超高粘度 的英文怎麼說

中文拼音 [chāogāonián]
超高粘度 英文
hyperviscosity
  • : Ⅰ動詞1 (越過; 高出) exceed; surpass; overtake 2 (在某個范圍以外; 不受限制) transcend; go beyo...
  • : Ⅰ形容詞1 (從下向上距離大; 離地面遠) tall; high 2 (在一般標準或平均程度之上; 等級在上的) above...
  • : 粘動詞(粘附) glue; stick; paste; adhere to; bond
  • : 度動詞[書面語] (推測; 估計) surmise; estimate
  • 超高 : 1 (鐵路彎線的外軌加高) superelevation2 (船的出水高度) freeboard; freeboard height3 super high...
  1. Ultrasonic has being attracted much attention gradually in fuel atomization because of some specialities of cavitation and infection on liquid flow. in the course of atomization of pitchy oil, especially, does it show greatly its advantage, but its material atomizational mechanism need research ulteriorly. the primary content of this thesis is about adding cantilever reed to effervescent atomizer so as to combine ultrasonic and effervescent. this thesis has discussed ultrasonic some mechanism, ultrasonic dynamical procreator, effervescent and liquid mucosity infection on atomization, at the some time we make some experiments and discuss atomization rule following some machinery parameter and run parameter so as to find some rule about ultrasonic atomization and to rich the research of ultrasonic atomization mechanism. all that will be beneficial to the design about ultrasonic atomization atomizer

    聲波由於其空化機理及對液體的流變性影響等特性,在燃油霧化燃燒中逐步引起人們的重視,尤其在重渣油等液體的霧化過程中逐步顯示出其優越性,但其具體的霧化機理還需要做進一步的研究在氣泡霧化噴嘴基礎加入懸臂式簧片哨,將聲波與氣泡霧化相結合是本文討論的主要內容本文從研究聲波的一些機理入手,討論了聲動力發生器氣泡霧化以及液體對霧化質量的影響,並通過具體的實驗,根據實驗數據來討論霧化質量隨各種結構參數運行參數的變化規律,以便找到聲霧化的一些規律,豐富對聲霧化機理的研究,對聲霧化噴嘴的設計具有一定的指導意義。
  2. This article aims at the boiler ' s problems in operation : 1 ) under nominal load, the smoke temperature at the outlet of hearth reaches 1200, far more exceeds 1050 the original designed temperature. this will always result in slag inside boiler and the temperature of overheater ' s pipe superheat, so that boiler cannot take nominal load and all these influence boiler ' s nomal operation heavily, 2 ) this article also studied the reason why the assistant oil becoming necessary when coal changes. during the nomal operation, many factors ( makeup of combustor and its disposal, smirch and encrust of water wall, excessive air coefficient, temperature of primary air, coal type and density of coal dust ) can deviate the designed working conditions, then affect the boiler ' s nomal operation

    本文針對該鍋爐在實際運行中存在的問題:在額定負荷下,爐膛出口溫、低溫段過熱器前煙溫達936 ,遠遠過815的設計值;噴燃器四周水冷壁結焦嚴重,過熱器管壁溫標,無法帶上額定負荷;甚至有時因燃煤質量的變化,必須投油助燃的嚴重情況進行了分析研究。在實際生產過程中,燃燒器的結構、布置,水冷壁的污、結垢,過剩空氣系數、一次風溫、煤種及其濃變化等許多因素都會偏離鍋爐的設計工況,從而影響爐內的傳熱和燃燒,造成爐膛出口溫、水冷壁結渣等問題。
  3. Rolling - cutting biscuit shaping machine is new equipment of making soda biscuit, good toughness of thin biscuit and super - thin biscuit. it ' s high production efficiency, low noises, safe operation, convenient, beautiful outer shape. this machine can press and roll rough flour 3 times and equiped with remaining flour recycling machine, also equiped with double - rolling cutting shaped equipement, in the mean time, it can produce two biscuit embryo of differnt shape. 3 times pressing - rolling machine can adjust different thickness and biscuit rough surface. it can roll rough flour and do not stick to rough flour embryo, correctness rate of adopting mould to cut margin of flour embryo reaches 100 percent so that avoid deforming of embryo due to deviation. this machine is one equipment which adopting advanced and won first technical rewarding for its independently control operation, beautiful outer appearance

    滾切式餅干成型機是連續製作梳打餅、韌性和薄餅薄餅的新型設備,具有生產效率、噪音低,操作安全、方便,外型美觀等優點,本機具有三道軋輥制皮和余料回收機,配備雙滾切成型裝置,同時能生產兩種不同形狀的餅干胚不停機,三道軋輥能同時調節不同厚和餅皮具有軋輥不皮、採用印模切邊一次同步進行準確率100 % ,避免偏差而造成餅胚變形,該機具有獨立控制操作,外形美觀,是目前國內較先進而獲得技術一等獎的設備。
  4. But some problems with self - compacting concrete such as high slump loss and the difficulty of harmonizing the cohesiveness and the flowability should be solved. the theory of concrete mix design should also be perfected. in accordance with these problems, this thesis carry out such research works as follows to deal with them

    然而,免振搗混凝土特別是強免振搗混凝土坍落損失大,聚性和流動性難以統一以及易產生收縮裂紋的問題亟待解決;免振搗混凝土的配比設計理論也需要進一步地加以完善。
  5. Regard to this problem, hengxing company, through repeated and numerous experiments, has finally concluded a solution : we use a kind of ultra - wear - resisting and high - molecular material to fix, stuck by a super bond, on the surface of the frame

    造成磚坯質量不同程的降低,針對這種問題,恆星公司的技術部門,經反復實驗,終于總結出一種方法,用一種耐磨,分子材料,配以合劑,將其固定在模框表面。
  6. Sometimes, some silty soil, super soft soil, because of its high compressibility, low strength, high water component, high dexterousity, has notable rheological behavior

    往往某些淤泥質土、土,其壓縮性、強低、含水量、靈敏,具有較顯著的流變特性。
  7. Double deck compounding fusing machine belt : with static - resistance varnished cloth inside and tearing - resistance fiberglass cloth outside, the compounded belt has a great improvement on its intensity, long using life, well balanced thickness, excellent deflecting preventing capacity, smooth surface, it ' s better for super thin lining

    雙層復合合機帶:雙層復合帶內層用抗靜電漆布,外層用抗撕纖維布,整體錯位復合而成.強大幅,使用時間長,整體厚均勻,防偏性能好,表面光滑細膩,加工合襯更佳。
  8. Because of the clay and aggregation in the soil, which induces the permeability to be bad, excessive pore water pressure produced in the process of dynamic consolidation does not dissipate quickly ; it will lead to the deformation and the failure of the soil

    世紀花園飽和地基土由於存在粒及集聚體,強夯后使土的滲透性變差,孔隙壓力難以快速消散,致使土發生變形破壞。
  9. Uhvi ultra high viscosity index

    超高粘度指數
  10. In addition, but also specially will set up a transportation plan organization, will planed strengthens between the organization as the improvement road invest the cooperation and a coordinated expert organization. the budget of this project is about 1. 4 million us dollars, chinese government will provide approximately 400, 000 us dollars including personnel and the material investment

    通過培訓,與會站長認為:金客車是中國大的客車生產基地, lg潤滑油是世界最大的石油化工企業,原裝進口,指數合成油,二者強強聯合,共同為金客車的使用者提供最優質的服務,給客戶創造價值。
  11. Aminobenzenesulfonic acid super - plasticizer is selected though cement paste test, which be provided with high water - reducing property, low slump loss and good compatibility with cement. according to the request of super high early strength, admixture rf is obtained though tests to compare performances of different accelerators and admixtures. experimental research and analysis are carried out on coarse aggregate ' s grain - size effect and composite aggregate ' s bulk - density to take sensitivity of coarse aggregate into account

    通過水泥凈漿試驗比較選擇了減水率、坍落損失小、與水泥適應性好的氨基苯磺酸鹽效減水劑;針對早強的性能要求,試驗比較了不同早強劑及早強性摻合料的性能表現,研製了早強性能顯著、與效減水劑和水泥相容性較好的rf摻合料;考慮到修補混凝土對粗集料粒徑的敏感性,對粗集料粒徑效應及混合集料堆積密進行試驗研究與分析;並對修補混凝土的抗折、抗壓、新老界面結強以及抗凍性等進行了試驗研究。
  12. For the purpose of improving calculation precision and reduce workload, viscoelastic similar shape element is generated in the numerical research about crack problem, using the characteristic of similar stiffness matrix between element near crack tip

    在裂紋問題的數值研究中,為了提計算精、減輕計算工作量,構造了彈性相似界面單元,利用裂尖附近相似單元剛陣相似的特點,採用聚縮法形成裂尖級單元。
  13. The poor adhesion of non - polarity ultra - high molecular weight polyethylene ( uhmwpe ) fiber with commonly polar resin matrix limits its applications in structure composites. in order to improve adhesion of uhmwpe fiber with matrixs, three methods are explored in this work, which are uhmwpe fiber surface treatment, synthesizing ve resin and introducing carbon fiber to co - hybrid with uhmwpe fiber

    論文針對分子量聚乙烯( uhmwpe )纖維接性差,沒有合適的既能與之獲的良好接界面又可以獲得良好結構強的樹脂基體的問題,展開了纖維表面的鉻酸氧化處理、合成ve樹脂以及採用碳纖維進行混雜三種途徑的研究。
  14. Super hard sub micron grade with 3 % binder and an outstanding hardness of 2000 hv30. excellent resistance against wear, not suitable for metal cutting operations

    加入了3 %的合劑,是硬的牌號,晶粒為亞微米級,硬達2000hv30 。極好的耐磨性,不適合金屬切削操作。
  15. The result shows that aerobic produced water, increasing polymer concentration and using high molecular weight polymer can increase the viscosity of polymer solution with produced water

    結果表明,污水暴氧、提聚合物濃及採用分子聚合物,可有效提污水聚合物溶液的,是保證污水注聚的有效手段。
分享友人