軸間耦合 的英文怎麼說

中文拼音 [zhóujiānǒugě]
軸間耦合 英文
cross axis
  • 軸 : 軸Ⅰ名詞1. （圓柱形的零件） axle; shaft 2. （對稱部分的直線） axis 3. （圓柱形的纏繞器物） roller; spool Ⅱ量詞（用於纏在軸上的線以及裝裱帶軸子的字畫）
  • 間 : 間Ⅰ名詞1 （中間） between; among 2 （一定的空間或時間里） with a definite time or space 3 （一間...
  • 耦 : Ⅰ動詞[書面語] （兩人並耕） plough side by sideⅡ名詞1 （古農具名） plough2 [書面語] （兩人一組） a...
  • 合 : 合量詞（容量單位） ge, a unit of dry measure for grain （=1 decilitre）
  • 耦合 : [物理學] coupling; interconnection; catena; linkage; linking
  1. The higher-order terms arise from nonlinearities and cross-axis sensitivity.

    高次項是由外線性和軸間耦合靈敏度所產生的。
  2. According to the working principle of magnetic bearing, there exists force coupling, magnetic coupling in radial magnetic bearings inside the magnetic suspension rotor system, and there exists force coupling, moment coupling between magnetic bearings as well

    摘要磁懸浮轉子系統中，根據磁力軸承工作原理，徑向磁力軸承內存在力耦合、磁耦合；徑向磁力軸承之間存在力耦合、力矩耦合。
  3. In order to investigate the unsteady flow frequency domain performances of an axial flow compressor at different mass flow, rotating speed and blade row spacing, plus inlet flow distortion, and considering aerodynamic characteristics and stability of the compressor, the low speed research compressor ( lsc ) at college of energy and power in nuaa is used to carry out the experiment studies. a large amount of test data has been gained through dynamic pressure transducers embedded in the stator blades at the tip, middle and hub section, then fast fourier transform algorithm ( fft ) is applied to calculate the frequency data

    為探討軸流壓氣機在工作流量、工作轉速及動?靜葉排軸向間距變化時的葉片排流場非定常頻譜特性變化規律，並耦合進氣畸變的影響，同時與壓氣機氣動性能和氣動穩定性相關聯，作者利用南京航空航天大學能源與動力學院的低速大尺寸軸流壓氣機（ lsc ）試驗器，採取在靜子葉片表面埋入動態壓力傳感器的實驗方法，對葉尖、葉中和葉根三個截面的動態壓力進行了測量，獲得了大量的可靠的實驗數據。
  4. The paper establishes mathematics model of electromagnetic heating system of eddy current field and temperature field, and gives corresponding discrete format with elements as eight nodes, hexahedron equal cell, through calculating eddy - current field to gain the internal heat source that the temperature field needed, to use discrete method to solve the problem of induction - heating part ' s temperature field by axial symmetrical electromagnetic, and then to analyze the characteristic of instantaneous temperature field

    本文建立了電磁加熱系統的渦流場和溫度場間接耦合的數學模型，分析了不同頻率下渦流和溫度的分佈情況，並以八節點六面體等參元為例給出了渦流場對應的離散格式，通過計算渦流場獲得溫度場所需要的內熱源強度，加熱部件的溫度場以軸對稱格式進行離散求解，並對瞬態溫度場有限單元法的求解特點進行了分析。
  5. The topic has analysis the body in the static, dynamic and the thermal - stress using the finite element method. in the analysis, adopting entity model building to build the fea model, predigesting the bonded block, using entity equivalence the bearing effect, adopting indirect method to couple the mechanism load and thermal load

    分析中，採用實體建模方法建立了機體的有限元模型;對結合部進行了簡化處理;用實體等效軸承的作用;採用間接法耦合了熱載荷和機械載荷的作用;應用錘擊法對機體和軸系進行了動態性能實驗。
  6. A new decoupling control strategy of magnetic suspension forces is put forward using the transformation of variables and reference frames for the proposed bearingless motor

    利用混合式轉子無軸承電機的轉子特點，將磁懸浮力模型轉變為電流空間矢量方程，提出了一種新的磁懸浮力解耦控制方法。
  7. With the consideration of the vertical wave effect of soil and soil - pile interaction, an approximate analytical solution to vertical vibration of pile system with variable impedance in visco - elastic layered soil is developed. a simplified and practical mathematical model for interaction between soil layers is proposed, and its applicability is theoretically investigated. based on this model and by using laplace transforms and the transmit property of impedance function, the analytical expression of the impedance function and solutions of the displacement and velocity response function in frequency domain and in time domain at the pile head are derived

    4 、從三維軸對稱土模型出發，對考慮樁土耦合作用、土層層間聯系以及樁周土豎向應力梯度變化條件下的成層粘彈性土中完整樁及變阻抗樁系統縱向振動問題進行了研究，提出了成層土中變阻抗樁系統縱向振動問題的近似解析解法和樁周土層層間相互作用的簡化而實用的數學模型，並利用拉氏變換和阻抗函數的傳遞性，獲得了成層土中任意段變阻抗樁樁頂阻抗函數的解析表達式，以及樁頂速度導納和時域速度響應解析解和半解析解。
  8. The third, some groping researches are made on broadband coaxial line filter output circuit of klystron. a broadband output circuit - mode four coupling slots double - gap output cavity loaded with coaxial filter, which has a workable relative bandwidth bigger than 14 % and fits in with l - band multi - beam klystron, is designed. meanwhile some analysis of its stability and peak power capacity is made

    第三，對速調管同軸線濾波器寬帶輸出迴路進行研究和探索，設計出了一個適合用於l波段多注速調管、相對帶寬超過14的四耦合槽模強耦合雙間隙腔加載同軸線濾波器輸出迴路，並對其穩定性和峰值功率容限做了一些分析。
  9. According to this structure, a de - coupled microgyroscope is designed, and the simulation results indicated that this three spring - mass structure can effectively eliminate the coupling effects between the drive and sense mode

    依據這種結構，設計了一種解耦型微陀螺，模擬結果表明，這種結構基本消除了垂直軸間的機械耦合，降低了對工藝精度和檢測電路的要求。
  10. After considering the coupling of the mounting errors and elastic deformation, the meshing influences of the error of the center distance, the setting parametric error in the axial direction, and the intersect angle between the two axes on transmission performance are investigated. 4

    考慮到安裝誤差和載荷作用下的彈性變形等非共軛因素耦合作用，分析了漸開線蝸桿傳動在安裝時存在中心距誤差，軸間相對位置誤差，軸間相對夾角誤差對其承載嚙合的影響； 4
  11. The design and simulation of the servo controller had been researched based on the optical track device for lunar rover made by dept. of astronautics engineering of hit. the main research are following : firstly, according to performance requirements, the control scheme is determined, and the control model are selected after analyzing the steady and dynamic characteristic. and the control equation are obtained

    首先根據系統的性能指標要求，在分析了系統的穩態和動態性能的基礎上，確定了系統的控制方案，建立伺服控制系統各環節的數學模型，對視覺平臺的控制方程進行了簡化處理，消除了方位軸和俯仰軸之間的力矩耦合，得到了相互獨立的方位軸和俯仰軸的控制方程。
  12. Using dynamic load that applied by the simulation above, the dynamic analysis and lighten - weight optimization of spider were done. getting stress history supplied testing data for its service life analysis

    利用剛柔耦合模擬得到的動載荷對十字軸進行了動力學分析和優化減重，並提取了十字軸的應力時間歷程曲線，為十字軸的疲勞壽命分析提供了有效的試驗數據。
  13. The torsional interaction from the electrical couplings among the generating sets is presented and the influence of the natural torsional frequency of the generating sets on the torsional oscillation characteristics is described. the torsional dynamics between identical parallel turbine - generators are deduced as well as that between non - identical parallel turbine - generators. then the basic principle of equivalent simplification of generating units for different operational condition is summarized

    （ 2 ）介紹了多機電力系統機組間電氣耦合對軸系扭振特性的影響，以及機組自然頻率與機組扭振相互作用的關系，並對復雜系統中並列運行的相同發電機和不同發電機間的扭振相互作用進行了分析，歸納了不同運行條件下機組等值簡化的基本原則。
  14. Abstract : the bearingless induction motor, which combines the induction motor and magnetic bearing is a strongly coupled complicated nonlinear system ; the decoupling control of the electromagnet torque and radial levitation force is the base of the stable operation of the bearingless motor

    文摘:無軸承異步電機是一個強耦合的非線性復雜系統，實現其電磁轉矩和徑向懸浮力之間的解耦控制是該電機穩定運行的前提。
  15. One downside of the integrated bearings is increased coupling between the radial and axial degrees of freedom. the analysis of coupling is done by method of an electric circuit analog of the integrated magnetic bearing. the basic equation of magnetic circuit and the equation of suspension force are derived when permanent magnet flux and electromagnetism flux simultaneity is effected

    利用等效磁路法建立了該磁軸承的磁懸浮力數學模型，依據此數學模型分析了徑向和軸向磁懸浮力之間的非線性耦合關系，得出在轉子平衡位置附近，徑向和軸向懸浮力是解耦的結論，從而為控制帶來了極大的方便。
分享友人
分享到 Line

分享到臉書