起始脈沖 的英文怎麼說

中文拼音 [qǐshǐmàichōng]
起始脈沖 英文
firing pulse
  • 起 : 起Ⅰ動詞1 （站起; 坐起） rise; get up; stand up 2 （取出; 取走） draw out; remove; extract; pull 3...
  • 始 : Ⅰ名詞1 （最初; 起頭） beginning; start 2 （姓氏） a surname Ⅱ動詞（開始） start; begin Ⅲ副詞[書面...
  • 脈 : 脈名詞1. （動脈和靜脈的統稱） arteries and veins2. （脈搏的簡稱） pulse 3. （像血管的組織; 連貫成系統的東西） vein
  • 起始 : origin; origination; parentage; germ; initiation
  1. Multiple functions available ： start / crater arc current, increase / decrease time, base / crest value current, pulse frequency, pulse rate, post flow time, hf welding

    功能豐富：起始/收弧電流、上升/下降時間、基值電流、峰直電流、脈沖頻率、占空比、滯后關氣時間分別可調，高頻引弧。
  2. Multiple funcyions available : start / crater arc current, increase / decrease time, base, crest value current, pulse frequency, pulse rate, post flow time, hf / friction welding, water / gas cooling

    功能豐富：起始/收弧電流、上升/下降時間、基值電流、峰值電流、脈沖頻率、占空比、滯后關氣時間分別可調，高頻/接觸引弧、水冷/氣冷可供選用。
  3. The calculated results show that, for low energy protons ( energy less than several decade mev ), the contribution of proton nuclear reaction to energy deposition can be neglected ; while for high energy protons ( energy greater than several hundred mev ), the great difference appears for the above two cases. this gives us an indication that the contribution of proton nuclear reaction to the energy deposition must be concerned for high - energy protons. the propagation process in material of thermal shock wave induced by high - energy intense - current pulsed proton beam irradiation is calculated for several different proton energies

    對于入射能注量為418 （ j cm ~ 2 ）脈沖寬度為0 . 1 s的矩形脈沖強流質子束，計算結果表明，由於質子束能量不同，引起的初始熱激波（ 0 . 1 s時刻的熱激波）有單峰結構，也有雙峰結構，不同能量的強流質子束引起的熱激波在傳播的過程中都會出現明顯的彈性前驅波。
  4. Many experiments on the effects with the change of several parameters, such as initial charging current, amplitude and frequency of positive pulses, variety of the amplitude of positive pulses among each charging stages, amplitude and duration of negative pulses, duration between positive and negative pulses, have been performed. the results of analysis and comparison of experimental data verify the validity and feasibility of the fast - charging method. on this basis, a new type of control strategy is advanced

    就充電過程中的起始充電電流、正脈沖的幅值、正脈沖的頻率、各充電級之間正脈沖幅值的變化幅度、負脈沖的幅值、負脈沖的持續時間、正負脈沖之間的停歇時間等幾個參數進行了大量的實驗，對實驗數據進行分析和比較，驗證了快速充電方法的有效性和可行性，在此基礎上提出了一種新型快速充電控制策略。
  5. Calculations indicate that the carrier phase takes effect till the time width of the pulse envelope becomes smaller than the period of the carrier oscillation, and the interpretation of this phenomenon is also presented. it is the difference between phase delay and group delay that causes the sliding between the carrier and the envelope

    數值分析的結果表明，當脈寬小於光波周期時，相位的作用開始顯現出來，當脈寬比光波周期長時，載波相位的作用可以忽略，並分析了相位起作用的原因，用解析的方法說明正是相延遲和群延遲之間的差別造成了光載波在脈沖包絡下的滑動。
  6. By applying related theory of gas discharge and mathematical statistics, this paper more in - depth and systemic study the influence of the length of air gap, ice state, water conductivity and air pressure on the inception corona and pulse discharge characteristics, included the discharge frequency, discharge amplitude and time interval

    根據試驗結果，用氣體放電和數理統計方法，分析了覆冰水電導率、冰的狀態（乾冰和濕冰） 、空氣間隙長度、氣壓和施加電壓等參數的變化對間隙模型的起始放電電壓、脈沖放電特性、放電頻率、放電幅值和時間間隔等的影響。
  7. Chapter 3 concentrates on the important technology of pd radar ' s data processing. this chapter includes the resolution of range and velocity ambiguity and the theory of the start of tracking, the refreshment of tracking, the disappearing of tracking and the single target tracking. in the part of the refreshment of the tracking, the, the theory and realizing of the filtering algorithm and the point ? tracking relating are illustrated

    第三章重點敘述了脈沖多普勒雷達數據處理的關鍵技術，包括數據錄取時距離和速度的解模糊； pd雷達工作在搜索狀態下目標航跡的起始，航跡的更新，航跡的消失，以及目標的編批和最優先級目標的判斷，其中航跡更新中主要講述了跟蹤濾波和點跡?航跡關聯的原理及實現； pd雷達工作在跟蹤狀態下的單目標跟蹤原理。
  8. A 0 bit is represented by an impulse followed by a pause ; a 1 bit is a pause followed by an impulse ; a start or stop bit is a pair of impulses

    0表示一單位脈沖加上一單位暫停； 1則為一單位暫停加上一單位脈沖；起始或結束位元，則為兩單位脈沖。
  9. Distortion of start - stop teletypewriter signals. the shifting of the end of all marking pulses from their proper positions in relation to the beginning of the start pulse

    起-止式電傳打字機信號的畸變，即所有信號脈沖的末端相對于起始脈沖的始端對其正確位置的偏移。
  10. In addition, the spacing between the pulses in the start bit allows the receiver to measure the transmission rate ; the rate does not need to be fixed in advance

    除此之外，也不必事先固定傳輸速率，因為接收器可透過起始位元內兩脈沖之間的距離，測量出傳輸速率。
分享友人
分享到 Line

分享到臉書