負載電機 的英文怎麼說

中文拼音 [fùzǎidiànjī]
負載電機 英文
load motor
  • 負 : Ⅰ名詞1 （負擔） burden; load 2 （虧損） loss 3 （失敗） defeat Ⅱ動詞1 [書面語] （背） carry on th...
  • 載 : 載Ⅰ名詞（年） year : 一年半載 six to twelve months; six months to a year; 三年五載 three to five ...
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 機 : machineengine
  • 負載 : [電學] load
  • 電機 : （任何產生和應用電能的機器 特指發電機、電動機） any power generating or power driven machine esp ...
  1. According to the operation condition, it is shown that the protector presented in this paper can duly follow the motor ' s load fluctuation and capitally match with motor ' s tolerance overload characteristic, thus it is valuable to be actually used

    運行結果表明，本文所研製的單片機式熱保護電器能較好地動態跟蹤負載變化，其熱保護特性能較好地與電動機的允許過載特性相匹配，有一定的工程實用價值。
  2. It looks upon water resistant as load, simulate every instance of locomotive running and check its every parameter automatically, then collect and dispose these data of parameters, calculate the power of simulating running of locomotive, which is based on the current, and voltage of host dynamotor. afterward, it can be judged from the working state of locomotive. through experiment and adjust each parameter, it can provide important warrant to the components of locomotive whether they can work normally and credibly

    即以水阻作為負載，模擬機車運行，對機車的主發電動機的電流、電壓和柴油機的轉速等參數進行檢測，並對檢測結果進行處理，計算出模擬機車運行時的功率，並以此為依據，對機車的工作狀念進行判斷，通過水阻試驗，調整有關參數，使機車運行時能發揮所要求的功率和滿足規定的工作特性。
  3. Electric power ergograph is a load or device of absorbing power, which mainly is used of measuring power for middling torque

    電力測功機是常用的負載與吸功設備，主要用來對中等大小的扭矩測功。
  4. Because of the elements which run under nonideal linearity and unentire symmetry in the power system, the loads which are different and change randomly, the methods which adjust and control the system faultily and operate improperly, the disturbance and the malfunction which happen somewhere, the current and voltage in the supply system are distorted seriously and thus large amount of harmonics are produced

    但是，由於電力系統元件運行的非理想線性或非完全對稱、負載的性質各異且隨機變化、調控手段的不完善以及錯誤操作、外來干擾和各種故障的存在，供電網中的電流（電壓）發生畸變，產生大量諧波。
  5. The theories and design principles of each circuit of the spwm three - phase frequency inverter experiment unit are in detail introduced in this thesis. at the same time some experiment results are shown that include the output voltage and current waves when the load is in resistivity, inductivity or asynchronous motor

    文中詳細介紹了spwm三相變頻實驗單元所包含的各電路環節的理論基礎及設計過程，並給出了調試結果，如負載為阻性、感性和異步電動機時，實驗單元輸出的電壓和電流波形。
  6. Moreover, we mensurate the reactances of the experimental motor by the way of direct joad method, and verify the vaiidity of " electromotive force method "

    文章還運用直接負載法測定出樣機在不同負載下的電抗參數，驗證了「電勢法」的正確性。
  7. Ssr - dd series of dc solid relay is vastly applied to output joggle of computer and external equipments, it is also applied to control or switch dc load : dc relay 、 contactor 、 dc electrical motor 、 kinds of electric - heating apparatus 、 dc electromagnetic valve 、 electromagnetic iron 、 solenoid 、 filament lamp 、 indication lamp 、 plc logical electrical appliance and dc solid relay

    Dd系列直流固態繼電器廣泛應用於計算機與外部設備的輸出介面，適用與控制或開關直流負載：直流繼電，接觸器、直流電動機、各類電熱器具；直流電磁閥，電磁鐵、螺線管、白熾燈、指示燈； plc邏輯電器。
  8. Some common nonlinear loads are fluorescent lighting, scr motor starters and ups systems

    一些常見的非線性負載有熒光燈、可控硅電動機啟動器以及ups系統。
  9. Procreant knowledge expression and forward inference engine are adopted in the method of fault diagnosis based on expert system theory. in the fault diagnosis applying neural network theory, six kinds of improved arithmetic of back - propagation arithmetic, including gradient descent with momentum, variable learning rate back - propagation, resilient back - propagation, quasi - newton, levenberg - marquardt and conjugate gradient, are applied to diagnose the faults of electric load manage center and solid state power controller. different diagnostic results gotten by simulation are compared at last

    在基於專家系統的故障診斷方法中，採用了產生式知識表達和正向推理機制；在基於神經網路的故障診斷方法中，則分別採用了bp神經網路的附加動量法、自適應學習速率、彈性bp演算法、擬牛頓法、共軛梯度法和levenberg - marquardt法對電氣負載管理中心和固態功率控制器的故障進行診斷，並對由模擬得到的不同診斷結果進行比較。
  10. Energy consume, electric strength, insulation resistance, ground conductivity, leakage current, microwave leakage, power input, normal temperature, humidity treatment, glow wire, horizontal flame, vertical flame, tracking, ball pressure, rainproof, water splash, dustproof, salt fog, endurance, motor load test, cord flexing, cord pulling, pull & torque test, lamp replacement, construction check etc

    能耗、電氣強度、絕緣電阻、接地連續性、泄漏電流、微波泄漏、功率、溫升、濕熱試驗、灼熱絲、水平燃燒、垂直燃燒、漏電起痕、球壓試驗、防雨淋、防濺水、粉塵、鹽霧、耐久性（壽命）試驗、電機負載試驗、電源線彎折、電源線提拉、拉扭力測試、燈頭互換性、安全結構檢查等。
  11. In this study, the load charateristics of submergible centrifugal pump and the influence of various regulating methods on energy dissipation are analyzed. the loading capacity of the submergible motor in variable speed drive control process is analyzed. the papers simple discribe the basic structure of the variable speed drive system in electric submergible pump > principle of pwm inverter and the basic structure of igbt

    在研究中，對潛油離心泵負載性能以及閘閥調節和調速調節對能耗的影響進行了分析；對潛油電動機在變頻調速的負載進行了分析；對潛油電泵變頻調速系統的基本結構、 pwm逆變器原理以及igbt的基本結構進行了簡單介紹。
  12. Basing on the analysis about the reason that how the superabundant torque appears, direct torque control strategy is used to realize the servo control of two asynchronous motors and load system ' s simulation. the measure method of superabundant torque of the system, the valid method of static state torque and the benchmark of dynamic torque are given by testifying the system ' s speediness through experiments

    在具體分析加載系統中多餘力產生原因的基礎上，採用直接轉矩控制策略，實現了兩臺異步電動機伺服控制和加載系統的負載模擬實驗，通過實驗驗證了系統的快速性；給出了系統多餘轉動慣量的測量、靜態轉矩的校驗和動態轉矩基準的實驗的基本方案。
  13. Power controllers will activate the emergency generators to provide power needed for vital equipment, to avoid any damages at the blackout period

    在停電時，電力控制員啟動緊急發電機以供給維生負載電力，避免設備遭受任何損壞。
  14. Through establishing three mathematics models including the movement equation of the mechanical and electrical transmission system, the control of the load and the sliding in stable status, direct - current - brake of ac motor, this paper ascertained the range of the frequency value of drive motor and the efficiency of transmission system, calculated the efficiency of load motor in stable status and the moment of load motor in braking. this paper completed the design of the mechanical part of inertia brake test platform and provides a tool for the measurement of the inertia brake parameters

    本文還通過建立慣性制動器試驗臺的包括機電傳動系統的運動方程、穩態運行時負載與轉差率控制、交流電動機直流制動在內的三個數學模型，確定驅動電機的頻率取值范圍和傳動系統的傳動效率，驗算慣性制動器穩態運行時負載電機軸功率和慣性制動器制動時負載電機軸力矩，完成慣性制動器試驗臺設計中的機械部分，為慣性制動器各參數的測量提供工具。
  15. The conventional connection circuit as the figure shows for two - wired transmitter : handhold terminal palm computer and external communication interface or mainframe communication circuit cannot directly bridges in the ends of power source. but may either meet on field ends a and b or meet on the ends of load resistance b and c. in the above - mentioned case, the circuit are supplied by power source

    對兩線制變送器來說，傳統的連接電路如圖所示：手持終端掌上電腦和外接通訊介面或主機通訊電路不能直接跨接在電源兩端，但既可接于現場兩端a ， b上，也可接在負載電阻兩端b ， c ，兩種情況下，電路都要通過電源來供電， hart規范允許負載電阻為2301100 。
  16. Without using mechanical potentiometer, the load voltage of the test mainframe can be putted on in the way of program control through the circuit board or through the cat software

    負載電壓可以在電路板上或肛軟體中進行程式控制加載，無機械電位器，調節方便，輸出精確、穩定。
  17. Priority control priority control is the process by which the total loads on the bus is limited to the most critical loads in the system until adequate generation capacity is available to serve all loads

    優先級控制優先級控制是指當總負載電力需求大於發電機組的輸出時，首先要滿足最關鍵負載的電力需求。
  18. The sounds and images are converted into electrical signals by a microphone ( sounds ) or video camera ( images ), amplified, and used to modulate a carrier wave that has been generated by an oscillator circuit in a transmitter

    聲音合圖像由話筒（聲音）或攝像機（圖像）轉換為電子信號，經過放大后，用來調制發射器中一個振蕩器產生的負載電波。
  19. In addition, we analyzed characteristics of every instrument of the test system. as key problems, the control, communication and synchronization, such as relay arrays control and gpib communicatipn, of the virtual instrument system were discussed carefully in the dissertation. we also discussed some anti - jamming solutions of the system

    詳細研究了基於虛擬儀器的測試系統中對多種程式控制設備的控制方法及系統中的同步方法（負載電源的模擬電壓控制方法、工業控制計算機與gpib設備的通信方法；模擬通道采樣的同步方法、測試程序中數據流的同步方法等） 。
  20. A 2kva prototype is built to verify the validity of the proposed inverter

    通過一臺2kva的原理樣機，驗證了該變換器的優點和負載電流前饋方法的有效性。
分享友人
分享到 Line

分享到臉書