距離垂線 的英文怎麼說

中文拼音 [jùlíchuíxiàn]
距離垂線 英文
range vertical
  • 距 : Ⅰ名詞1 （距離） distance 2 （雄雞、雉等的腿的後面突出像腳趾的部分） spur （of a cock etc ）Ⅱ動詞...
  • 離 : Ⅰ動詞1 （離開） leave; part from; be away from; separate 2 （背離） go against 3 （缺少） dispens...
  • 垂 : Ⅰ動詞1 （東西的一頭向下） hang down; droop; let fall 2 [書面語] （敬辭 多用於長輩、上級對自己的行...
  • 線 : 名詞1 （用絲、棉、金屬等製成的細長的東西） thread; string; wire 2 [數學] （一個點任意移動所構成的...
  • 距離 : 1 （相隔的長度） distance; range; gap; space; spacing; separation 2 （相距） be apart from; be aw...
  1. The helicopter is allowed to fall the same distance that it climbed at the beginning of the maneuver before pulling the helicopter back to straight and level flight

    待直升機垂直俯沖的距離與垂直爬升的距離相同時，拉起機頭恢復成水平直線飛行。
  2. Those sensitive parameters making system have negative damping and occur self - excited shimmy are horizontal pulling lever rigidity, tire sideslip rigidity, steering gear rigidity and damping, kingpin equivalent damping, kingpin caster angle, tire drag. and wheel center distance, tire side rigidity, vehicle wheel unbalanced mass, tire vertical rigidity, and distance from kingpin center to the vertical central line plane of tire have great influence on shimmy, but they do n ' t make the system have negative damping. and horizontal pulling lever damping, suspension damping and rigidity have very small influence on shimmy

    橫拉桿剛度、輪胎的側偏剛度、轉向機剛度、轉向機阻尼、繞主銷當量阻尼、主銷后傾角、輪胎拖距是影響擺振的敏感性參數，適當調節某一參數可引起系統的負阻尼，使系統產生自激擺振；輪距、輪胎側向剛度、車輪上的不平衡質量、輪胎垂向剛度及主銷延長線與地面交點至車輪平面的距離對擺振的影響也較大，但不會使系統出現負阻尼；而橫拉桿阻尼、懸架阻尼與懸架剛度對擺振的影響很小。
  3. The line spacing is the vertical distance between the base lines of two consecutive lines of text

    行距是兩個連續文本行的基線之間的垂直距離。
  4. The position and size of the monochromator, focusing curvature radii and tilting angles of the germanium focusing monochromator under different different take - off angle, size and divergency of the second collimator and intensity loss due to the use of it were determined. the neutron flux at different wavelength, under different reflection and take - off angle of the monochromator and divergency of the first collimator, were given. the simulation on the aperture used for limiting beam size in front of the sample showed that, smaller the size of the aperture and further the distance from the aperture to the sample, greater the loss of the intensity and more serious the spread of the beam along vertical direction at the sample position which makes the practical sampling volume greater than expected

    用蒙特卡羅模擬方法對中子應力衍射譜儀的設計方案進行了優化研究，提出了一系列可供參考的數據：確定了單色器的位置、尺寸、垂直聚焦單色器在不同起飛角下的聚焦曲率半徑和傾角；討論了第二準直器的尺寸和發散，以及使用第二準直器造成的強度損失；給出了在不同單色器反射面、起飛角、中子波長和第一準直器發散度的情況下樣品處的中子注量率，以及多種組合情況下譜儀的解析度曲線；對限束方孔的尺寸、距離樣品遠近對強度損失和測量中的影響做了深入研究。
  5. It shows that the method suggested in the paper is simple, applicable for engineering and has good precision. on the bases of the formulas deduced, and combining with relative test datas, it studies in the paper several factors influencing the bearing performance of the simple beams, such as shape of the external tendons, the equal moment segment length, span - to - depth ratio of the beam, valid initial prestress of the external tendons, area of the internal tension reinforcement, strength of the concrete, vertical distance between

    在公式推導的基礎上，結合相關試驗資料，研究了體外筋的形狀、等彎矩區長度、梁跨高比、有效張拉預應力、體內受拉筋配筋率、混凝土強度、錨固點到樑上邊緣在垂直方向上的距離、體外預應力筋水平段長度（雙折線型體外筋的情況）以及荷載類型等對體外預應力混凝土簡支梁受力性能的影響。
  6. Use snaplines to align them vertically and to space them evenly

    使用對線垂直排列這些控制項並使其等距離間隔。
  7. In june, italian and foreign engineers completed an 11 - year, $ 27 million restoration project to reduce its tilt by 16 inches

    今年六月，義大利工程師和國外同行完成了一項修復工程，這項修復工程耗時11年，耗資27 ， 000 ， 000美元，將斜塔距離垂線的距離矯正了16英寸。
  8. Officials closed the tower in 1990, when it leaned by a dangerous 13 feet off the perpendicular. in june, italian and foreign engineers completed an 11 - year, million restoration project to reduce its tilt by 16 inches

    今年六月，義大利工程師和國外同行完成了一項修復工程，這項修復工程耗時11年，耗資27 ， 000 ， 000美元，將斜塔距離垂線的距離矯正了16英寸。
  9. The perpendicular distance from the base of a geometric figure to the opposite vertex, parallel side, or parallel surface

    頂垂線，高線從一個幾何形體的底邊到相對的頂點、平行邊或平行面的垂直距離
  10. Integrated the monitoring data collected from the scene of blast with the correlative theory of earthquake wave, the blast vibration characteristic of this underground blast engineering and the influence that the blast vibration act on the ground buildings are analyzed. applied the method of duality linearity regression analysis, the propagation attenuational laws of blast earthquake wave in this underground engineering are gained by this software matlab. the analysis results indicat that the attenuational laws of blast earthquake wave are obvious diversity in the condition of difference distances

    結合採集到的大量爆破振動現場實測數據，並應用地震波的相關理論，分析了該地下工程開挖爆破的地面爆破振動特性及爆破振動對地面建（構）築物的影響;應用二元線性回歸分析法，通過matlab軟體計算得出該地下工程開挖爆破地震波的傳播衰減規律;分析結果表明，不同距離下的地面爆破地震波的衰減規律存在明顯的差異，近距離條件下爆破地震波的垂直方向分量衰減最慢，遠距離條件下垂直方向分量衰減最快，遠距離的爆破地震波的垂直方向分量和水平徑向分量的衰減指數均要比近距離相應的爆破地震波衰減指數要大。
  11. In a three - dimensional ocean model with curvilinear coordinates horizontally and a coordinate vertically, the adapted grids at a layer for interpolation in the eulerian - lagrangian method ( elm ) is unreasonable over steep topography, because the vertical distance between the adjacent grids in the same a layer is too large

    摘要在水平曲線坐標和垂向坐標的三維海洋模式下，歐拉拉格朗日方法的插值如果在-面相鄰網格之間進行，那麼在水深變化劇烈處，由於-面相鄰網格之間的垂向距離較大，插值依據會顯得較不合理。
  12. The vertical mixing law of the linear source in the natural river has been studied in the second step. at first the concentration equation of the linear source at different depth has derived. by the theoretical analysis, the relationship between the distance of the vertical homogeneous mixing and the part depth of homogeneous mixing, and the equation calculated distance of whole depth homogeneous mixing for the linear source have been presented

    通過理論推導，得出任意位置上瞬時線源濃度場的解析解表達式；推導得到表面不同深度線源排放時垂向部分均勻混合水深隨縱向距離變化規律的函數關系，並建立了相應變化規律的諾莫圖；導出了表面不同深度線源在全水深均勻混合時的縱向距離的計算公式，應用長江口南通河段實測資料驗證，得到一致結果。
  13. Secondly, according to convex geometric characteristics, a common - perpendicular - line algorithm is developed for the distance between the convex nurbs surfaces by making surfaces discrete, approximating the distance by one between convex hulls of discrete surfaces and solving a linear programming problem to get their vertical projective length on common perpendicular direction, that is, the original distance

    然後，針對凸曲面的幾何特徵，給出了nurbs凸曲面間距離求解的公垂線法和切平面法。公垂線法是把曲面間的距離求解問題轉化成曲面的離散點生成的凸殼間的距離，再歸之為兩凸殼在其公垂線上投影集合間的距離，由此抽象成一個線性規劃問題，估算出近點對。
分享友人
分享到 Line

分享到臉書