軸應力 的英文怎麼說

中文拼音 [zhóuyīnglì]
軸應力 英文
axial stress
  • 軸 : 軸Ⅰ名詞1. （圓柱形的零件） axle; shaft 2. （對稱部分的直線） axis 3. （圓柱形的纏繞器物） roller; spool Ⅱ量詞（用於纏在軸上的線以及裝裱帶軸子的字畫）
  • 應 : 應動詞1 （回答） answer; respond to; echo 2 （滿足要求） comply with; grant 3 （順應; 適應） suit...
  • 力 : Ⅰ名1 （力量; 能力） power; strength; ability; capacity 2 [物理學] （改變物體運動狀態的作用） forc...
  1. This theory can be extended to biaxial stress.

    這個理論能推廣到雙軸應力。
  2. A body is said to be in a state of plane stress or alternatively in a two-dimensional or biaxial state of stress.

    據稱該物體處于平面應力狀態或二維應力狀態或雙軸應力狀態。
  3. The subject for different process technology and surface treatment of crank takes tracking checkout for its internal stress, analyses relation of jumping measurement, deformation measurement, recovery measurement and stress change, finds the reason and usual law of jumping overproof of crank. through cold pressure alignment, hot pressure alignment, support aged alignment and so on methods for 42crmo steel crank, the subject checks change of stress in the process of alignment and change of tissue and property after alignment for crank, and gives comprehensive evaluation for every alignment technology, then give safe and feasible technology parameter

    本課題主要是對不同加工工藝及不同表面處理過程的曲軸，對其內應力進行跟蹤檢測，分析各工藝過程中跳動量、變形量、恢復量與應力改變的關系，找出曲軸跳動量超差的原因和一般規律。通過對42crmo鋼曲軸進行「常溫壓力校直」 、 「熱壓力校直」 、 「支撐時效校直」等方法的校直，檢測校直過程中曲軸應力的變化及校直后組織和性能的改變，進而對各校直工藝進行綜合評價，給出安全可行的工藝參數。
  4. It is frequently accelerated by the presence of an active environment and by triaxial stress.

    激化環境和存在三軸應力，常可加速這種破壞。
  5. Based on the experimental data of rotor steel 1crmov in the loading of low - cycle fatigue at high temperature, the strength behavior and the fatigue life curve of this material at 550 have been achieved. meanwhile, with respect to three kinds of notched bar, their material damage assessment method under multiaxial stress condition is discussed

    本文在1crmov材料的高溫低周疲勞實驗數據進行了整理和統計的基礎上，得到了材料的疲勞強度特性曲線和疲勞壽命曲線，同時對三種不同缺口形式的圓柱形試件進行了多軸應力狀態下的材料損傷的研究，並通過數值計算方法進行了疲勞壽命評估。
  6. For pump shafts, the results reveal that the stress in the spline is higher than the other parts of the shaft, and the highest stress is at bottom and terminal of the spline. in fact, the broken of shafts is at the same position ; it demonstrates that the calculation is right

    實踐證明，軸斷部位基本集中在潛油泵軸花鍵的根部，說明計算結果和實際是吻合的；對于潛油電機軸，應力集中點主要處在軸承鍵與環槽的交界處和花鍵的根部。
  7. In this paper, a more practical strength criterion equation of concrete in biaxial stress strength is taken into account. the result from this criterion equation agree well with the various test data and empirical curves and hence the equation can be put into the use of practical calculation easily

    對混凝土在壓-壓受力破壞時的強度準則進行了研究，在分析中因二軸應力強度不可忽略，最終推導了一個簡單的、計及二軸應力強度影響的強度準則公式，該公式與諸多可資利用的試驗成果吻合較好，可較好地應用於實際計算之中。
  8. Stress distribution and fatigue analysis of the extraction hollow shaft of raw meal tube mill

    生料管磨機出料中空軸應力分佈及疲勞分析
  9. With the typical on - axis fatigue tests to get the relative s - n curves of unidirectional laminates, executed at certain stress ratio, it is possible to predict the fatigue life of multidirectional laminates subjected to cyclic stresses of different stress ratios. this would tremendously reduce test costs for laminate structures

    考慮了層壓板中單向層面內多軸應力和平均應力的影響，在已知單向板在確定應力比下受典型單軸循環應力的s - n曲線的基礎上，預測任意鋪疊次序層壓結構在不同應力比的循環載荷下的疲勞壽命。
  10. Effect of equilbrant on univevsal shaft stress in large rolling mill

    平衡力對大型軋機萬向接軸應力狀態的影響
  11. Biaxial stress of ferromagnetic materials and residual stress of welding components have been measured by using the relation between barkhausen effeet based on the law of approach to saturation magnetization and internal stress

    利用該技術，以近飽和磁化產生的巴克豪森效應與應力的關系，測量了鐵磁構件的二軸應力和焊接構件的殘余應力。
  12. Development of testing machine for coupled seepage and triaxial stress measurements in rocks

    三軸應力耦合試驗機的研製
  13. In recent years, pro f bazant has been devoting to the work ofmicroplane theory microplane theory a theory on the basis of micro - mechanics, has excellent ability of describing not is iv only the concrete constitutive behaviors under non - proportional load but also the damage behavior of concrete under multi - axial stresses

    著名學者z . p . bazant教授近十年一直致力於微平面理論的研究，該理論對于描述混凝土在非比例加載下的本構行為和混凝土在多軸應力作用下的損傷行為具有優勢。
  14. Biaxial stress strain relation

    雙軸應力
  15. Energy dissipation in particulate - reinforced viscoelastic materials under the condition of high stress triaxiality

    高三軸應力條件下粒子填充粘彈性材料的能量耗散
  16. Calculation of stress intensity factors for cracked diesel engine crankshafts

    含裂紋柴油機曲軸應力強度因子計算
  17. Tri axial stress

    三軸應力
  18. Fractal character of concrete and its chaos effect of cracks evolution under axial stress

    混凝土的分形性及其單軸應力下裂紋演化的混沌效應
  19. The shear strength curve and compressed curve and soil - water characteristic curve as well as triaxial stress - strain curve of intact loess were obtained

    得到了原狀黃土的抗剪強度曲線、土-水特徵曲線、壓縮曲線及三軸應力應變曲線。
  20. In this paper, the theory of wavelet transformation in signal noise reduction is introduced, together with the algorithm of signal decomposition and reconstruction

    摘要介紹採用小波變換進行信號降噪的原理；利用小波分解和重構函數對乳機主傳動軸應力和扭矩信號進行降噪處理。
分享友人
分享到 Line

分享到臉書