貫穿接頭 的英文怎麼說
中文拼音 [guànchuānjiētóu]
貫穿接頭
英文
penetrating connector- 貫 : Ⅰ動詞1 （穿; 貫通） pass through; pierce; thread 2 （連貫） be linked together; follow in a connt...
- 穿 : Ⅰ動詞1 （破; 透） pierce through; penetrate 2 （通過孔、隙、空地等） pass through; cross; go thro...
- 接 : Ⅰ動詞1 （靠近;接觸） come into contact with; come close to 2 （連接; 使連接） connect; join; put ...
- 貫穿 : 1 （貫竄） run through2 （穿過; 連通） breakthrough; penetrate; [醫學] transfixion;貫穿輻射 penet...
- 接頭 : 1 （連接起來） connect; join; joint 2 （找人聯系） contact; get in touch with; meet 3 （了解情況...
-
The following conclusions are gained : ( 1 ) the located shear band prongs the ligament near the top crack tip and the structure may occur shear - mode fracture at the angle of 155 ? to crack when load is 87. 92mpa ; the mode of fracture of the flange joint structure is not possible to be void - mode ; ( 2 ) it is proved that loading and then unloading repeatedly can not increase the possibility of invalidation of the structure when the times of loading and unloading are not too more when load is operating pressure ; the structure is safe when the vessel is operating ; ( 3 ) in the fe model of the thesis, not considering the influence of water pressure test which is in the process of fabrication of vessel in fe results in larger deviation in analysi
得出了以下結論：在8792mpa的載荷下筒體一封頭連接結構處的集中剪切帶貫穿韌帶，可能發生沿與原裂紋線成155 「角方向剪切型斷裂；筒體一封頭連接結構不可能發生韌窩型斷裂； （ 2 ）在工作壓力下進行次數不多的反復加、卸載，結構不會破壞，也不會喪失安定性：結構在工作狀態下是安全的； m在本文的彈塑性有限元模擬計算中，對于裂紋尖端進行力學分析時，不考慮壓力容器製造過程中水壓試驗的影響，將導致計算結果出現較大的偏差； （ 4 ）筒體完全屈服時的載荷為92石3mpa ，封頭完全屈服時載荷為86Since then, the mission operations team at nasas jet propulsion laboratory in pasadena, california, has run through nearly all its backup plans to try to contact the probe
此後，團隊作戰使命美國宇航局帕薩迪納噴氣推進實驗室，加利福尼亞貫穿幾乎所有的備份計劃嘗試接觸探頭
分享友人