負阻抗放大器 的英文怎麼說

中文拼音 [fùzǔkàngfàngdàqì]
負阻抗放大器 英文
negative impedance amplifier
  • 負 : Ⅰ名詞1 （負擔） burden; load 2 （虧損） loss 3 （失敗） defeat Ⅱ動詞1 [書面語] （背） carry on th...
  • 阻 : 動詞（阻擋; 阻礙） block; hinder; impede; obstruct
  • 抗 : Ⅰ動詞1 （抵抗; 抵擋） resist; combat; fight 2 （拒絕; 抗拒） refuse; defy 3 （對等） contend with...
  • 放 : releaseset freelet go
  • 器 : 名詞1. （器具） implement; utensil; ware 2. （器官） organ 3. （度量; 才能） capacity; talent 4. （姓氏） a surname
  • 阻抗 : [電學] impedance
  • 放大器 : amplifier; pantograph; lawnmower; enlarger; magnifier
  • 放大 : amplify; magnify; boost; enlarge; blow up; gain; amplification; enhancement; multiplication; magn...
  1. The exportation resistance of a device work device with what link after loading the resistance s the certain connections for should satisfying, in order to prevent mount to load the appearance produce the obvious influence. with each other connect to say to electronics equipments, for example after signal connect the enlarger, ex - class to connect class, only behind first - degree importation resistance before larger than first - degree exportation resistance 5 - 10 times are above, can think the resistance to match good ; connect the box come saying, electronics tube the machine should choose to use with for the enlarger its output to carry the mark to call the resistance the box for, but transistor enlarger then have noing this restrict, can take officing why resistance of equal or approximate box

    一件器材的輸出阻抗和所連接的負載阻抗之間所應滿足的某種關系，以免接上負載后對器材本身的工作狀態產生明顯的影響。對電子設備互連來說，例如信號源連放大器，前級連后級，只要后一級的輸入阻抗大於前一級的輸出阻抗5 - 10倍以上，就可認為阻抗匹配良好對于放大器連接音箱來說，電子管機應選用與其輸出端標稱阻抗相等或接近的音箱，而晶體管放大器則無此限制，可以接任何阻抗的音箱。
  2. Technically, the damping factor is the specified load impedance ( in use, that ' d be the speaker system ) divided by the amplifier ' s output impedance

    技術上，阻尼因子就是指定的負載阻抗（實踐中，也就是揚聲器系統）除以放大器的輸出阻抗。
  3. Technically, the damping factor is the specified load impedance ( in use, that ' d be the speaker system ) divided by the amplifier ' s [ i ] output impedance [ / i ]

    技術上，阻尼因子就是指定的負載阻抗（實踐中，也就是揚聲器系統）除以放大器的輸出阻抗。
  4. The current in the dac ’ s output can drive the load, and the structure can save a buffer consisted of operational amplifier, so the structure can achieve high speed with no close - loop and feedback in this circuit

    該10位分段式電流舵型數模轉換器的輸出端可直接用電流輸出來驅動負載阻抗，省去運算放大器構成的輸出緩沖，整個電路中沒有形成閉環和反饋，因此這種電路結構可以達到很高的速度。
  5. The preamplifier will drive a low impedance load without alteration in the signal, in fact it can be used as a current source driving a 0 impedance mixer junction without any distortion

    這個前級放大器能夠驅動一個低阻抗的負載而不會引起信號的變化，實際上它可以用作一個驅動零阻抗混合節點，而又不產生任何失真的電流源。
  6. Power : put to say to, and the sum settle the power to is just valid index sign that evaluate the to put the function. it points within the scope of certain of the wave lose true, and the make longer a work can biggest power of the output s. enlarger while connecting into the box of the different resistance that exportation power can have different, usually the enlarger can mark clearly its sum to settle the exportation resistance ; for example a sum that set enlarger while loading a resistance to settle the exportation power to the, and load the resistance to may increase the the above. because the power there is method of various marks, some and illegal factory to can have intention to exaggerate the data, purchase or choose the hour to want with physically hear the to take in to distinct, comparison

    它是指在一定的諧波失真范圍內，功放長期工作所能輸出的最大功率。放大器在接入不同阻抗的音箱時的輸出功率會有所不同，通常放大器會標明其額定輸出阻抗例如一臺放大器在負載音箱阻抗為時的額定輸出功率為，負載阻抗為時就可能增加到以上。因為功率有多種標法，某些不法廠商會有意誇大數據，購買或選配時要以實際聽音加以區別比較。
分享友人
分享到 Line

分享到臉書