軸流效應 的英文怎麼說

中文拼音 [zhóuliúxiàoyīng]
軸流效應 英文
axial flow effect
  • 軸 : 軸Ⅰ名詞1. （圓柱形的零件） axle; shaft 2. （對稱部分的直線） axis 3. （圓柱形的纏繞器物） roller; spool Ⅱ量詞（用於纏在軸上的線以及裝裱帶軸子的字畫）
  • 流 : Ⅰ動1 （液體移動; 流動） flow 2 （移動不定） drift; move; wander 3 （流傳; 傳播） spread 4 （向壞...
  • 效 : Ⅰ名詞（效果; 功用） effect; efficiency; result Ⅱ動詞1 （仿效） imitate; follow the example of 2 ...
  • 應 : 應動詞1 （回答） answer; respond to; echo 2 （滿足要求） comply with; grant 3 （順應; 適應） suit...
  • 效應 : [物理學] effect; action; influence
  1. The numerical computation for the secular variable of the semi - major axis, solar distance at perihelion, orbital periods and longitude of perihelion has been made for fifteen meteor streams by using the solution of gylden - meshcherckii equations

    利用g - m型變質量天體軌道根數變化方程的一階和二階解對15個流星群軌道半長軸、近日點距離、軌道周期和近日點經度因太陽質量損失造成的每世紀的長期改變效應做了數值計算，並得出計算結果。
  2. Owing to its excellent adaptability to large angle - displacement between two transmission shafts and other characteristics such as large transmission ratio, terse mechanism, high transmission efficiency, cardan cross - pin spindles has been widely used as an important mechanical part in transport machines, metallurgy machines, petrolic machines, heavy machines, etc. as an effective and promising approach to resolve complicated development of modern software, component - based development ( cbd ) is put forward to change the present way of software development by producing software through assembling ready software components and its final target is to realize the industrialization of software development totally

    十字軸式萬向聯軸器能夠很好地適應傳動軸間的較大角位移，而且具有傳遞扭矩范圍大、結構緊湊、傳動效率高、維修保養方便等特點，是一種重要的傳動部件，因此在交通運輸、冶金、重型機械等領域中得到廣泛應用。基於組件的開發是近幾年發展並日益成熟起來的一種軟體開發新方法，其核心思想是以流水線方式、通過組裝組件生產軟體，從而容易實現軟體開發的工業化。
  3. In different in terne die travel, the metal flow characterize in warm extrusion forming processes and the affection for the flow of metal stage which made by the difference between the blank bottom altitude and the axial direction limiting size in warm extrusion forming technique have been analysed we have gotten the equivalent strain field and the velocity field and other field variable that the blank in different in terne die travel and the die travel - load curve. at the same time, we have analyzed the contributing factor for the oil pump stator forming process optimized and achieve thereasonable die parameter for the war m extrusion forming finally, the optimized technics parameters were used into pilot production, then the qualified oil pump stator forging were produced, the analog results were compared with those of pilot production

    論文具體分析研究了不同成形工藝過程中金屬流動的特點，並對不同凸模行程下溫擠成形過程中的金屬流動特點、坯料連皮厚度（底部高度）與溫擠壓成形工藝中的軸向界限尺寸的差值對金屬變形階段的影響進行了分析，獲得了坯料在不同凸模行程下的等效應變場、速度場等場變量及凸模行程-載荷曲線，同時對油泵定子成形過程的影響因素等進行了分析，優化並獲得了合理的溫擠成形工藝及模具參數。最後，利用模擬優化獲得的各項工藝參數進行生產實驗，得到實際生產出的合格油泵定子件，並將模擬結果與生產實驗結果進行比較。
  4. The regularities distribution of the electromagnetic field and vortex density had been simulated by the software matlab, the results of simulation not only proved the existence skin effect but also provided theory evidence for designing and researching of the shaft bearing replacer

    通過matlab軟體對被加熱工件進行了電磁場和渦流分佈的計算機模擬，形象描述了工件內電磁場的分佈規律，證明了集膚效應的存在，為軸承感應拆卸裝置的設計研究提供了理論依據。
  5. The aim of this study is to explore the concentrating effects of both the electric current density and the stresses in the plate due to the existence of the elliptic hole

    其研究重心是定量計算橢圓孔對電流密度以及板內應力分佈在橢圓長軸端點處的集中效應。
  6. The flow between two gaps in the new type of axial trust balancing device was assumed as laminar move, and the flowing physical model in these two gaps was simplified into laminar move in the gaps between two parallel plates

    摘要將新型軸向力平衡裝置兩個間隙中的流動假設為層流，並將兩個間隙流動的物理模型簡化為平行板間隙的層流運動，推導出了徑向間隙與?漏量關系式和考慮離心力效應時軸向間隙與?漏量的關系式。
  7. Based on many references form civil and abroad, the author mainly studies the measurment theory and method for flux, raising height, axial power and rotational velocity. avoiding many complicated and intermediate courses for power wastage analysis, introduces the electric measurement and using efficiency curve of motor in measureing axial power, and satisfies the automatization of the device. the paper also provides a new method, inductive winding, in measuring rotational velocity of electromotor, supplys limitations of other method in measuring rotational velocity of electromotor in water, and meet practical needs in developing diving electric pump for corporation

    作者在參閱大量國內外有關文獻，著重探討了水泵流量、揚程、軸功率、轉速的測試原理和測試方法，提出了採用電測法並結合電機效率特性曲線測量水泵軸功率，從而避免了損耗分析法中大量復雜的中間過程，滿足了試驗裝置的自動化測量要求；採用漏磁感應線圈法測量電機轉速，彌補了其它轉速測量方法對水下電機測試的局限性，適應了萊恩公司開發潛水電泵的實際需要。
  8. Through the analyzes of electromagnetic system of a axial symmetry by the method of electromagnetic vector potential, an eddy current field math model is build by triangle cell, this article has researched the effect of power frequency to eddy current density, penetration depth and the skin effect

    本文以電磁場矢量位有限元法為基礎對二維軸對稱場的磁場強度、渦流密度進行了計算求解，採用三角形單元和六面體單元建立了渦流場數學模型，研究了電源頻率對渦流密度、透入深度及集膚效應等場量的作用影響。
  9. It was difficult to measure the load voltage directly between inner and outer conductor of cable induced by shield current under low flux x ray. this paper introduces a measurement, pouring a current, which was same as cable approximately photocurrent in x ray test, into the shield of cable with a triocoaxial system, and the load voltage was got. finally the measured result of typical cable and comparison with the calculation was given with a special load

    在簡要介紹屏蔽電纜的轉移阻抗和轉移導納耦合的基礎上，描述了利用三同軸系統對雙電纜和等效負載組成的電纜系統進行電流注入，模擬電纜屏蔽層發射電流，測量芯線等效負載感應信號的實驗，給出實驗結果及分析，並對理論結果與實驗進行了比較。
  10. Analysis on the aerodynamic behaviors of the swept leading edge shocks in high load axial compressors

    軸流壓氣機掠形前緣激波動力學效應的模型分析
  11. Relativistic back wave oscillator ( rbwo ) with a coaxial structure has a big power capacity of system. with large radius electron beam to decrease the space charge effects without usage of high current, hence the rbwo can work well at a lower axial guide magnetic field

    同軸返波管具有很大的功率容量，可以採用大半徑電子注，在工作電流不變的情況下空間電荷效應大幅度降低，因而可工作在低磁場狀態。
  12. For the case of static loaded er journal bearings, the influence of er effects on the lubrication performance are studied under various radius clearances, eccentricity ratios and shear rates

    對于穩載電流變滑動軸承的潤滑問題，研究了不同平均間隙、不同偏心率以及不同剪切速率下電流變效應對軸承潤滑性能的影響。
  13. The results show that the solar mass - loss extends the semi - major axis, the distance at perihelion and orbital periods of the meteor streams, especially, the extensive influence on the semi - major axis is not overlooked, but this influence on other orbital elements may be neglected

    其計算結果表明，太陽質量損失使流星群軌道半長軸每世紀的改變效應較明顯，它們同太陽距離的擴大影響值得關注，但對軌道周期的拉長每世紀的影響甚小，對近日點經度只有量級變化小到可以略而不計。
  14. The numerical results show that : with the enhancement of er effects, the bearing capacity is obviously increased ; the increase magnitude is larger when small radius clearances and large eccentricity ratios ; at low shear rates, the influence of er effects on the lubrication performance of journal bearings are more obvious

    數值研究表明：隨著電流變效應的增強，軸承潤滑油膜的承載能力明顯提高；軸承半徑間隙越小，偏心率越大，軸承承載能力增加的幅度也越大；在低剪切速率下，電流變效應對軸承潤滑性能的影響較大。
  15. Abstract : this paper describes the thermal effects of a coaxial rf - excitedco2 laser ， based on the balance equations of electron density and energy ， current continuity equation ， and heat conduction equation. depende ncies of the spatial distributions of gas temperature on some discharge parameters arediscussed

    文摘:通過求解放電等離子體中的帶電粒子密度和能量的平衡方程、電流連續性方程以及熱傳導方程，研究了同軸射頻（ rf ）激勵co2激光器中放電混合氣體的溫度效應，分析了有關放電參數對溫度分佈的影響。
  16. The mode competition is much improved. it may operated with a large electron beam radius, that means decreasing the space charge effects compared with a smaller radius beam with the same current, hence the rbwo may operated with a low axial guide magnetic field. besides, the rbwo with a sinusoidal corrugated coaxial structure is very easy to manufacture

    波紋內導體rbwo具有一些突出優點:同軸結構中內導體的存在使系統的截止頻率顯著升高，使得系統尺寸可比普通波紋波導慢波系統大;具有很大的抑制模式競爭的能力和很高的功率容量;可以採用大半徑電子注，在工作電流不變的情況下空間電荷效應大幅度降低，因而可以工作在低磁場狀態;此種慢波結構內導體上的波紋易於加工。
  17. Two - dimensional geometry effect on space - charge - limited current in axially symmetrical planar diode

    軸對稱平板二極體空間電荷限制流的2維效應
  18. Using axisymmetric full navier - stokes equations, the thermo - chemical nonequilibrium flow in hypersonic nozzle was simulated and the scale effects due to nonequilibrium were analysed numerically

    摘要採用軸對稱熱化學非平衡全n - s方程，數值分析了高超聲速噴管流場中非平衡引起的尺度效應。
  19. For the case of dynamically loaded er journal bearings, the effects of er fluids on the lubrication performance are numerically studied by simultaneously solving the reynolds equation and the journal motion equation

    對于動載電流變滑動軸承的潤滑問題，聯立求解了基於電流變流體模型的動載雷諾方程和軸頸運動方程，分析了電流變效應對動載軸承潤滑性能的影響。
  20. For verify the test theory, we used the numerical method the simulated the instrument heat exchanging. thus we checked the axial heat disturbing how to influence the test results, and checked the test time ’ s influence the test result, finding the time limit to avoid the natural convection influence

    運用數值方法模擬了測試儀器的實際傳熱過程，結果表明熱絲端部的軸向熱流在短時間內對測試的結果影響較小，採用雙熱絲可以有效避免端部效應。
分享友人
分享到 Line

分享到臉書