車輛鑒定 的英文怎麼說

中文拼音 [liàngjiàndìng]
車輛鑒定 英文
fahrzeugbewertung
  • : 車名詞1. (中國象棋棋子的一種) chariot, one of the pieces in chinese chess2. (國際象棋棋子的一種) castle; rook
  • : 量 (用於車)
  • : Ⅰ名詞1 (鏡子 古代用銅製成) ancient bronze mirror2 (可以作為警戒或引為教訓的事) warning; objec...
  • : Ⅰ形容詞1 (平靜; 穩定) calm; stable 2 (已經確定的; 不改變的) fixed; settled; established Ⅱ動詞...
  • 車輛 : vehicle; car; rolling stock; tram; seater; carriage
  • 鑒定 : 1 (評語) appraisal (of a person s strong and weak points) 2 (評定) appraise; identify; auth...
  1. First, the wheelset is fixed and rotated by the device used hi vehicle depot as usual. second, the center line of wheelset axis is determined by a device called axis - center probe. last, the acting device for sensor can draw a whole felloe profile, which is made up of parallel - pole device and rotating - probe

    於此,本文給出了一種全新的測量方案:採用段普遍使用的轉輪器實現被測輪對的位;採用軸基準探尺測被測輪對的軸線;採用並聯式伸縮機構和旋轉測頭作為傳感器的執行機構,測輪輞斷面的輪廓線。
  2. The research work of this paper provides the consultable control strategy for further development in vehicle stability control system, meanwhile it also vail to analyze and simulation experiment of the vehicle motion

    本文的研究工作為進一步發展性控制系統提供了可借的控制策略,同時也對研究運動分析及其模擬實驗有一的幫助。
  3. The following works are carried out in the dissertation : the study of meter - gauge freight car intensity design and accreditation test specifications ; the structural design of meter - gauge covered car of 14t axle - load ; the finite element analysis of car body structure of meter - gauge covered car of 14t axle - load ; the structure optimization of meter - gauge covered car of 14t axle - load. specification of intensity design for meter - gauge freight wagons is a combination of the theoretical calculations, long - term tests and the data of the application and maintenance of the rolling stock

    本文主要進行以下工作:米軌貨強度設計與試驗規范的研究14t軸重米軌棚結構設計14t軸重米軌棚體結構有限元分析14t軸重米軌棚的結構優化設計米軌貨強度設計與試驗規范是集理論計算、長期試驗、運用及檢修數據累計分析的結果。
  4. Road vehicles - electromagnetic compatibility test procedure of motor vehicles - part 2 : qualification of the immunity to electromagnetic interference in a semi - anechoic chamber

    道路.汽的電磁兼容性試驗程序.第2部分:半隔音室的抗電磁干擾的合格
  5. Finaly, according to the the temporary criteria for the strength design and test accreditation about the passenger car that can run at 200km / h speed or upwards, intensities of the frame and swing boster are analyzed

    最後,按《 200km h及以上速度級鐵道強度設計及試驗暫行規》的要求對構架和擺枕的強度指標進行了校核。通過校核可以看出,構架和擺枕的強度滿足要求,而且還有一的裕量。
  6. With the help of the whole optimization, the effective volume capacity was broadened, the deadweight was decreased to 23. 77t, and the load capacity was up to 60t. the intensity and the rigidity of the car were both measure up tb / t1335 - 1996 railway vehicle - specification for evaluation the intensity design and accreditation test

    通過整體的優化設計,增大了的有效容積,使的自重降低到23 . 77噸,設計載重提升到60噸,體的剛度、強度均符合tb t1335 ? 1996 《鐵道強度設計及試驗規范》的要求。
  7. Road vehicles - electromagnetic compatibility test procedure of automotive components - part 6 : qualification of the immunity to narrowband interference according to the current injection procedure

    道路.汽部件的電磁兼容性試驗程序.第4部分:根據通用噴射程序窄帶抗干擾性的合格
  8. Road vehicles - electromagnetic compatibility test procedure of automotive components - part 5 : qualification of the immunity to narrowband interference according to theabsorptive chamber procedure

    道路.汽組件的電磁兼容性試驗規程.第5部分:根據吸收室規程進行抗窄帶干涉性的合格
  9. Road vehicles - electromagnetic compatibility test procedure of automotive components - part 3 : qualification radiation emitted interference

    道路.汽部件的電磁兼容性試驗程序.第3部分:合格輻射干擾
  10. Railway vehicles - specification for evaluation the dynamic performance and accreditation test

    鐵道動力學性能評和試驗規范
分享友人