超速檢測器 的英文怎麼說

中文拼音 [chāosùjiǎncèqì]
超速檢測器 英文
over speed detector
  • 超 : Ⅰ動詞1 （越過; 高出） exceed; surpass; overtake 2 （在某個范圍以外; 不受限制） transcend; go beyo...
  • 速 : Ⅰ形容詞（迅速; 快） fast; rapid; quick; speedy Ⅱ名詞1 （速度） speed; velocity 2 （姓氏） a surna...
  • 檢 : Ⅰ動詞1 （查） check up; inspect; examine 2 （約束; 檢點） restrain oneself; be careful in one s c...
  • 測 : 動詞1. （測量） survey; fathom; measure 2. （測度; 推測） conjecture; infer
  • 器 : 名詞1. （器具） implement; utensil; ware 2. （器官） organ 3. （度量; 才能） capacity; talent 4. （姓氏） a surname
  • 超速 : 1 （超出速度限制） exceed the speed limit; overspeed; over speed 2 [力學] hypervelocity; 超速保護...
  • 檢測器 : detector
  • 檢測 : check; detection; test; gauging; detecting; sensing; [工業] checkout; measuring
  1. Its leading products for static and dynamic electronic truck scale short table, electronic ground value, electronic platform scales, electronic truck scale load meter, portable weighing device, bending plate sensor, pre - gauge high - speed detection, highway overweight detection system, weight fees and anti - cheating weighing system and so on

    營業執照其主導產品為靜動態短臺面電子汽車衡、電子地上衡、電子臺秤、電子汽車衡地磅，便攜式稱重儀，彎板式傳感器，高速預檢超限檢測，計重收費，防作弊稱重系統等。
  2. This research offers the technical scheme of detecting ulf absolute vibratory signal by the normal electromagnetism rate transducer

    本研究提出了一種利用普通的電磁式速度傳感器檢測超低頻絕對振動信號的技術方案。
  3. Test shows that this research can solve the problem of which the normal electromagnetism rate transducer can not inspect the ulf absolute vibratory

    實驗表明，本研究方案較好的解決了普通電磁式速度傳感器不能檢測超低頻絕對振動問題。
  4. Abstract : it is expounded the composition and detection method of the diagnostic system of dynamic failure for locomotive running gear. also discussed are the key technologies as ultrasonic resonance demodulation, identification of locomotive type & speed, message sampling of sensors tracing running mechanism and three dimensional diagnosis, as well as the feasibility test

    文摘:闡述了機車走行部動態故障診斷系統的組成及檢測方法，介紹了超聲共振解調、車型車速識別、多個傳感器跟蹤運動機械的信息采樣、三維診斷等關鍵技術及其可行性試驗情況。
  5. In principle, ultrasonic sensors are suspended over a road, which keep emitting pulse signals periodically to nearby and feed back waves to decide existence of any obstacles, thus to detect the speed, height, length, different sizes ( heavy, medium and small ) of moving vehicles and accumulative flow as well as length of motorcade. optionally, it can be applied to multitude driving lanes simultaneously for traffic data. by integrating and analyzing these measured data, the necessary figures concerning traffic flow may be obtained, which are fundamental basis guiding road buildings

    本課題設計的是一種懸掛式超聲波車流多信息檢測器，通過懸掛于路面上方的超聲波探頭向路面周期性地發射脈沖信號，利用地面回波來判斷遮擋物地存在，可用於檢測行駛中的機動車車速、車高、車長、大中小分型以及累計車流量、車隊長度等信息，並可用於多個車道車流信息的同時檢測，綜合這些測量參數可獲得車流量的必要數據，可為公路建設提供必要的基礎依據。
  6. The data acquisition and data flow for various sensor carriers are analyzed systematically, and the calculation models are put forward. the model of quantification of wall - loss defects for in - line inspection with ultrasonic pigs has been established. and inspection data can be pretreated with this model, compressed with dpcm technique and treatd by dsp instruments

    建立了檢測頭數據採集量及數據處理速率模型，首次建立了管道壁缺陷液浸超聲檢測的量化分析模型；提出採用該模型進行數據預處理后，採用差分脈碼調制技術進行數據壓縮，採用dsp器件提高數據處理速率。
  7. Single - loop flash and sound alarm controller adopts advanced microprocessor for smart control, and can match use with our any control instrument or other contact check control instrument. it can be conveniently fabricated into multi - loop alarm system. on the field normally open normally closed input mode are optinal for users

    超大屏幕單迴路數字顯示控制儀採用先進的微處理器進行智能控制，適用於溫度濕度壓力液位瞬時流量速度等多種物理量檢測信號的顯示及控制，並能對各種非線性輸入信號進行高精度的線性校正。
  8. This strategy has many advantages : solving the problems that the system is unsteady under super - synchronization ; improving power factor of stator ( it is unity relative to that of rotor ) ; no rotor position sensor and no initial position measurement, easily building up doubly fed speed adjustment system with speed sensorless because adjusting speed is taken in the rotor coordinate and rotor current vector fixing is implemented

    該方案由於引入了定子電流勵磁分量的閉環控制，使系統同時具有轉速和勵磁調節兩個調節通道，具有如下優點：一、解決了超同步工作工況不穩定的問題；二、提高了定子側的功率因數（與轉子側功率因數為1相比） 。三、由於速度調節在轉子坐標系下進行，並以轉子電流矢量定向，所以無須轉子位置傳感器，也不用檢測初始位置，易於組成無速度傳感器雙饋調速系統。
  9. Prosecutors in the belgian capital, overwhelmed by the number of speeding fines imposed since fixed radar traps were installed, have asked police to let off all but the worst offenders - - angering local mayors

    自從比利時首都布魯塞爾設置固定式雷達測速器后，檢察官被堆積如山的超速罰單壓得喘不過氣來，因此要求警方除對犯行最重的駕駛開罰外，不要對其他超速駕駛開單這讓區長們大為光火。
  10. In order to solve this problem, this research adopts the electrical self - regulation circuit in series, on the basis of the unchanged of transfer function of electromagnetism rate transducer, extend frequency bandwidth of the transducer, improving its capability. after the self - regulation, the transducer has high passing feature and inferior lower lever cut - off frequency ( below 1 hz )

    為了解決普通電磁式速度傳感器不能檢測超低頻振動信號的問題，本研究採用了一種串聯式電子補償電路，在保持電磁式速度傳感器的傳遞函數性質（高通）不變的前提下，拓展了傳感器的頻寬，改善了傳感器的性能。
  11. Finally, a design of a fast and accurate sonar - ring sensor for a mobile robot is proposed

    第四，提出了一種可用來對移動機器人周邊環境實現快速檢測的超聲環的設計思路。
  12. According to the structure characteristics and motion rules of the new type nursing robot, the close loop control system of this new type nursing robot is designed and made with the virtual instrument developing software labwindows / cvi, mcu, piezoelectric ultrasonic motor and high precision optical incremental encoder, which can make the robot reset and rotate by the predefined tracks. at the same time, in order to make the nursing robots used more widely where intensity, precision and price are not high, another control system is designed with the step motor, virtual instrument developing software labwindows / cvi, multi - function daq card pci1711, linear power amplifier. in order to use the nursing robots in acupuncture therapy, a simple finger is designed

    在對其結構特點和運動規律分析的基礎上，本文以虛擬儀器編程語言labwindows / cvi為軟體開發工具，以單片機為控制核心，以超聲電機為驅動元件，以高精度光電編碼器作為速度和角位移檢測裝置，實現了機械臂的復位以及預定軌跡的閉環控制系統的開發;同時為適應一些強度不大、精度要求不高的應用場合，也為降低成本，簡化控制裝置，推動新型護理機械臂短期內應用推廣的需要，以目前應用較為廣泛、控制技術較為成熟的步進電機為驅動元件，用labwindows / cvi開發環境、 pci1711數據採集卡以及線性功率放大器開發了一套控制系統，實現了手臂的復位、勻速運動以及預定軌跡的控制系統;為推廣護理機器人在針灸理療中應用，設計了簡單的手指機構並利用labwindows / cvi開發環境，以及智能材料驅動器? ?層疊式壓電驅動器，進行了手指的抓取以及對驅動對象的轉動控制。
分享友人
分享到 Line

分享到臉書