zero state, leading to a higher efficiency and reduced duty cycle loss. the operation principle of the improved converter and the comparison with the original converter are analyzed in this paper. the effect of the blocking capacitor in series with the transformer or resonant inductance is discussed, and a best scheme is determined

    本文將諧振電感和變壓器交換位置，使變壓器與滯后橋臂相連，這樣箝位二極體在一個開關周期中只導通一次，同時零狀態時諧振電感電流較小，有利於提高變換效率和減小占空比丟失，本文分析改進后變換器的工作原理，並與改進前的變換器進行對比，討論隔直電容在不同位置對變換器工作的影響，確定一種最佳工程方案。
  12. The system can generate sweep frequency signal with frequency range from 100khz to 150mhz and power range from - 40dbm to + 18dbm, and measure the gain and phase of the crystal. according to the gain and phase information and the iec - 444 standard, crystal parameters can be calculated, such as nominal frequency, series resistance, shunt capacitance, motion capacitance, motion inductance, q factor and so on

    該系統能產生頻率范圍達100khz 150mhz ，功率范圍為? 40dbm + 18dbm的掃頻信號，並能對晶振的增益和相位差進行測量，其測量結果按照iec - 444晶振測量標準進行實時處理和計算，從而得到晶振的串聯諧振頻率、並聯諧振頻率、等效電阻、靜態電容、動態電容、動態電感和品質因數等主要電參數。
  13. This structure possesses common spectra gaps with transverse - electric surface waves and transverse - magnetic surface waves, a multiple of in phase frequency regimes to characterize magnetic resonances are also within those spectra gaps, which were detected both by measuring return loss of an antenna near the surface and by fdtd simulations

    實驗和數值模擬顯示這類表面的橫電模式極化和橫磁模式極化的表面波具有多帶隙的豐富能帶結構，同時它還有多個磁性諧振頻率，實驗和理論顯示這些磁性諧振所對應的多個同位相反射區落在兩個表面波帶隙中。
  14. Measurement of quartz crystal unit parameters by zero phase technique in a - network ; part 2 : phase offset method for measurement of motional capacitance of quartz crystal units

    用型網路的零相位技術測量石英諧振器參數.第2部分:測量石英諧振器的動態電容的相位偏離法
  15. 30 mhz measurement of quartz crystal unit parameters by zero phase technique in a pi - network - part 4 : method for the measurement of the load resonance frequency fl, load resonance resistance rl and the calculation of other derived values of quartz crystal units, up to 30 mhz

    用型網路的零相位法測量石英晶體元件參數.第4部分:石英晶體單元負荷諧振頻率fl負荷諧振電阻rl的測量方法及其他石英晶體元件導出值的計算方法
  16. On the aspect of errors analysis of hrg, a brief introduction of the close - loop detection theory of hrg is present first. later the expressions of close - loop detection errors are deduced in theory. the impact of stimulating signals, turning speed, outside appended oscillation, the location & area of electrodes, and the current loss in capacitor is considered, and the primary analysis of error compensation is given

    在半球諧振陀螺誤差分析方面，本文從半球諧振陀螺的閉環檢測原理出發，對半球諧振陀螺閉環檢測誤差進行了分析和推導，考慮了激勵信號、轉動速率、外界附加振蕩、電極位置及極板面積和電容傳感器等因素造成的陀螺誤差並對誤差補償進行初步分析。
  17. In this paper, the operation principle of the oscillator is analyzed first, from the point of view of theory the designs of crystal resonator and its equivalent circuit, crystal oscillator and thermostatic chamber are defined. the noise model of circuit is used to analyze key factors influencing phase noise of the crystal oscillator, in order to control phase noise of the crystal noise from the very beginning of the design

    本文首先分析了振蕩器的工作原理，從理論的角度闡明了晶體諧振器及其等效電路、晶體振蕩器和恆溫箱的設計，利用電路的噪聲模型來分析影響晶體振蕩器相位噪聲的關鍵因素，從設計就開始控制晶振的相位噪聲，為更好地實現課題的目標打下良好的基礎。
  18. The resonance network is connected to the gate, then the output and input matching network is designed to satisfy the oscillation criteria. then harmonic balance method is used to analysize and optimize the output power and phase noise. to minimize the load pulling effect a buffer amplifier is designed to isolate the oscillator and the load

    本文在場效應管fet柵極上加上諧振網路（諧振網路是通過cst模擬得到的，它是串聯反饋迴路，介質工作在te01模，對于其後的fet ，它又相當於一個帶阻濾波器） ，然後設計輸入輸出匹配電路，使電路結構滿足起振條件，之後繼續用諧波平衡法模擬和優化，使振蕩器輸出功率合適，相位噪聲很低。
  19. The main ideas of the thesis and the contributions to the resonant dc - link area are also listed in this chapter. a novel control strategy for the two - amplitude actively clamped resonant dc - link is proposed in chapter ii. it neglects the bus short circuit time adjuster and stabilizes the clamping voltage by a pi regulator so that the obtained link frequency is improved and the link losses are greatly reduced

    第二章針對雙幅控制技術在單相橋式電壓源逆變器中的應用為範例進行研究，提出了直流母線無短路控制和通過pi調節環穩定箝位電壓的雙幅諧振控制策略，進一步提高了母線振蕩頻率，減少了直流環節損耗。
  20. 30mhz measurement of quartz crystal unit parameters by zero phase technique in a - network ; part 4 : method for the measurement of the load resonance frequency fl load resonance resistance rl and the calculation of other derived values of quartz crystal units, up to 30 mhz

    用型網路的零相位技術測量石英諧振器參數.第4部分:石英晶體元件負荷諧振頻率fl負荷諧振電阻rl的測量方法，以及石英晶體元件其他導出值的計算方法
分享友人
分享到 Line

分享到臉書