負阻管頻率計 的英文怎麼說

中文拼音 [guǎnbīn]
負阻管頻率計 英文
dynatron frequency meter
  • : Ⅰ名詞1 (負擔) burden; load 2 (虧損) loss 3 (失敗) defeat Ⅱ動詞1 [書面語] (背) carry on th...
  • : 動詞(阻擋; 阻礙) block; hinder; impede; obstruct
  • : Ⅰ名詞1 (管子) pipe; tube 2 (吹奏的樂器) wind musical instrument 3 (形狀似管的電器件) valve;...
  • : Ⅰ形容詞(次數多) frequent Ⅱ副詞(屢次) frequently; repeatedly Ⅲ名詞1 [物理學] (物體每秒鐘振動...
  • : 率名詞(比值) rate; ratio; proportion
  • : Ⅰ動詞1 (計算) count; compute; calculate; number 2 (設想; 打算) plan; plot Ⅱ名詞1 (測量或計算...
  • 頻率 : frequency; rate
  1. The thesis has done the widespread investigation and study to the domestic and foreign ’ s technologies of analogy low voltage and low power, and analyzes the principles of work, merts and shortcomings of these technologies, based on the absorption of these technologies, it designs a 1. 5v low power rail - to - rail cmos operational amplifier. when designing input stage, in order to enable the input common mode voltage range to achieve rail - to - rail, it does not use the traditional differential input pair, but use the nmos tube and the pmos tube parallel supplementary differential input pair to the structure, and uses the proportional current mirror technology to realize the constant transconductance of input stage. in the middle gain stage design, the current mirror load does not use the traditional standard cascode structure, but uses the low voltage, wide - swing casecode structure which is suitable to work in low voltage. when designing output stage, in order to enhance the efficiency, it uses the push - pull common source stage amplifier as the output stage, the output voltage swing basically reached rail - to - rail. the thesis changes the design of the traditional normal source based on the operational amplifier, uses the differential amplifier with current mirror load to design a normal current source. the normal current source provides the stable bias current and the bias voltage to the operational amplifier, so the stability of operational amplifier is guaranteed. the thesis uses the miller compensate technology with a adjusting zero resistance to compensate the operational amplifier

    本論文對國內外的模擬低電壓低功耗技術做了廣泛的調查研究,分析了這些技術的工作原理和優缺點,在吸收這些技術成果基礎上設了一個1 . 5v低功耗軌至軌cmos運算放大器。在設輸入級時,為了使輸入共模電壓范圍達到軌至軌,不是採用傳統的差動輸入結構,而是採用了nmos和pmos並聯的互補差動輸入對結構,並採用成比例的電流鏡技術實現了輸入級跨導的恆定;在中間增益級設中,電流鏡載並不是採用傳統的標準共源共柵結構,而是採用了適合在低壓工作的低壓寬擺幅共源共柵結構;在輸出級設時,為了提高效,採用了推挽共源級放大器作為輸出級,輸出電壓擺幅基本上達到了軌至軌;本論文改變傳統基準源基於運放的設,採用了帶電流鏡載的差分放大器設了一個基準電流源,給運放提供穩定的偏置電流和偏置電壓,保證了運放的穩定性;並採用了帶調零電的密勒補償技術對運放進行補償。
  2. In the fifth chapter, a new fully differential operational amplifier with voltage and current - mode negative feedback has been proposed, which can stabilize its quiescent operation point, using the characteristic of mos transistors which operate in the triode region acting as active variable resistor, a fully differential fourth - order chebyshev low - pass filter with tunable frequency and bessel low - pass filter with accurate group delay based on r - mosfet - c and operational amplifier has been designed

    第五章:提出了一種新的既具有電壓共模反饋又同時具有電流共模反饋的全差分運算放大器電路,能較好地穩定電路的靜態工作點,並應用mos工作在線性區可作有源可變電用的特性設得到了截止可連續調節的高性能r - mosfet - c 、運放結構切比雪夫( chebyshev )和精確群時延值貝塞爾( bessel )低通濾波器。
分享友人