諧波變頻器 的英文怎麼說

中文拼音 [xiébiànbīn]
諧波變頻器 英文
harmonic converter
  • : Ⅰ形容詞1 (和諧) in harmony; in accord; in tune 2 (詼諧) humorous Ⅱ動詞(商量好; 辦妥) come t...
  • : Ⅰ名詞1 (波浪) wave 2 [物理學] (振動傳播的過程) wave 3 (意外變化) an unexpected turn of even...
  • : Ⅰ形容詞(次數多) frequent Ⅱ副詞(屢次) frequently; repeatedly Ⅲ名詞1 [物理學] (物體每秒鐘振動...
  • : 名詞1. (器具) implement; utensil; ware 2. (器官) organ 3. (度量; 才能) capacity; talent 4. (姓氏) a surname
  1. In view of this situation this article has conducted research to the design of metallurgy auxiliary biography with the frequency conversion table electrical machinery first multianalysis to the frequency changer and the frequency conversion table electrical machinery movement characteristic is carried out, the voltage waveform harmonious which the frequency changer outputs is big, attacks in a big way, and the voltage climbing rate reaches as high as 6600v / mu s which is 20 times ordinary sine alternating voltage, the rolling mill auxiliary biography table set the extremely strict request to the electrical machinery ; its movement frequency is very low, rate frequency in 8 - 20hz ; the velocity modulation scope is wide, the lowest movement frequency lowers to 1hz, and the starting number of times is quite frequently, each hour reaches as high as 600 - 800 time, the impact shoulders in a big way, the overload capacity request is high

    針對這一情況本文對冶金輔傳用輥道電機的設計進行了系統研究。首先對輥道電機的運行特性進行詳細分析,輸出的電壓大,沖擊大,電壓上升率高達6600v / s ,是普通正弦交流電壓的20倍;軋機輔傳輥道對電機提出了十分嚴格的要求:其運行率很低,額定率在8 - 20hz ;調速范圍寬,最低運行率低到0 . 5hz ,起動次數相當繁,每小時高達600 - 800次,沖擊負荷大,過載能力要求較高。
  2. All sorts of imperceptible factors making the system get worse, including the harmonic of the inverter and magnifying of dv / dt over long cable and the effects after applying the inverter. i applied the three - level main circuit structure to the esp system, so that the high voltage problems resulted by low endureing voltage can be solved, at the same time avoided the voltage distributing because of devices in series

    為此本文將三電平主電路結構運用到潛油電泵系統中,以解決由於當前件耐壓較低而要求實現中高壓問題,同時避免了由於件串聯而引起的均壓問題,具有含量較二電平要低和體積較低壓單元串聯方式要小等特點。
  3. But because of frequency conversion machine when it was in application it will produce harmonic interference inevitably, the traditional means ca n ' t be applied in variable frequency speed regulation system completely, therefore need some new analytical methods aiming at frequency conversion machine accordingly

    但是由於應用中不可避免地要產生干擾,傳統的手段和方法已經不能完全適用於系統中,因此需要針對系統採用相應的分析方法。
  4. The design process consisted of computer design by circuit simulation software integrate with electromagnetic simulation software, fabrication of microstrip bpf 、 lpf 、 the match circuits, cavity and test. when rf frequency is 91 ~ 97ghz, lo frequency is 47ghz, power is 10 dbm. the best conversion loss of the 2 and 4 sub - harmonic mixer is 13. 5 db and 23. 5db which is shown in the test

    實測表明,在本振為47ghz ,功率10dbm ,測試射帶寬為91ghz 97ghz時,二次與四次分損耗最優處分別為12 . 7db和23db 。最後對實驗結果進行分析並提出改進措施。
  5. Secondly, the mmic 20 - 40ghz hmmc - 5040 amplifier is used to realize the phemt frequency converter. the feasibility of up / down converter using phemt sub - harmonic mixing is validated by the experimental results. at last, on the base of phemt multiplying, amplifying and gate mixing, the

    之後研究了採用hp公司的20 - 40ghz放大晶元( hmmc - 5040 )設計製作phemt ( pseudomorphichighmobiletransistor ),通過測試,給出了實驗結果,並通過實驗驗證了採用phemt二次模式,實現上下混的可行性。
  6. In active section, in order to meet performance of out put power above 10dbm, the power amplifier module of ka - band is fabricated by using hmc283 to achieve the 14db conversion gain. there are five parts that include of waveguide - to - microstrip ? mixer ? filter ? power amplifier and waveguide - to - microstrip. input signal ' s power is 10dbm, after it pass waveguide - to - microstrip, it ' s frequency is escalate from 30ghz to 35ghz

    該組件由五個部分組成:功率為10dbm信號經過導? ?微帶過渡,然後混,濾將30ghz提高到35ghz濾除不需要的以及三階交調信號,為了彌補混損耗,加一級功率放大,此放大採用hittle公司hmc283晶元,此上放大組件完成了上?濾?放大功能。
  7. Abstract : this paper pointed out a few problems of series, harmonic and efficiency etc., to be needed considering, it introduced constructed by all - controlling power electronics device igbt by means of multi - pwm control technology, and this kind of convertor can be the used for direct frequency conversion governorof midolle / high - voltagea. c mo tors

    摘要:提出用於高壓電動機調速電源需考慮的串聯、和效率等幾個問題;介紹由全控型電力電子件igbt按多重化pwm控制技術構成、目前已商品化的高壓,可用於中、高壓交流電動機的直接調速。
  8. Due to the complexity of the structure and control of cycloconverter - type three - phase hf link inverter for soft - switching based on phase - shift - controlled full - bridge mode, a simple and optimized vvvf control strategy is proposed. this control strategy includes : produced pwm by space voltage vector ( svm ) and equivalent carrier frequency fe = 1 / te are introduced into the pdm control of the cycloconverter ; softened equivalent pwm wave is generated at the notches of hf voltage pulses ; the harmonious control between regulating pulse width by phase - shifted angle and regulating voltage of equivalent pwm is to minimize the harmonics content of output voltage of the inverter

    西安理工大學博士學位論文針對這種前級移相全橋軟開關周流型三相高鏈逆結構和控制的復雜性,提出了一種實現簡單而整體優化的vvvf控制策略:將空間電壓矢量產生p姍的方法svm和等效載率fe = 1 / te引入到周的pdm控制;按高電壓脈沖前後沿軟化等效p翎;用移相調節高脈沖寬度和等效p姍調壓協調控制逆輸出電壓,在滿足輸出電壓條件下使最小。
  9. Based on the results of the theory analysis and computer simulation of suspended stripline low pass filter, band pass filter, the transition from waveguide to finline and the transition from waveguide to suspended stripline, the structure design and manufacture were made. the measured results match the requirement. different from the traditional mixers used in the domestic communications satellites, the sub - harmonic balance mixer type was used in the ka - band mixer design

    在ka段混的研究過程中,通過對衛星和飛船所用到的混進行研究,在對ka段的傳統射前端電路的分析基礎上,提出改以往星上傳統的基方案,採取了次方案,降低了本振率,簡化了本振鏈路,使噪聲特性、可靠性獲得改善。
  10. So there are good prospects for alternating current excitation generators. in this thesis, the operation principle of aceg and the excitation control strategy based on dynamical synchronous reference frame are analyzed, the simulation models of the generator and excitation controller are established based on the saber simulator. according to the requirement of aceg, the converter should have regeneration capability, and the input and output currents of converter should be sinusoidal

    由於交流勵磁發電機既可能運行於勵磁系統向電機轉子方輸入電功率,也可能運行於勵磁系統將轉子方輸出的電功率回饋給電網,根據交流勵磁發電機系統對勵磁功率雙向流動及輸入和輸出電流含量少、幅值小的要求,本文提出採用輸入和輸出性能優良的矩陣式交-交作為勵磁電源。
  11. The series h - bridge multilevel converter has the advantages of high output voltage, high power, lower harmonic content in line and motor sides and high input power factor

    串聯h橋多電平具有輸出電壓高、功率大,輸入側和輸出側含量小,輸入功率因數高等特點。
  12. According to the mechanism characteristics of the ac motor, with zero - voltage switching technology, the pdm converter mathematical models both the pwm and rectangular wave control mode are given in this paper. and the voltage and current harmonic analysis and the simulation waveforms of the output voltage, current and power are also described respectively

    根據交流電機在恆轉矩區和恆功率區的特性,結合零電壓開關技術,分別給出相應的脈寬調制控制( pwm )方式和方控制方式下的高交流脈沖密度調制的數學模型,電壓和電流的分析以及輸出電壓、電流和功率的模擬形。
  13. It also gives the motive of the ka - band vco and mixer, associated with the subject ' s requirement and the realistic conditions, according to which a proposal is confirmed that the gunn diode and the varactor are mounted in the same cavity to fulfill the vco and an antiparallel diode pair is used to fulfill the harmonic mixer. in chapter 2, based on the basic theory of negative resistance oscillating, we analyses the gunn oscillator and it ’ s tuning character. chapter 3 introduces the theory of millimeter - wave harmonic mixer

    以此為根據結合課題需要和實驗室的實際條件,確定vco採用耿氏管腔體振蕩形式,容管與耿氏管安裝在同一個腔內以進一步減小體積,採用反向並聯二極體實現;第二章介紹負阻振蕩理論及其調原理;第三章介紹毫米基本原理;第四章給出了振蕩的設計過程,整個組件聯調的結果;最後是結束語,分析了電路中存在的問題,指出了改進方向。
  14. This paper discusses the problem of harmonic waves of the converter in running, and the countermeasures are also proposed

    摘要本文針對運行中存在的問題,分析產生的原因及危害,並提出解決方法。
  15. Based on the modularized asi, cascade inverter topology structure and modulation mode is introduced in this paper. comparing with several control strategies such as single closed - loop feedback and dual close - loop instantaneous value feedback, the voltage - current dual closed - loop control strategy, which is the voltage effective value feedback and inductance current instantaneous value feedback, is adopted

    針對級聯逆討論其pwm調制技術,在比較幾種pwm調制技術的基礎上,對該級聯逆採用倍移相調制技術,其輸出不含載,邊次數比二階和三階調制的邊次數提高一倍,等效開關率也提高一倍。
  16. Harmonics inhibition methods and measurement for frequency converters

    抑制方法及測量
  17. Harmonic tackling of low voltage grid and rational selection of reactive compensation equipment

    低壓治理和無功功率補償
  18. It can improve the utilize of power by fed back the power generated by motor machine to power - net, has the benefit of improving power factor, reducing the harmonious feeding back to the power - net and can enhance the performance of converters for the constant voltage of dc - link

    該裝置能夠提高電能的利用率,把由電動機產生的再生能源回饋到交流電網,並且能提高裝置的功率因數,減少對電網的污染。由於pwm整流,中間直流環節的電壓能保持穩定,提高了逆的調速性能。
  19. The simulation about the harmonic detection of a three - phase cycloconverter - fed a. c. excited generator verified the effectiveness of the method

    針對三相交-交交流勵磁發電系統的檢測進行的模擬研究,驗證了本文方法的有效性。
  20. In this paper, firstly, based on the analyzing the nature of the harmonics produced by the cycloconverter excited acems, a novel concept of " power harmonic " is proposed

    本文首先對採用交交勵磁的acem發電系統電力特性進行了詳細的分析,獲得了「電源」的新概念。
分享友人