載波負載 的英文怎麼說

中文拼音 [zǎibōfùzǎi]
載波負載 英文
carrier load
  • 載 : 載Ⅰ名詞（年） year : 一年半載 six to twelve months; six months to a year; 三年五載 three to five ...
  • 波 : Ⅰ名詞1 （波浪） wave 2 [物理學] （振動傳播的過程） wave 3 （意外變化） an unexpected turn of even...
  • 負 : Ⅰ名詞1 （負擔） burden; load 2 （虧損） loss 3 （失敗） defeat Ⅱ動詞1 [書面語] （背） carry on th...
  • 載波 : signal carrier; carrier wave; carrier: 3路載波 three channel carrier載波傳輸 carrier transmission...
  • 負載 : [電學] load
  1. Microwave microelectronics. attenuators and loads

    微波微電子學.衰減器和負載
  2. Load modulate technology based on sub - carrier wave for fuze setting information feedback

    基於副載波的負載調制技術實現引信感應裝定信息反饋的方法
  3. The drive band and retainer feature a hex - drive system to distribute drive loading evenly and eliminate overstressing of the flexible elastomer bellows

    傳動環和護圈配置一個六角傳動系統，均勻的分配傳動負載，消除柔軟的彈性波紋管上的過度應力。
  4. Because of the elements which run under nonideal linearity and unentire symmetry in the power system, the loads which are different and change randomly, the methods which adjust and control the system faultily and operate improperly, the disturbance and the malfunction which happen somewhere, the current and voltage in the supply system are distorted seriously and thus large amount of harmonics are produced

    但是，由於電力系統元件運行的非理想線性或非完全對稱、負載的性質各異且隨機變化、調控手段的不完善以及錯誤操作、外來干擾和各種故障的存在，供電網中的電流（電壓）發生畸變，產生大量諧波。
  5. In order to eliminate the influence of the output filter capacitor current on the grid current, a novel control strategy for the grid - connected inverter in grid - tied and off - grid modes is proposed. the control strategy can also realize seamless transfer between grid - tied and off - gird modes. the grid - connected inverter can supply power to the critical load when the grid is off

    本文針對傳統並網控制策略進網電流受輸出濾波電容電流影響的問題，提出了一種新的並網控制策略，該控制策略能基本消除輸出濾波電容對進網電流的影響，實現獨立與並網兩模式之間的無縫切換，對關鍵負載起不間斷供電的作用。
  6. The theories and design principles of each circuit of the spwm three - phase frequency inverter experiment unit are in detail introduced in this thesis. at the same time some experiment results are shown that include the output voltage and current waves when the load is in resistivity, inductivity or asynchronous motor

    文中詳細介紹了spwm三相變頻實驗單元所包含的各電路環節的理論基礎及設計過程，並給出了調試結果，如負載為阻性、感性和異步電動機時，實驗單元輸出的電壓和電流波形。
  7. Energy consume, electric strength, insulation resistance, ground conductivity, leakage current, microwave leakage, power input, normal temperature, humidity treatment, glow wire, horizontal flame, vertical flame, tracking, ball pressure, rainproof, water splash, dustproof, salt fog, endurance, motor load test, cord flexing, cord pulling, pull & torque test, lamp replacement, construction check etc

    能耗、電氣強度、絕緣電阻、接地連續性、泄漏電流、微波泄漏、功率、溫升、濕熱試驗、灼熱絲、水平燃燒、垂直燃燒、漏電起痕、球壓試驗、防雨淋、防濺水、粉塵、鹽霧、耐久性（壽命）試驗、電機負載試驗、電源線彎折、電源線提拉、拉扭力測試、燈頭互換性、安全結構檢查等。
  8. The perovskite - type metal oxides supports and the corresponding supported pd catalyst were prepared by microwave, and characterized by xrd, sem and used in the direct synthesis of diphenyl carbonate ( dpc )

    摘要利用微波法制備了鈣鈦礦型復合氧化物載體及把負載鈣鈦礦型催化劑，用xrd和sem對載體及催化劑進行了表徵，並將微波法制備的催化劑用於一步氧化羰基化合成碳酸二苯酯（ dpc ）實驗。
  9. Because of the temperature rising of ultrasonic motors, load changes, and vicinal surrounding changes and so on, the resonant frequency will shift, leading to working stability drop

    由於超聲波電機的溫升、負載變化及周圍環境變化等原因，使電機的諧振頻率發生漂移，這將影響超聲波電機運行的穩定性。
  10. Live - loading of bonnet bolting stores the required sealing load during a pressure or temperature induced transient

    在壓力或溫度不斷波動轉換的情況下，動負載閥帽螺栓儲存了所需要的密封負載。
  11. Electricity metering - data exchange for meter reading, tarif and load control - part 31 : use of local area networks on twisted pair with carrier signalling

    電量計.抄表電費和負荷控制的數據交換.第31部分:帶有載波信號傳輸的雙絞線局域網的使用
  12. Electricity metering - data exchange for meter reading, tariff and load control - part 31 : use of local area networks on twisted pair with carrier signalling

    電度表.計數器讀數稅控制和負載控制的數據交換.第31部分:帶有載波信令的雙扭線局域網的使用
  13. 1 m 0. 5, the phase - shifted angle 6 is controlled in term of sine law which makes the magnitude of resonant voltage track a reference sine voltage, and the resonant voltage is rectified, filtered, inverted and then the better sine - voltage output is obtained, theoretical analysis and experimental results show that for the resistive load and inductive load, the switches of leading leg of the phase - shift - controlled circuit are always turned on at zvs, and ones of lagging leg are turned on at zvs ( < 0 ) or turned off at zcs ( ( > 0 ), moreover, all switches in the low - frequency inverter are always turned on and off at zvs, the measured circuit efficiency for rated load reaches up to 88 %

    從功率單向流動角度出發，提出了一種lcc諧振型恆頻移相單相高頻鏈逆變電路拓撲，在調制系數0 . 1 m 0 . 5情況下，控制移相角按正弦規律變化，使諧振電壓脈沖列的幅值追蹤參考正弦電壓信號，經過整流、濾波、低頻逆變，從而獲得正弦度較好的輸出電壓。理論分析和實驗結果證明對于阻性負載或阻感性負載，移相全橋具有超前橋臂零電壓開通，滯后橋臂或者零電壓開通（ _ 0 ）或者零電流關斷（ _ 0 ）的軟開關特性，而低頻逆變器的各個開關均實現零電壓條件下的開通與關斷。
  14. The harmonic circulating current balancing is an important factor in the parallel operating control for it makes the units of the system to get. an equal power factor and makes foundation for the system to work stable and reliable

    並聯電源系統的諧波環流均分控制是實現負載的失真功率均分，保證各並聯單元的輸出功率因數均衡，保證並聯系統穩定可靠工作的一個重要方面。
  15. Skj ( jjw ) series of ac purifying regulated power supply, incorporating functions of regulation and auti - inter ference, designed and muters, xerox, video equipments, medical instrmments and other electr onicinstrmmerts and autocontrol systems for is wide vange of regulating, high precicion, quickacting, high effciency, small itcan restrain restrain sharp voltageand protect from moise of electric power net

    系列進精密凈化電源是當今國際上普遍採用的現代電源調節技術，配以大容量濾波器與集成化控制系統構成；它具有如下特點：可靠性好、效率高、優良的動（瞬）態，體積小、重量輕、噪音低、負載適應能力強；適用於對電源要求較高的儀器或設備。
  16. In this paper, the drive theory of the large ratio friction transmission is studied ; a new type elliptical cam wave generator is designed ; the large ratio friction transmission prototype is designed and manufactured ; based on the ansys finite element method software, structure of the elliptical cam is analyzed ; precision index of the manufactured large ratio friction transmission prototype, such as transmission accuracy, least step, stability of the least step, load capacity is measured by the absolute rotary encoder. by analyzing the measurement data and research content, it is think that the new elliptical cam wave generator could overcome a good many problems brought by processing errors, facilitate size precision adjustments, input moment can be achieved in the form of a pure force couple importing ; through this study, " the large ratio friction transmission prototype " could apply in practical engineering basically

    本文研究了大速比摩擦傳動的傳動理論;設計了新型橢圓凸輪波發生器，設計製作了大速比摩擦傳動樣機;用軟體ansys對所設計的橢圓凸輪結構進行了有限元分析;用19位絕對式編碼器測試了大速比摩擦傳動機構的傳動精度、最小步距、最小步距的穩定性以及帶負載能力等各項精度指標;對測量數據和研究內容進行了歸納和整理，認為新型橢圓凸輪波發生器克服了加工誤差帶來的諸多問題，新型橢圓凸輪波發生器可以進行尺寸精度調整，能夠達到輸入力矩以純力偶的形式輸入;通過本項研究，基本可以使「大速比摩擦傳動機構」在工程中得以應用。
  17. Based on the six - port relative power theory that for a given load the relative power ratios of different ports are left unchanged with the input power to the six - port varied, characteristic parameters of detectors can be obtained through the least - square method

    根據六埠相對功率理論即對某一負載各埠相對功率比值不隨輸入功率變化，由最小二乘法得到檢波器的特徵參數，結合四標準法，確定六埠網路的系統常數。
  18. Sol - gel method was used for preparing the nano - tio2 photocatalytic film on general glas slid and ito conductive glass. the spectrum property, surface image, crystlal type, particle size, thickness and other properties of this film were measured by uv - vis, afm, xrd and other apparatus

    採用溶膠-凝膠法在普通玻璃載波片和ito導電玻璃上制備出負載型納米tio _ 2薄膜，並用uv - vis ， afm ， xrd等對納米tio _ 2薄膜的光譜特性、表面形貌、晶型及粒子大小、薄膜厚度等進行了表徵。
  19. Analysis and modeling for the sub - harmonic load pull characteristics of the cdma power amplifier

    功放電路副諧波負載牽引特性與建模研究
  20. Keywords : active power filter, voltage type harmonics, load voltage regulaton

    關鍵詞：主動式電力濾波器、電壓型諧波、負載電壓調整。
分享友人
分享到 Line

分享到臉書