負荷條件 的英文怎麼說

中文拼音 [fùhétiáojiàn]
負荷條件 英文
load conditions
  • 負 : Ⅰ名詞1 （負擔） burden; load 2 （虧損） loss 3 （失敗） defeat Ⅱ動詞1 [書面語] （背） carry on th...
  • 荷 : 荷名詞（蓮） lotus
  • 條 : Ⅰ名詞1 （細長的樹枝） twig 2 （條子） slip; strip 3 （分項目的） item; article 4 （層次; 秩序; 條...
  • 件 : Ⅰ量詞（用於個體事物） piece; article; item Ⅱ名詞1. （指可以一一計算的事物） 2. （文件） letter; correspondence; paper; document
  • 負荷 : [電學] load; charge; weight
  • 條件 : 1. （客觀的因素） condition; term; factor 2. （提出的要求） requirement; prerequisite; qualification
  1. Technical condition of the tyre strength tubness unseating - dead load tester

    輪胎強度脫圈靜負荷試驗機技術條件
  2. This study tried to observe responsive and recovery characteristics of immune function induced by an acute incremental ergometer exercise, and to observe the effect of hyperoxia intake on immune recovery rate

    本實驗主要研究急性遞增負荷運動條件下機體免疫的應答特徵和恢復特徵，並且，在恢復期以吸氧為輔助手段，觀察吸氧對急性運動后免疫機能的影響。
  3. In the research, a set of simulation equipment is developed to examine the drivers " static and dynamic fatigue. recur to the apparatus, contrast and control experiment are made among different ages, workload intension and workload factors group. the endings summarize as following : ( 1 ) driving sensation fatigue investigation ( investigation of psychological and physiologic index and contrast investigation of fatigue ) ; continuous driving load and discrete driving load investigation of fatigue

    ? ?門）駕駛疲勞平衡穩定性是通過在力檢測臺上描繪人體重心軌跡的方法，提出檢測駕駛員疲勞平衡穩定指數，在不同狀態下（傾斜度15 30 『以及閉目等狀態下）對不同負荷、不同年齡分別進行測試，建立駕駛疲勞客觀測試評價體系； n ）經實驗室研究與現場調查，通過對駕駛疲勞與駕駛時間、駕駛速度等關系的研究，提出了不同年齡、不同條件下的最大連續安全駕駛時間標準，日駕駛時間標準，最大安全行車速度標準等。
  4. The correlation of serum mda and la with these parameters were analyzed so as to observe the tendency of immune alteration after acute incremental exercise and to understand if hyperoxia intake is helpful to accelerate recovery rate of exercise - induced fatigue

    並且將急性遞增負荷運動后血清mda和血乳酸的變化與免疫指標的變化進行相關性分析，以探討這種運動條件下免疫機能應答變化和恢復變化的可能機理。
  5. Presents the steady - state programming with constant coolant average temperature and constant live steam pressure, an ideal programming for marine nuclear power plant ( npp ), under which, both the coolant average temperature and the live steam pressure of nuclear steam supply system ( nsss ) are constant when the steady state operating condition is varied, and points out that in comparison with the steadysate programming with constant coolant average temperature, the ideal programming can improve the overall operating performance of npp effectively, especially in low - load range, for instance, raise the heat efficiency of npp, decrease the operating noise of main coolant pump, and improve the conditions of design, operation and control of the secondary loop system

    雙恆定運行方案是船用壓水堆核動力裝置的理想運行方案.在這種運行方案下，當裝置穩態功率變化時，冷卻劑平均溫度與蒸汽壓都保持不變，與通常採用的冷卻劑平均溫度恆定運行方案相比，有效地改善了核動力裝置的總體運行性能，特別是在低負荷運行時，可以提高裝置經濟性、降低主泵運行噪聲、改善二迴路系統的設計、運行和控制條件，這對于提高船用核動力裝置的運行可靠性和安全性具有實際意義
  6. The air - flow field in the stripping unit can be adjusted easy by changing the rotation speed of fan which is benefit to reduce the grain losses, it was found during experiment that the cross - flow fan can diffuse some of mog ( material other of grain ) and diffuse it in a certain direction which is useful to satisfy the working condition for driver and lighten working load of the threshing unit of the combine harvester candidate and speciality : peng shengmin ; machinary design and theory supervisor : prof. zhang huiyou

    該裝置可以通過控制橫流風機的轉速，使裝置內氣流在有控制的情況下排出裝置外，改善了裝置內流場狀態，提高了裝置喂入口處的負壓，這對減少摘脫裝置的落粒損失，有著重要意義。由於橫流風機的除雜，可以減輕機器的復脫和清選負荷。安裝橫流風機后可以對裝置的出風口處灰塵進行有效導引，改善駕駛員的工作條件。
  7. It shows that the injection quantity and the difference of temperature distribute as a parabola which is at the same load, and the minimum of the parabola corresponds to the optimum quantity of injection ( g ). under the condition that the quantity of injected mass, the air speed and the heat quantity is respectively g, v and q, the research demonstrates that the pentium iv chip ' s temperature variation can be controlled under 40c and work normally when the wind speed overpass 1. 5m / s and the power dissipation of the chip is 60w. otherwise this paper calculates the flooding limit of thermosiphon with several different methods

    對其充灌量、散熱量、電子元件（ cpu模擬晶元）表面與環境溫度之差及通風、流速的影響進行了系統的測試，發現充液量與溫差的關系在負荷不變時呈拋物線分佈，其極小值點對應的充液量是最佳充液量g 。在充液量為g時，對風速v 、散熱量q進行的研究表明，當風速超過1 . 5m / s后，奔騰晶元在60w發熱條件下晶元溫度小於40 ，能滿足長期正常工作。
  8. A river quality management model is proposed for the optimal waste load allocation in a tidal river basin, taking into account the impacts of stochastic pollutant discharge and dynamic hydrological conditions on water quality during a tidal cycle

    摘要考慮污染源強隨機變化和感潮河流潮周期內動態水文條件對水質的影響，建立了優化污染負荷分配的流域水質管理模型。
  9. Finally, we can not use electric power but the engine of bus or subsidiary engine to drive air compressors of bus air conditions. because the change range of turnaround speed of engine is very wide, that brings difficulties in controlling the rate of flow of cold - producing medium. in the control of bus air - conditions, preventing evaporator from freezing to make the air - conditions work with high efficiency and controlling the temperature of railway carriage are the basic tasks in air - condition control

    與一般的建築空調相比，汽車空調的工作環境惡劣，條件差，控制難度要增加很多，主要體現在以下幾個方面：一是車外熱負荷變化大，難以確定控制參數；二是要求空調負荷大，而且要控制空調使其降溫迅速：三，不便於用電力作為動力源，必須用汽車發動機或輔助發動機來帶動壓縮機，當採用汽車發動機作為動力源時，由於汽車的車速變化大，發動機轉速的變化可從600r min到4000r min ，壓縮機轉速與發動機轉速成正比，其轉速變化高達7倍，給空調系統製冷劑流量控制帶來困難。
  10. Under the condition mention in this physical model, when there is a high rotor heat load, the effect of the axial direction gas - flow to the total heat - emitting capability is not very great

    轉子高熱負荷條件下，該模型建模條件下由氣隙楔度所產生的軸向風量對總散熱能力的貢獻較小。
  11. Alpine ski bindings ; lateral release under impact loading ; test method ; identical with iso 9465 : 1991

    高山滑雪橇緊固.沖擊負荷條件下的橫向松脫.試驗方法
  12. As a result, this paper gives a corresponding harmonic prevent me asure. finally, according to the asymmetrical characteristics of electrical traction loads, this paper studies the negative sequence currents under different loads and makes a piece of advice for reducing the negative sequence currents produced

    最後，還根據電力牽引負荷三相不對稱的特點，分析了阻抗匹配平衡變壓器在不同負荷條件下的負序電流，對如何減小電力牽引負荷的負序電流提出了一點建議。
  13. Thermal insulating products for building applications - determination of deformation under specified compressive load and temperature conditions ; german version en 1605 : 1996

    建築物絕熱產品.規定壓力和溫度負荷條件下變形測定
  14. Experiment of intensifying primary treatment was conducted to treat urban wastewater with bio - flocculation adsorption technique. sludge precipitation property and affecting factors of biological phase under different sludge load were analyzed

    摘要應用生物絮凝吸附技術對城市污水進行強化一級處理試驗，對不同污泥負荷條件下污泥沉降性能及生物相的影響因素進行分析研究。
  15. According to the characteristic of nine - area diagram of substation vol / var coordinated control, this system gives the defination of fuzzy sets and the degree of membership of input / output variables, and designs corresponding control rules. the results of simulation demonstrate the system can satisfy the constrains of the day - adjusting times of the switching of on - load transformer and paralleled compensation capacitors, and ensure voltage quality, reactive power basical balance. considering the var requirement in different load time period and the control demand in load saltation, a improved control scheme is provided. the results of simulation show the improved scheme can meet the demand of vol / var in different load time period, protect the wrong operation when either voltage or reactive power appears saltation, and decrease the times of regulation of the switching of on - load transformer and paralleled compensation capacitors finally, a background software module of substation vol / var coordinated control is designed, based on the supervisory control and data acquisition system of substation

    模擬結果證明該系統能在各種負荷條件下確保電壓合格和無功基本平衡，且能滿足變電站對有載調壓變壓器分接頭日調節次數和並聯補償電容器組的日投切次數的限制。通過考慮不同負荷時段對無功功率的需求和負荷突變情況下的控制要求，對上述模糊控制策略進行了改進，模擬結果證明改進后的控制策略能滿足不同負荷時段對電壓和無功的要求、抑制電壓或無功突變情況下的誤動作，且有效地減少了有載調壓變壓器分接頭和並聯補償電容器組的調節次數。最後基於變電站scada系統設計了一后臺電壓無功綜合控制軟體模塊。
  16. Emgear gr grades have stringiness for long - lasting protection, enabling to be good lubricants for open gears, chains and wire ropes that operating in low speed and heavy loading

    Emgear gr具有可提供長期保護作用的特強粘稠特性，為適用於開放式齒輪組、鏈條與鋼纜等低速重負荷機件的優選潤滑劑。
  17. Structural design of buried pipelines under various conditions of loading - general requirements

    不同負荷條件下地下管道的結構設計.一般要求
  18. Structural design of buried pipelines under various conditions of loading - part 1 : general requirements ; german version en 1295 - 1 : 1997

    各種負荷條件下地下管道結構設計.第1部分:一般要求
  19. Test methods for transparent materials for aircraft glazing - determination of temperature at deflection under load

    飛機玻璃窗用透明材料的試驗方法.負荷條件下彎曲時溫度的測定
  20. Jointing products. glazing materials and compounds for sealing. plastic - oil based sealants. determination of adhesion - cohesion properties under tensile loading

    接縫用品.密封用釉料和化合物.粘滯油基密封劑.在張力負荷條件下粘著特性的測定
分享友人
分享到 Line

分享到臉書