負載升高 的英文怎麼說

中文拼音 [fùzǎishēnggāo]
負載升高 英文
load rise
  • 負 : Ⅰ名詞1 （負擔） burden; load 2 （虧損） loss 3 （失敗） defeat Ⅱ動詞1 [書面語] （背） carry on th...
  • 載 : 載Ⅰ名詞（年） year : 一年半載 six to twelve months; six months to a year; 三年五載 three to five ...
  • 升 : Ⅰ動詞1 （由低往高移動） rise; hoist; go up; ascend 2 （等級提高） promote Ⅱ量詞1 （容量單位） lit...
  • 高 : Ⅰ形容詞1 （從下向上距離大; 離地面遠） tall; high 2 （在一般標準或平均程度之上; 等級在上的） above...
  • 負載 : [電學] load
  1. In view of this situation this article has conducted research to the design of metallurgy auxiliary biography with the frequency conversion table electrical machinery first multianalysis to the frequency changer and the frequency conversion table electrical machinery movement characteristic is carried out, the voltage waveform harmonious which the frequency changer outputs is big, attacks in a big way, and the voltage climbing rate reaches as high as 6600v / mu s which is 20 times ordinary sine alternating voltage, the rolling mill auxiliary biography table set the extremely strict request to the electrical machinery ; its movement frequency is very low, rate frequency in 8 - 20hz ; the velocity modulation scope is wide, the lowest movement frequency lowers to 1hz, and the starting number of times is quite frequently, each hour reaches as high as 600 - 800 time, the impact shoulders in a big way, the overload capacity request is high

    針對這一情況本文對冶金輔傳用變頻輥道電機的設計進行了系統研究。首先對變頻器和變頻輥道電機的運行特性進行詳細分析，變頻器輸出的電壓波形諧波大，沖擊大，電壓上升率高達6600v / s ，是普通正弦交流電壓的20倍;軋機輔傳輥道對電機提出了十分嚴格的要求:其運行頻率很低，額定頻率在8 - 20hz ;調速范圍寬，最低運行頻率低到0 . 5hz ，起動次數相當頻繁，每小時高達600 - 800次，沖擊負荷大，過載能力要求較高。
  2. Based on the hydrodynamic energy transport model, the influence of variation of negative junction depth caused by concave depth on the characteristics of deep - sub - micron pmosfet has been studied. the results are explained by the interior physical mechanism and compared with that caused by the source / drain depth. research results indicate that with the increase of negative junction depth ( due to the increase of groove depth ), the threshold voltage increases, the sub - threshold characteristics and the drain current driving capability degrade, and the hot carrier immunity becomes better in deep - sub - micron pmosfet. the short - channel - effect suppression and hot - carrier - effect immunity are better, while the degradation of drain current driving ability is smaller than those with the increase of depth of negative junction caused by source / drain junction shallow. so the variation of concave depth is of great advantage to improve the characteristics of grooved - gate mosfet

    基於能量輸運模型對由凹槽深度改變引起的負結深的變化對深亞微米槽柵pmosfet性能的影響進行了分析，對所得結果從器件內部物理機制上進行了討論，最後與由漏源結深變化導致的負結深的改變對器件特性的影響進行了對比.研究結果表明隨著負結深（凹槽深度）的增大，槽柵器件的閾值電壓升高，亞閾斜率退化，漏極驅動能力減弱，器件短溝道效應的抑制更為有效，抗熱載流子性能的提高較大，且器件的漏極驅動能力的退化要比改變結深小.因此，改變槽深加大負結深更有利於器件性能的提高
  3. It ' s high - frequence noise absorption, absorption of noise caused by rapid rise of front and self - reset function have widespread application in imput of supply, for absorption of inductive load switching surge voltage and for protection of two - way thyristor switching device, bypass capacitors, micro - machines and the others

    它所具有的吸收高頻噪聲、前沿快脈沖上升噪聲及自復位功能，使其在電源輸入端、吸收電感性負載開關浪涌電壓、保護雙向可控開關器件、旁路電容器、微型電機等方面有著廣泛的用途。
  4. The simulation results show that the power factor and efficiency of lim are much lower than that of rotary induction motor due to end effect and big air gap of lim. end effect force has a great influence on the thrust of lim. the performance of lim can be improved with the proper secondary structure, small air gap, big goodness factor or heavy load

    結果表明:受邊端效應及大氣隙影響，直線感應電機功率因數及效率較低;運行狀態下的邊端效應力對電機推力有較大影響;設計電機時選用合適的次級材料、減小氣隙、增大品質因數、增加負載都可提升電機的輸出性能，通過設計有效的控制演算法可使電機在額定滑差下具有較高的運行效率。
  5. The authour investigate the dosing conditions and effect of the pac to the huanghe water - source, which includes the following four parts : the selection of the pac ; the confirmation of dosing scheme and effect of the pac ; the research of application of potassium permanganate in combination with pac ; the research of the pac ' s modification and the modified effectiveness. the experiment is mainly carried out on the pilot system in the jieyuan water plan of tianjin. the results of the reseach include the following : l ) the pac from zunhua plant is selected as the better carbon for the source water of tianjin through the experiment ; 2 ) through the pilot experiment we conclude that the pac ' s best adding point is the mixing tank and the better dose is 10mg / l, on which the codmn of filtered water can be decreased to 40 % and the effluent have no problem of odour and color ; 3the adsorbing experiment show that pac mainly adsorb the organic matters which molecular wt., distribution between 500 and 3000, and can adsorb organic matters whose molecular wt., distribution are bigger than 6000 if the dose of it is adequent ; 4 ) pac together with potassium permanganate can remove the organic matter more effectively than each of them alone, and reduce the rising trend of turbidity of the flotation ' s effluent due to adding pac ; 5 ) the thesis made a research on the surface properties and the adsorbing capability of the modified carbon by oxidizer : the modified carbon with 20 % h2o2 can remove more organic pollutants than the untreated one by 12 % when we add a higher dose of coagulant ; 6 ) the modification of reduction and loading metal ions are also sttldied, and drow the following conclusions : the modified carbon with 5 % ammonia can enhance the organic matter ' s removal effectiveness by 10 % to the tianjin source water than the untreated one, and the modified one with loading metal ion remove the organic matters from the tianjin source water better ( 8 % ) than the untreated one due to the strong affinity betwween the humic acid and copper ion

    本文的實驗主要是在天津芥園水廠的中試系統上完成的，論文的成果和結論主要包括： 1 ）通過靜態實驗選定河北遵化活性炭廠生產的煤質炭為適合天津原水的炭種； 2 ）中試實驗確定粉末活性炭的較佳投加點為混合池投加，較佳投加量為10mg l ，此時可使濾后水的cod _ （ mn ）降低40 ，且可較好地控制濾后水的嗅味和色度； 3 ）初步確定粉末活性炭對原水中有機物的吸附主要集中在分子量在500 - 3000范圍內，投量增大時可吸附部分分子量大於6000的有機物4 ）中試實驗表明：粉末活性炭與高錳酸鉀聯用可取得較兩者單獨應用時對有機物更好的去除效果，且對因投加粉末活性炭而造成的氣浮出水濁度升高有一定的改善作用； 5 ）研究並初步確定氧化改性對粉末活性炭表面性質和有機物的去除效果的影響：粉末活性炭的氧化改性會使其表面的酸性官能團大量增強，表面極性增加；經20的過氧化氫改性的活性炭在增大混凝劑投加量（ fecl _ 3投量為15mg l ）時對有機物的總體去除效果較原活性炭提高12 ， 1次氯酸鈉改性活性炭對有機物的去除效果較原活性炭提高6 ； 6 ）研究並初步確定還原改性、負載金屬離子對原水中有機物的去除效果的影響：經5氨水改性的活性炭可提高天津源水中有機物的去除率達到10 ；負載銅離子后的活性炭可提高對腐殖酸類物質的去除能力，一般可提高8左右。
  6. By close study on the average temperature rise, temperature distribution, and tune constant of the class f resin dry type power transformer ' s high voltage and low voltage winding under self - cooling and wind - cooling mode, we find out the connection between the variation of the load and the items, mentioned above. the results of the experiments can be reference to both thermal design optimization of dry type power transformer and the revision of current standards. meanwhile, we develop the software, which can predict the overload ability of the dry type power transformer

    本文對f級樹脂澆注式乾式變壓器的高、低線圈的平均溫升，內部溫度分佈和時間常數在自冷和風冷，兩種冷卻方式下隨負載變化的規律進行了研究，得出了平均溫升、熱點溫升和時間常數隨負載變化的相互關系和有關計算用參數和公式，試驗結果可作為改進乾式電力變壓器的熱設計的依據和對現行標準進行修改的參考。
  7. In order to drive a high impedance load such as hpm sources, it is necessary to commutate fcg ' s long pulse width, high - current and low voltage pulse to a short pulse with high voltage

    為用fcg驅動象hpm源這樣較高阻抗的負載，必須使用脈沖功率調制電路把fcg產生的低電壓、大電流、上升時間長的電壓脈沖轉化為高電壓、上升時間短的脈沖。
  8. The synchrolifting lifting system developed by changjiang three - gorges navigation bureau is adaptable to the requirement of quick lifting of seriously deviated heavy load & large - diameter members, and possesses the advantages of high precision and good performance of adjustment

    長江三峽通航管理局研製的同步升降系統，能適應偏載大負荷大尺寸構件的快速升降要求，同步精度高，調整性能好。
  9. This system has a lot of the prominent characteristics such as simple structure, and good efficiency, especially adapting to the large, middle power machine equipments that have the big qualities, periodicity, in the short time, constantly accelerating and applying the brake. it is very remarkable in energy - saving

    二次調節靜液傳動系統具有許多顯著的優點，比如：較為簡單的結構，並可得到較高的效率，特別適用於那些負載質量較大、具有周期性、在短時內需不斷加速和制動的大中功率場合（如車輛系統和升降系統） ，其節能效果十分顯著。
  10. In the power - amplifying grade of drive circuit, the system adopts a method of high / low voltage drive that is different to the conventional drivers. so the high frequency performance of the system is improved and the load support capability of step motor is increased. by the software method, the control principle of the optimum increasing / decreasing frequency of step motor is achieved

    在驅動電路的功放級採用了一種不同於傳統驅動器的高低壓驅動方式，改善了系統的高頻性能，增加了步進電機帶負載能力，以軟體方法實現步進電機最佳升降控制規律，實現了步進電機的快速啟、停控制。
  11. In order to solve the problems that large energy consumption, temperature variation, high, cost trouble maintenance in current electro - hydraulic servo control system for material testing machine, a new design scheme that electro - hydraulic proportional control system for material testing machine based on extension control strategy is proposed. the design scheme is successful by means of designing new main frame system, hydraulic cylinder system, digital electro - hydraulic micro - fluid proportional valve and electrical control system, and its results lay a foundation for material testing machine industries in our country

    針對國內外材料試驗機主要採用電液伺服控制系統，存在能耗大、溫升、成本高、維護困難等問題，本課題提出了基於可拓控制策略的材料試驗機電比例負載適應控制系統這一新型研究方案，通過開發新型試驗機主機系統、液壓缸系統、數字式微小流量電液比例流量閥及電控系統，實現了材料試驗機電液比例負載適應控制，為我國材料試驗機自動控制系統的產業化打下了基礎。
分享友人
分享到 Line

分享到臉書