軸截距 的英文怎麼說

中文拼音 [zhóujié]
軸截距 英文
axial intercept
  • : 軸Ⅰ名詞1. (圓柱形的零件) axle; shaft 2. (對稱部分的直線) axis 3. (圓柱形的纏繞器物) roller; spool Ⅱ量詞(用於纏在軸上的線以及裝裱帶軸子的字畫)
  • : Ⅰ名詞1 (距離) distance 2 (雄雞、雉等的腿的後面突出像腳趾的部分) spur (of a cock etc )Ⅱ動詞...
  1. The digital simulation based on this control law denotes that it possesses very well performance, and the interception ability of aam for short range in launching of large off - bore sight angle can be raised

    數字模擬表明,該控制律具有很好的性能,能使近空空導彈在大離角發射時的擊能力得到提高。
  2. In the experiment, we use the he - ne laser and the semiconductor laser as the source, record the bessel beam patterns behind the axicon by using a digital camera and a microscope, measure the radius of the bessel beam central spot by film - scanning and measure the effect of both the radius of the aperture and the open angle of the axicon on the maximum non - diffraction distance. the experiments show that a specific propagating range has constant power and the beam has a bessel - like distribution in this range. the results agree with the beam corresponding to a diffraction free beam

    同時我們還採用膠片掃描的方法測量了無衍射光束的中心光斑尺寸,測量了不同光闌孔徑和不同稜角情況下的最大無衍射離和傳播附近橫面內微小光孔中的光強,實驗結果顯示當激光光束經過棱錐轉換後有一段離功率變化很小,且分佈近似貝塞爾分佈,符合無衍射光束的特性;經過聚焦后,呈現三維分佈中空的光束bottlebeam ,實驗結果與理論分析基本吻合。
  3. In order to investigate the unsteady flow frequency domain performances of an axial flow compressor at different mass flow, rotating speed and blade row spacing, plus inlet flow distortion, and considering aerodynamic characteristics and stability of the compressor, the low speed research compressor ( lsc ) at college of energy and power in nuaa is used to carry out the experiment studies. a large amount of test data has been gained through dynamic pressure transducers embedded in the stator blades at the tip, middle and hub section, then fast fourier transform algorithm ( fft ) is applied to calculate the frequency data

    為探討流壓氣機在工作流量、工作轉速及動?靜葉排向間變化時的葉片排流場非定常頻譜特性變化規律,並耦合進氣畸變的影響,同時與壓氣機氣動性能和氣動穩定性相關聯,作者利用南京航空航天大學能源與動力學院的低速大尺寸流壓氣機( lsc )試驗器,採取在靜子葉片表面埋入動態壓力傳感器的實驗方法,對葉尖、葉中和葉根三個面的動態壓力進行了測量,獲得了大量的可靠的實驗數據。
  4. With the different tripping annulus at the inlet, a new method of the distance definition from the wall was used to measure 35 mean velocity profiles on seven sections in the pipe length x / d = 125. 2

    採用新的離壁離標定方法,在入口處設有改變擾動強度擋環的條件下,利用熱線儀在管長x d約為125的范圍內完成了七個不同管流面上的35個線方向速度分佈的測量工作。
  5. Basing the analysis on the experimental data, the author provides the load - bearing capacity formula of the concrete short column confined by overlapping hoops under uniaxial compression and the relationship between characteristic value of hoop and spacing of hoop, which is of great practical value

    摘要通過實驗數據的分析,提出了心受壓復合方箍短柱正面承載力的計算公式並給出了配箍特徵值與箍筋間的關系,具有一定的實用價值。
  6. This paper investigates and presents the design methods for lateral braces between equal spaced columns reducing the effective lengths of the columns to half

    本文探討了一排等間布置的承受相同力的等面柱,使柱計算長度減少至0 . 5l時所需橫向水平撐桿的設計問題。
  7. A method of choosing the wind load influence modulus that decides the wind load numerical value of combination structure was proposed correspondingly. firstly the wind load parameter that influences the wind load of combination structure was chosen according to design criterion of high - rising structure and through tradition calculation methods of wind load. by using currently calculation methods the axis force and martix of the most danger section was worked out, and the security of structure was analyzed and checked

    首先運用傳統風荷載計算的方法,結合本文的組合結構的特殊情況,以高聳結構設計規范為參考,參照風荷載理論選定了影響該組合結構風荷載的風荷參數,並依據一般塔架演算法(簡化懸臂梁法)計算出了與底座連接處斷面(最危險面,塔底6米段)的力和彎矩,同時對此處進行了應力分析和可靠性校核。
  8. Class uses a least - squares criterion for deriving estimates of what the y intercept and slope parameters should be

    類使用最小二乘法準則推導出y軸截距( y intercept )和斜率( slope )參數的估計值。
分享友人